Effects of acoustic nonlinearity on pulse-echo attenuation coefficient estimation from tissue-mimicking phantoms

Recent Advances in Attenuation Estimation

This chapter reviews some of the recent advances in the estimation of the local and the total attenuation, with an emphasis on reducing the bias and variance of the estimates. A special focus is put on describing the effect of power spectrum estimation on bias and variance, the introduction of regularization strategies, as well as on eliminating the need to use reference phantoms for compensating for system dependent effects.

Quantitative Ultrasound: Experimental Implementation

The backscatter coefficient is a fundamental property of tissues, much like the attenuation and sound speed. From the backscatter coefficient, different scatterer properties describing the underlying tissue can be used to characterize tissue state. Furthermore, because the backscatter coefficient is a fundamental property of a tissue, estimation of the backscatter coefficient should be able to be computed with system and operator independence. To accomplish system- and operator-independent estimates of the backscatter coefficient, a calibration spectrum must be obtained at the same system settings as the settings used to scan a tissue. In this chapter, we discuss three approaches to obtaining a calibration spectrum and compare the engineering tradeoffs associated with each approach. In addition, methods for reducing deterministic noise in the backscatter coefficient spectrum are considered and implementation of these techniques is discussed.

Ultrasonic backscatter coefficient estimation in nonlinear regime using an in situ calibration target

Tissue characterization based on the backscatter coefficient (BSC) can be degraded by acoustic nonlinearity. Often, this degradation is due to the method used for obtaining a reference spectrum, i.e., using a planar reference in water compared to a reference phantom approach resulted in more degradation. We hypothesize that an in situ calibration approach can improve BSC estimates in the nonlinear regime compared to using the reference phantom approach. The in situ calibration target provides a reference within the medium being interrogated and, therefore, nonlinear effects would already be contained in the in situ reference signal. Simulations and experiments in phantoms and in vivo were performed. A 2 mm diameter titanium bead was embedded in the interrogated media. An L9-4/38 probe (BK Ultrasound, Peabody, MA) and an analysis bandwidth from 4.5 to 7.4 MHz were used in experiments. Radiofrequency data from the sample, bead, and reference phantoms were acquired at a quasi-linear baseline power level and at further increments of output power. Better agreement between the BSC obtained at low power compared to high power was observed for the in situ calibration compared to the reference phantom approach.