The Influence of Ankle Braces on Functional Performance Tests and Ankle Joint Range of Motion

Effect of Braces on Performance in the Context of Chronic Ankle Instability

Ankle braces are commonly recommended for prevention of ankle sprains, especially secondary sprains, rehabilitation, and return to normal activity or sport after injury. One common resistance to use is the feeling that braces will impede functional performance. For people with chronic ankle instability, the limited research indicates that the use of semirigid, lace-up, or soft-shell braces will not affect, and in some cases, may enhance performance. Activities that could be enhanced are jumping, hopping, and dynamic balance.

The effect of two types of ankle orthoses on the repetitive rebound jump performance

Background

Ankle orthotics decreases the maximal vertical jump height. It is essential to maximize jump height and minimize ground contact time during athletic performance. However, the effect of ankle orthotics on athletic performance has not been reported. We aimed to investigate the effect of ankle orthotics on squat jump (SJ), countermovement jump (CMJ), and repetitive rebound jump (RJ) performance.

Methods

Twenty healthy volunteers performed SJ, CMJ, repetitive RJ under no-orthosis and two orthotic conditions (orthosis 1 and orthosis 2). During SJ and CMJ, we measured the vertical ground reaction force and calculated the following parameters: jump height, peak vertical ground reaction force, rate of force development, net vertical impulse, and peak power. During repetitive RJ, the jump height, contact time, and RJ index were measured. A two-dimensional motion analysis was used to quantify the ankle range of motion in the sagittal plane during SJ, CMJ, and repetitive RJ.

Results

Multivariate analysis of variance and the post hoc test showed orthosis 2 significantly decreased in the vertical jump height (p = 0.003), peak power (p = 0.007), and maximum plantarflexion and dorsiflexion angles (p < 0.001) during SJ Ankle orthoses 1 and 2 did not influence to the RJ performance compared to those using the no-orthosis condition. Additionally, orthosis 2 significantly decreased the jump height at the end of repetitive RJ (p = 0.046).

Conclusions

These results suggest that ankle orthosis do not affect average RJ performance but should be considered when performing repetitive jumps frequently.

Ankle Sprain Bracing Solutions and Future Design Consideration for Civilian and Military Use

INTRODUCTION

Ankle sprains are common injuries within the civilian and military populations, with lingering symptoms that include pain, swelling, giving-way, and a high likelihood for recurrence. Numerous bracing systems are available to stabilize the ankle joint following sprains, with new design iterations frequently entering the market. Currently available braces generally include sleeve, lace-up, and stirrup designs. Sleeves provide mild compression and warmth but limited stability for the ankle, while lace-ups and stirrups appear to be more effective at preventing and treating lateral ankle sprains.

AREAS COVERED

This review summarizes the use of various brace options in practice. Their major clinical benefits, and limitations are highlighted, followed by an overview of emerging concepts in brace design. Current advancements in biomechanical simulation, multifunctional material fabrication, and wearable, field-deployed devices for human injury surveillance are discussed, providing possibilities for conceiving new design concepts for next-generation smart ankle braces.

EXPERT OPINION

Performance of the commercially available braces are limited by their current design concepts. Suggestions on future brace design include: (1) incorporating high-performance materials suitable for extreme environments, (2) leveraging modeling and simulation techniques to predict mechanical support requirements, and (3) implementing adaptive, customizable componentry material to meet the needs of each unique patient.

USING FAST FOURIER TRANSFORM AND POLYNOMIAL FITTING ON DORSAL FOOT KINEMATICS DATA TO IDENTIFY SIMULATED ANKLE SPRAIN MOTIONS FROM COMMON SPORTING MOTIONS

Ankle sprain is very common in sports, and a commonly suggested etiology is the delayed peroneal muscle reaction time. Recent studies showed the successful attempts to deliver electrical stimulation to the peroneal muscles externally to initiate contraction before it could react, however, the success relies on a workable method to detect ankle sprain injury in time. This study presented a fast Fourier transform and polynomial fitting method with dorsal foot kinematics data for quick ankle sprain detection. Five males performed 100 simulated ankle sprain and 250 common sporting motion trials. Eight gyrometers recorded the three-dimensional angular velocities at 500[Formula: see text]Hz. Data were trimmed with a 0.11[Formula: see text]s window size, the suggested duration of preinjury phase in ankle sprain, and were transformed from time to frequency domain by fast Fourier transform and fitted with a fifth-order polynomial. First-order coefficients from polynomial fitting on frequency space were obtained. The method achieved 97.0% sensitivity and 91.4% specificity in identifying simulated sprains, vertical jump–landing, cutting, stepping-down, running, and walking motions, with vertical jump–landing excluded due to its relatively low specificity (67.3%). The method can be used to detect ankle sprain in sports with mainly floor movements and minimal vertical jump–landing motion.

The effect of silicone ankle sleeves and lace-up ankle braces on neuromuscular control, joint torque, and cutting agility

Objective

To evaluate the effects of silicone ankle sleeves (SASs) and lace-up ankle braces (LABs) on neuromuscular control, net joint torques, and cutting agility in healthy, active individuals.

Design

Markerless motion-capture technology tracked subjects fitted with SASs, LABs, or no brace while they performed the movements: Y-excursion, left cutting, right cutting, single-leg drop vertical jump (SLDVJ), 45-degree bound, and single-leg squat (SLS).

Setting

University Laboratory.

Participants

Ten healthy, active individuals (5 males and 5 females, mean ± SD 23.60 ± 1.43 years of age).

Main outcome measures

Degrees of joint range of motion (ROM), Newton-meters of joint torque, time to perform a cutting maneuver.

Results

SASs and LABs resulted in significantly different knee and ankle ROM and hip internal rotation in the SLDVJ, SLS, Y-excursion, cutting maneuver, and 45-degree bound when compared to control (p < .05). Both ankle and knee torque were significantly reduced in the 45-degree bound and cutting movements with both types of PABs (p < .05). There were minimal differences between the SASs and LABs for all conditions. There were no statistically significant differences in cutting times for any of the 3 conditions.

Conclusion

Both SAS and LAB positively impacted neuromuscular control, reduced net joint torque, and neither impaired cutting agility when compared to control.

Ankle bracing's effects during a modified agility task: analysis of sEMG, impulse, and time to complete using a crossover, repeated measures design

This study explored the effects of no braces, softshell (AE), and semi-rigid (T1) ankle braces on time to complete a modified agility task, as well as lower extremity muscle activity and impulse during the change of direction component of the task. Thirty-nine healthy, active individuals completed a modified agility task under the three brace conditions. Time to complete the modified agility task, along with mean surface electromyographic activity (sEMG) and impulse during the deceleration and propulsive phases of the task were measured. There were no significant differences across conditions with respect to sEMG or impulse measures during the deceleration or propulsive phases. There was a significant change in time to complete the modified agility task, F(2,76) = 17.242, p< 0.001, ηp² = 0.312. Post-hoc analysis revealed a significant increase in time to complete the modified agility task when wearing the AE (0.16 (95% CI, 0.062 to 0.265) seconds, p< 0.001) and T1 (0.20 (95% CI, 0.113 to 0.286) seconds, p< 0.001) ankle braces compared to no braces. It appears that performance on a modified agility task may be diminished when wearing ankle braces, although sEMG activity and impulse are unaffected.

Implications of Classification of Os Trigonum: A Study Based on Computed Tomography Three-Dimensional Imaging

BACKGROUND The os trigonum is an accessory bone that is not fully fused with the talus during secondary ossification, and is one of the risk factors of posterior malleolus impact syndrome. The purpose of this study was to classify the os trigonum and to guide the diagnosis and treatment of related clinical diseases. MATERIAL AND METHODS Ankle computed tomography (CT) scans of 586 Chinese patients between October 2014 and October 2018 were reviewed. CT images of 1011 ankle joints were reconstructed to evaluate the classification of the os trigonum and the measurement of anatomical parameters. RESULTS The incidences of os trigonum in 3 groups were determined as type I (1.9%), type II (10.5%), and type III (14.7%). The macro-axis of type II (0.89±0.31) cm was significantly larger than with type I (0.65±0.24 cm) and type III (0.74±0.23 cm) (p<0.05).The minor axis of similar of type I (0.41±0.23 cm) was significantly shorter than that of type II (0.58±0.32 cm) and type III (0.55±0.16 cm) (p<0.05).The distance from os trigonum to calcaneal tubercle was significantly different than that of type I (1.33±0.52 cm), type II (1.67±0.55 cm), and type III (1.84±0.45 cm) (p<0.05). CONCLUSIONS This study showed that os trigonum has a high incidence. Type I was the least common, the volume of type II was larger, and type III was more common. The anatomical parameters of each type may improve treatment of related diseases and the further development of ankle arthroscopic surgery.