Dose distributions for 90Y intravascular brachytherapy sources used with balloon catheters

Verification and uniformity control of doses for Sr/Y intravascular brachytherapy sources using radiochromic film dosimetry

Intravascular brachytherapy (IVBT) is a useful treatment modality for the recurrence of in-stent restenosis following drug-eluting stents (DES) or IVBT failure. The objective of this study was to measure the dose rate of (90)Sr/(90)Y IVBT sources for comparison with that given by the manufacturer and to control the dose uniformities of these sources along the source axis. The dose rates of (90)Sr/(90)Y beta sources were measured with a radiochromic film in a custom-made phantom. The films for calibration were irradiated using (60)Co photon beams. The results for the three sources were 4.5%, 2.3%, and 3.5% higher than the corresponding certificate values. Maximum and minimum of the dose rates varied within +/-10% of those at source center; and maximum dose discrepancy for the first (90)Sr/(90)Y source train was 8.2%; for the second source train, 7.1%; and for the third source train, 5.1%. Our study showed that the dose rates given by the manufacturer for the three (90)Sr/(90)Y IVBT sources were reliable and dose uniformities were within +/-10% along two thirds of the treatment length.

Experimental determination of the radial dose function of 90Sr/90Y IVBT sources

A series of measurements were undertaken using both high sensitivity radiochromic film and new lithium fluoride thermoluminescent dosimeters in a liquid water medium to define the radial dose function of 90Sr/90Y beta emitting intravascular brachytherapy sources more accurately. These measurements of a single 5 French source pellet served to verify current Monte Carlo transport models and extrapolation chamber measurements of the radial dose function, thus providing the recommended independent published measurements for g(r) of these sources. A slight deviation in the published radial dose function at depth leads the authors to recommend that treatment planning be performed using updated g(r) values from current Monte Carlo transport models verified by measurements such as those shown in this investigation.

Monte Carlo parametric study of stent impact on dose for catheter-based intravascular brachytherapy with 90Sr/90Y

The radiation treatment of catheter-based beta-emitter sources is being used to prevent restenosis following interventional coronary procedures. We present the results of a Monte Carlo calculation study to assess the dosimetric impact in the vessel tissue due to the presence of the stent. A catheter-based beta-emitter system is modeled using the Monte-Carlo code MCNP4B. Dose distributions are calculated in annular voxels (0.050 x 0.025 mm2 section) along the axis of a 40 mm. 90Sr/90Y source with and without the stent (at a distance of 1.5-3.0 mm from the longitudinal axis of the source). The main results include: (a) a clear difference between the local perturbation just behind the strut and a more general perturbation seen deeper into the vessel tissue; (b) the local perturbations disappears at a depth of 300-400 microm while the more general perturbation affects the tissue in its full thickness including the prescription point; (c) in the local perturbation the maximum impact is determined mainly by the material and the thickness of the strut while the spatial attenuation of this impact is defined mainly by the strut width; (d) in the general perturbation, the most important magnitude is the free-area ratio for the path of the electrons, being the material characteristics and strut thickness of secondary importance; (e) analytical expressions are presented to estimate the magnitude of this perturbation according to the complete characteristics of the expanded strut, i.e., thickness, free-area ratio, and material; and (f) a simple algorithm is presented for estimating the free-area ratio when this information is not available.

GAF film dosimetry of a tandem positioned beta-emitting intravascular brachytherapy source train

Coronary artery brachytherapy may require treatment of lesions longer than a single source length. A treatment option is tandem positioning of the single source. This study presents relative dosimetric measurements of a cardiovascular brachytherapy source and the dosimetric characteristics in the junction region of tandem treatments. Measurements were carried out using a Novoste Beta Cath 90Sr/90Y 40 mm beta source in a plastic water phantom. Radiochromic MD-55-2 film, calibrated using both 6 MV photon and 6 MeV electron beams from a linear accelerator, was used as the dosimeter. Dose distributions around a single source and in the junction region of tandem irradiation were measured. Measurements of the near field dose as close as 1.2 mm from the source are presented. Significant over- or underdoses in the junction region of tandem irradiation were quantified. At a radial distance of 2 mm from the longitudinal axis of the source, the dose value in the middle of the junction region, normalized to the dose at 2 mm midline single source, was about 182% for a 2-seed overlap and 16% for a 2-seed gap, respectively. Dose distributions in the junction region as a function of source overlap and radial distance have fairly high gradients and exhibit characteristic patterns. The fraction of prescription dose was found to have a sigmoidal dependence on overlap size, for radial distances ranging between 1.2 and 3 mm. The parameters of these sigmoids, quantified as functions of radial distance, could be used to provide quick and reasonable over/underdose estimates, given any potential overlap or gap in the junction area, with an uncertainty within 10%.