Freestanding narrowband terahertz filters based on aluminum foil

Terahertz (THz) filters with high transmission coefficient (T) in the passband and frequency selectivity are critical in numerous applications such as astronomical detection and next-generation wireless communication. Freestanding bandpass filters eliminate the Fabry-Pérot effect of substrate, thus providing a promising choice for cascaded THz metasurfaces. However, the freestanding bandpass filters (BPFs) using the traditional fabrication process are costly and fragile. Here, we demonstrate a methodology to fabricate THz BPFs using aluminum (Al) foils. We designed a series of filters with center frequencies below 2 THz and manufacture them on 2-inch Al foils with various thicknesses. By optimizing the geometry, T of the filter at the center frequency is over 92%, and the relative full-width half maxima (FWHM) is as narrow as 9%. The responses of BPFs show that "cross-shaped" structures are insensitive to the polarization direction. The simple and low-cost fabrication process of the freestanding BPFs promise their widespread applications in THz systems.

Near-field investigation of the effect of the array edge on the resonance of loop frequency selective surface elements at mid-infrared wavelengths

Mid-infrared scattering scanning near-field optical microscopy, in combination with far-field infrared spectroscopy, and simulations, was employed to investigate the effect of mutual-element coupling towards the edge of arrays of loop elements acting as frequency selective surfaces (FSSs). Two different square loop arrays on ZnS over a ground plane, resonant at 10.3 µm, were investigated. One array had elements that were closely spaced while the other array had elements with greater inter-element spacing. In addition to the dipolar resonance, we observed a new emergent resonance associated with the edge of the closely-spaced array as a finite size effect, due to the broken translational invariance.

Cross-Shaped Terahertz Metal Mesh Filters: Historical Review and Results

Terahertz frequencies experiments has motivated the development of new sources, detectors and optical components. Here we will present a review of THz bandpass filters ranging from 0.4 to 10 THz. We also demonstrate our fabrication process, simulations and experimental results.

PHYSICAL AND CHEMICAL NANOLITHOGRAPHY TECHNIQUES: CHALLENGES AND PROSPECTS

The fabrication of nanodevices and nanosystems having dimensions smaller than 100 nm requires the ability to produce, control, manipulate, and modify structures at the nanometer scale. Physical and chemical nanolithography techniques have been demonstrated to be promising because of the low cost and high throughput. Although the physical and chemical nanolithography techniques can pattern small features on single chips or across an entire wafer, there are considerable challenges when dealing with complex nanostructures, alignment and multilevel stacks. In this paper, the problems are reviewed and potential solutions suggested.