Ultrasound-modulated optical tomography at new depth

Single-exposure ultrasound-modulated optical tomography with a quaternary phase encoded mask

Ultrasound-modulated optical tomography (UOT) is a deep-tissue imaging modality that provides optical contrast with acoustic resolution. Among existing implementations, camera-based UOT improves modulation depth through parallel detection but suffers from a low camera frame rate. The condition prohibits this technique from being applied to in vivo applications where speckles decorrelate on a time scale of 1 ms or less. To overcome this challenge, we developed single-exposure camera-based UOT by employing a quaternary phase encoded mask (QPEM). As a proof of concept, we demonstrated imaging of an absorptive target buried inside a dynamic scattering medium with a speckle correlation time as short as 0.49 ms, typical of living biological tissues. Benefiting from the QPEM-enabled single-exposure wavefront measurement (5.5 ms) and GPU-assisted wavefront reconstruction (0.97 ms), the point scanning and result update speed can reach up to 150 Hz. We envision that the QPEM-enabled single-exposure scheme paves the way for in vivo UOT imaging, which holds promise for a variety of medical and biological applications.

Coaxial interferometry for camera-based ultrasound-modulated optical tomography with paired illumination

Ultrasound-modulated optical tomography (UOT), which combines the advantages of both light and ultrasound, is a promising imaging modality for deep-tissue high-resolution imaging. Among existing implementations, camera-based UOT gains huge advances in modulation depth through parallel detection. However, limited by the long exposure time and the slow framerate of modern cameras, the measurement of UOT signals always requires holographic methods with additional reference beams. This requirement increases system complexity and is susceptible to environmental disturbances. To overcome this challenge, we develop coaxial interferometry for camera-based UOT in this work. Such a coaxial scheme is enabled by employing paired illumination with slightly different optical frequencies. To measure the UOT signal, the conventional phase-stepping method in holography can be directly transplanted into coaxial interferometry. Specifically, we performed both numerical investigations and experimental validations for camera-based UOT under the proposed coaxial scheme. One-dimensional imaging for an absorptive target buried inside a scattering medium was demonstrated. With coaxial interferometry, this work presents an effective way to reduce system complexity and cope with environmental disturbances for camera-based UOT.

Comparison of contrast-to-noise ratios of different detection methods in ultrasound optical tomography

Ultrasound optical tomography (UOT) is a hybrid imaging modality based on interaction between ultrasound and light, with a potential to extend optical imaging capabilities in biological tissues to depths of several centimeters. Several methods have been developed to detect the UOT signal. To better understand their potential for deep tissue imaging, we present a theoretical contrast-to-noise comparison between the spectral hole burning, single-shot off-axis holography, speckle contrast, and photorefractive detection methods for UOT. Our results indicate that spectral hole burning filters have the potential to reach the largest imaging depths. We find that digital off-axis holography and photorefractive detection can have good contrast-to-noise ratio at significant depths. The speckle contrast method has a smaller penetration depth comparatively.

Enhancing spatiotemporal focusing of light deep inside scattering media with Time-Gated Reflection Matrix

Time-gated reflection matrix (RM) has been successfully used for optical imaging deep inside scattering media. Recently, this method was extended to enhance the spatiotemporal focusing of light ultra-deep inside scattering media. This is achieved by calibrating the decomposition of the RM with the Tikhonov regularization parameter to convert multiply scattered photons that share the same time of flight with the singly scattered photons into singly scattered photons. Such a capability suggests a reshaping to the interaction mechanism between light and scattering media, which may benefit or inspire wide optical applications that desire enhanced spatiotemporal focusing of light at depths inside scattering media.

Reflection-mode acousto-optic imaging using a one-dimensional ultrasound array with electronically scanned focus

SIGNIFICANCE

Practical implementation of acousto-optic imaging (AOI) encounters difficulties that prevent it from rapid adoption in clinical use. In many practical medical applications, the region of interest may be accessed only from one side, and using a water tank for coupling is not feasible. The solution might be to use reflection-mode imaging with an electronically scanned ultrasound (US) focus. Such an approach, however, entails considerable challenges.

AIM

The possibilities of detecting and localizing light-absorbing inclusions inside turbid media by combining reflection-mode AOI conducted using a one-dimensional US array with electronic scanning of the US focus are investigated experimentally and signal processing algorithms that could be used for this purpose are introduced.

APPROACH

We determine the speckle contrast decrease due to the acousto-optic effect as a function of the US focal point coordinates. Different signal postprocessing techniques are investigated.

RESULTS

A significant decrease in the determined speckle contrast difference values is observed due to the presence of light-absorbing inclusions. However, local minima occur in the plots only under specific conditions. Subtracting individual distributions and determining symmetry deviations allow for localizing the inclusions.

CONCLUSIONS

Detection and localization of optically distinct regions are possible using the introduced approach. Signal postprocessing is required in a general case.

Imaging through highly scattering human skulls with ultrasound-modulated optical tomography

Advances in human brain imaging technologies are critical to understanding how the brain works and the diagnosis of brain disorders. Existing technologies have different drawbacks, and the human skull poses a great challenge for pure optical and ultrasound imaging technologies. Here we demonstrate the feasibility of using ultrasound-modulated optical tomography, a hybrid technology that combines both light and sound, to image through human skulls. Single-shot off-axis holography was used to measure the field of the ultrasonically tagged light. This Letter paves the way for imaging the brain noninvasively through the skull, with optical contrast and a higher spatial resolution than that of diffuse optical tomography.

Ultrasound-modulated laser feedback tomography in the reflective mode

A novel method of ultrasound-modulated optical tomography (UOT) detection based on the laser feedback technology is proposed in this Letter. The system has advantages such as a simple structure, high sensitivity, and reflective configuration. Effective penetration depths of up to 9 cm and 5 cm in phantom and biological tissues, respectively, have been demonstrated experimentally. The detection capability is comparable with the state of the art in the transmission mode but with a much lower photon consumption. Although a lot remains to be improved, the proposed method is promising for further development toward practical applications.

Focusing light through biological tissue and tissue-mimicking phantoms up to 9.6 cm in thickness with digital optical phase conjugation

Optical phase conjugation (OPC)-based wavefront shaping techniques focus light through or within scattering media, which is critically important for deep-tissue optical imaging, manipulation, and therapy. However, to date, the sample thickness in OPC experiments has been limited to only a few millimeters. Here, by using a laser with a long coherence length and an optimized digital OPC system that can safely deliver more light power, we focused 532-nm light through tissue-mimicking phantoms up to 9.6 cm thick, as well as through ex vivo chicken breast tissue up to 2.5 cm thick. Our results demonstrate that OPC can be achieved even when photons have experienced on average 1000 scattering events. The demonstrated penetration of nearly 10 cm (∼100 transport mean free paths) has never been achieved before by any optical focusing technique, and it shows the promise of OPC for deep-tissue noninvasive optical imaging, manipulation, and therapy.

Lock-in camera based heterodyne holography for ultrasound-modulated optical tomography inside dynamic scattering media

Ultrasound-modulated optical tomography (UOT) images optical contrast deep inside scattering media. Heterodyne holography based UOT is a promising technique that uses a camera for parallel speckle detection. In previous works, the speed of data acquisition was limited by the low frame rates of conventional cameras. In addition, when the signal-to-background ratio was low, these cameras wasted most of their bits representing an informationless background, resulting in extremely low efficiencies in the use of bits. Here, using a lock-in camera, we increase the bit efficiency and reduce the data transfer load by digitizing only the signal after rejecting the background. Moreover, compared with the conventional four-frame based amplitude measurement method, our single-frame method is more immune to speckle decorrelation. Using lock-in camera based UOT with an integration time of 286 μs, we imaged an absorptive object buried inside a dynamic scattering medium exhibiting a speckle correlation time ([Formula: see text]) as short as 26 μs. Since our method can tolerate speckle decorrelation faster than that found in living biological tissue ([Formula: see text] ∼ 100-1000 μs), it is promising for in vivo deep tissue non-invasive imaging.

Ultrafast acousto-optic imaging with ultrasonic plane waves

Due to multiple light scattering inside biological tissues, deep non-invasive optical medical imaging is very challenging. Acousto-optic imaging is a technique coupling ultrasound and light that allows recovering optical contrast at depths of few centimeters with a millimeter resolution. Recent advances in acousto-optic imaging are using short focused ultrasound pulses often averaged over several hundred or thousand pulses. As the pulsing rate of commercial probes is limited to about few ultrasound cycles every 100 μs, acquiring an acousto-optic image usually takes several tens of seconds due to the high number of acoustic pulses excitation. We propose here a new acousto-optic imaging technique based on the use of ultrasound plane waves instead of focused ones that allows increasing drastically the imaging rate.

Dependence of optical scattering from Intralipid in gelatin-gel based tissue-mimicking phantoms on mixing temperature and time

Intralipid is widely used as an optical scattering agent in tissue-mimicking phantoms. Accurate control when using Intralipid is critical to match the optical diffusivity of phantoms to the prescribed value. Currently, most protocols of Intralipid-based hydrogel phantom fabrication focus on factors such as Intralipid brand and concentration. In this note, for the first time to our knowledge, we explore the dependence of the optical reduced scattering coefficient (at 532 nm optical wavelength) on the temperature and the time of mixing Intralipid with gelatin-water solution. The studied samples contained 1% Intralipid and were measured with oblique-incidence reflectometry. It was found that the reduced scattering coefficient increased when the Intralipid-gelatin-water mixture began to solidify at room temperature. For phantoms that had already solidified completely, the diffusivity was shown to be significantly influenced by the temperature and the duration of the mixing course. The dependence of the measured diffusivity on the mixing conditions was confirmed by experimental observations. Moreover, the mechanism behind the dependence behavior is discussed.

Ultrasonically encoded wavefront shaping for focusing into random media

Phase distortions due to scattering in random media restrict optical focusing beyond one transport mean free path. However, scattering can be compensated for by applying a correction to the illumination wavefront using spatial light modulators. One method of obtaining the wavefront correction is by iterative determination using an optimization algorithm. In the past, obtaining a feedback signal required either direct optical access to the target region, or invasive embedding of molecular probes within the random media. Here, we propose using ultrasonically encoded light as feedback to guide the optimization dynamically and non-invasively. In our proof-of-principle demonstration, diffuse light was refocused to the ultrasound focal zone, with a focus-to-background ratio of more than one order of magnitude after 600 iterations. With further improvements, especially in optimization speed, the proposed method should find broad applications in deep tissue optical imaging and therapy.

High-sensitivity ultrasound-modulated optical tomography with a photorefractive polymer

By detecting ultrasonically tagged diffuse light, ultrasound-modulated optical tomography images optical contrast with ultrasonic resolution deep in turbid media, such as biological tissue. However, small detection etendues and weak tagged light submerged in strong untagged background light limit the signal detection sensitivity. In this Letter, we report the use of a large-area (~5 cm×5 cm) photorefractive polymer film that yields more than 10 times detection etendue over previous detection schemes. Our polymer-based system enabled us to resolve absorbing objects embedded inside diffused media thicker than 80 transport mean free paths, by using moderate light power and short ultrasound pulses.

Dynamic ultrasound modulated optical tomography by self-referenced photorefractive holography

Photorefractive Bi(12)SiO(20) single crystal is used for acousto-optic imaging in thick scattering media in the green part of the spectrum, in an adaptive speckle correlation configuration. Light fields at the output of the scattering sample exhibit typical speckle grains of 1 μm size within the volume of the nonlinear crystal. This heterogeneous illumination induces a complex refractive index structure without applying a reference beam on the crystal, leading to a self-referenced diffraction correlation scheme. We demonstrate that this simple and robust configuration is able to perform axially resolved ultrasound modulated optical tomography of thick scattering media with an improved optical etendue.