Thermal resistance of Bacillus subtilis var. niger in a closed system

Review of techniques for the in-situ sterilization of soil contaminated with Bacillus anthracis spores or other pathogens

This review summarizes the literature on efficacy of techniques to sterilize soil. Soil may need to be sterilized if contaminated with pathogens such as Bacillus anthracis. Sterilizing soil in-situ minimizes spread of the bio-contaminant. Soil is difficult to sterilize, with efficacy generally diminishing with depth. Methyl bromide, formaldehyde, and glutaraldehyde are the only soil treatment options that have been demonstrated at full-scale to effectively inactivate Bacillus spores. Soil sterilization modalities with high efficacy at bench-scale include wet and dry heat, metam sodium, chlorine dioxide gas, and activated sodium persulfate. Simple oxidants such as chlorine bleach are ineffective in sterilizing soil.

Decontamination of soil contaminated at the surface with Bacillus anthracis spores using dry thermal treatment

In the event of a large, aerosol release of Bacillus anthracis spores in a major metropolitan area, soils and other outdoor materials may become contaminated with the biological agent. A study was conducted to assess the in-situ remediation of soil using a dry thermal treatment approach to inactivate a B. anthracis spore surrogate inoculated into soil samples. The study was conducted in two phases, using loam, clay and sand-based soils, as well as biological indicators and spore-inoculated stainless-steel coupons. Initial experiments were performed in an environmental test chamber with temperatures controlled between 80 and 110 °C, with and without added humidity, and with contact times ranging from 4 h to 7 weeks. Tests were then scaled up to assess the thermal inactivation of spores in small soil columns, in which a heating plate set to 141 °C was applied to the soil surface. These column tests were conducted to assess time requirements to inactivate spores as a function of soil depth and soil type. Results from the initial phase of testing showed that increasing the temperature and relative humidity reduced the time requirements to achieve samples in which no surrogate spores were detected. For the test at 80 °C with no added humidity, 49 days were required to achieve soil samples with no spores detected in clay and loam. At 110 °C, 24 h were required to achieve samples in which no spores were detected. In the column tests, no spores were detected at the 2.5 cm depth at four days and at the 5.1 cm depth at 21 days, for two of the three soils. The experiments described in the study demonstrate the feasibility of using dry thermal techniques to decontaminate soils that have been surficially contaminated with B. anthracis spores.

Review of Decontamination Techniques for the Inactivation of Bacillus anthracis and Other Spore-Forming Bacteria Associated with Building or Outdoor Materials

Since the intentional release of Bacillus anthracis spores through the U.S. Postal Service in the fall of 2001, research and development related to decontamination for this biological agent have increased substantially. This review synthesizes the advances made relative to B. anthracis spore decontamination science and technology since approximately 2002, referencing the open scientific literature and publicly available, well-documented scientific reports. In the process of conducting this review, scientific knowledge gaps have also been identified. This review focuses primarily on techniques that are commercially available and that could potentially be used in the large-scale decontamination of buildings and other structures, as well as outdoor environments. Since 2002, the body of scientific data related to decontamination and microbial sterilization has grown substantially, especially in terms of quantifying decontamination efficacy as a function of several factors. Specifically, progress has been made in understanding how decontaminant chemistry, the materials the microorganisms are associated with, environmental factors, and microbiological methods quantitatively impact spore inactivation. While advancement has been made in the past 15 years to further the state of the science in the inactivation of bacterial spores in a decontamination scenario, further research is warranted to close the scientific gaps that remain.

Determination of lethality rate constants and D-values for heat-resistant Bacillus spores ATCC 29669 exposed to dry heat from 125°C to 200°C

Exposing flight hardware to dry heat is a NASA-approved sterilization method for reducing microbial bioburden on spacecraft. The existing NASA specification only allows heating the flight hardware between 104°C and 125°C to reduce the number of viable microbes and bacterial spores. Also, the NASA specifications only allow a four log reduction by dry heat microbial reduction because very heat-resistant spores are presumed to exist in a diverse population (0.1%). The goal of this research was to obtain data at higher temperatures than 125°C for one of the most heat-resistant microorganisms discovered in a spacecraft assembly area. These data support expanding the NASA specifications to temperatures higher than 125°C and relaxing the four log reduction specification. Small stainless steel vessels with spores of the Bacillus strain ATCC 29669 were exposed to constant temperatures between 125°C and 200°C under both dry and ambient room humidity for set time durations. After exposures, the thermal spore exposure vessels were cooled and the remaining spores recovered and plated out. Survivor ratios, lethality rate constants, and D-values were determined at each temperature. The D-values for the spores exposed under dry humidity conditions were always found to be shorter than those under ambient humidity. The temperature dependence of the lethality rate constants was obtained by assuming that they obeyed Arrhenius behavior. The results are compared to those of B. atrophaeus ATCC 9372. In all cases, the D-values of ATCC 29669 are between 20 and 50 times longer than those of B. atrophaeus ATCC 9372.

Pilot-scale experimental and theoretical investigations into the thermal destruction of a Bacillus anthracis surrogate embedded in building decontamination residue bundles

Bacillus anthracis (B. anthracis) spores were released through the U.S. mail system in 2001, highlighting the need to develop efficacious methods of decontaminating and disposing of materials contaminated with biological agents. Incineration of building decontamination residue is a disposal option for such material, although the complete inactivation of bacterial spores via this technique is not a certainty. Tests revealed that under some circumstances, Geobacillus stearothermophilus (G. stearothermophilus; a surrogate for B. anthracis) spores embedded in building materials remained active after 35 min in a pilot-scale incinerator and survived with internal material bundle temperatures reaching over 500 degrees C. A model was also developed to predict survival of a bacterial spore population undergoing thermal treatment in an incinerator using the thermal destruction kinetic parameters obtained in a laboratory setting. The results of the pilot-scale incinerator experiments are compared to model predictions to assess the accuracy of the model.

Effect of the wavelength of infrared heaters on the inactivation of bacterial spores at various water activities

Bacterial spores (Bacillus subtilis subsp. subtilis NBRC 16183) inoculated onto a stainless steel Petri dish and treated at nine levels of water activity (a(w)) for 2 days were inactivated by infrared radiation heating (IRH) using three kinds of infrared heaters with different radiation spectra. The peak wavelengths used were 950, 1,100 and 1,150 nm. In general, the inactivating efficacy of IRH treatment against bacterial spores with shorter wavelength heater (950 nm) was greater than that with other heaters. The decimal reduction times (D value) calculated using the linear portion of survival curves were affected by both the initial a(w) values and the spectra of the infrared rays. Spores at approximately 0.9, 0.7 and 0.6 a(w) were most resistant to IRH at wavelengths of 950, 1,100 and 1,150 nm, respectively. The a(w) values that led to maximum D values for bacterial spores increased as the wavelength was shortened. Optimum a(w) values were identified for the inactivation of bacterial spores by IRH. Spore resistance to IRH could also be affected by the spectral characteristics of the infrared absorption, which varied with the a(w) of bacterial spores.

Microbicidal efficacy of superheated steam. II. Studies involving E. faecium and spores of B. xerothermodurans and B. coagulans

The authors' studies on the heat resistance of microorganisms and the superheating of steam (Spicher et al., Zbl. Hyg. Umweltmed. 201, 541-553, 1999) have been continued, using the vegetative bacterium, Enterococcus faecium, and spores of B. xerothermodurans and B. coagulans. The temperature of the saturated steam was 68 degrees C (E. faecium), 105 degrees C (B. xerothermodurans) and 110 degrees C (B. coagulans), respectively. The steam was superheated by 30-40 K, as a maximum. The test organisms had been fixed to fibre glass fleece. The time of exposure to saturated or superheated steam after which 50% of the bioindicators yielded no viable germs was used as a measure of resistance of the organisms. In the discussion, reference has also been made to the findings for B. subtilis and B. stearothermophilus spores obtained in the preceding study. E. faecium exhibited a maximum resistance when superheating the steam by 5 K. The superheated steam required a 74-fold exposure time compared to saturated steam of 68 degrees C. Resistance became gradually reduced as superheating was further increased. Even superheating by 30 K required a 11-fold exposure time. The bacterial spores exhibited maxima of resistance on superheating by 23-30 K. In these cases necessary exposure times were 119 (B. subtilis), 30 (B. xerothermodurans), and 4 times (B. coagulans, B. stearothermophilus) longer than those required in saturated steam. In the superheating range below 10 K, behaviour patterns varied. Thus, heat resistance may initially become reduced with increasing superheating (B. coagulans), remain on almost the same level as under exposure to saturated steam (B. stearothermophilus), reach a stage of weakly enhanced resistance (B. xerothermodurans), or approach a maximum of resistance in an almost linear mode (B. subtilis). It appears that there are differences between strains of one and the same bacterial species.

Heat Resistance of Bacillus Spores at Various Relative Humidities

The thermal resistance characteristics of spores from strains of five different Bacillus species were determined in phosphate buffer and at relative humidities ranging from <0.001 to 100% in a closed-can system. Spores tested in the closed-can system showed a marked increase in heat resistance over those in phosphate buffer, with the greatest increases occurring at relative humidities between 1 and 50%. When estimates of the time to reduce the initial spore concentration 99.99% ( F value) at eight different relative humidities were plotted against temperature, three different types of heat resistance profiles were obtained, with maximum resistances at relative humidities of 1, 7, and 30%. When the various strains of spores were heated at the relative humidity of their maximum heat resistance, their relative order of heat resistance was different from that seen in buffer. Spores from the soil isolate were most resistant under these conditions ( F 121.1 = 99.5 h).

The effect of quaternary ammonium compounds and amine oxides on spores of Bacillus cereus

The effect of 1-dodecylpiperidine 1-oxide and N,N'-bis(dodecyldimethyl)-1,2-ethane diammonium dibromide on the spores of Bacillus cereus. particularly their binding to intact spores and spores with reduced cystine bonds, was investigated. The Langmuir type of binding is involved in both cases. Both compounds decreased the thermoresistance of spores. DPNO decreased the fraction of non-germinating spores, the effect of the drug increasing with increasing concentration. This phenomenon was associated with a faster release of dipicolinic acid to the medium. Only microgermination proceeded in the presence of BDED and dipicolinic acid was released only in substantially lower amounts. Both compounds also influenced respiration.

Thermal resistance of naturally occurring airborne bacterial spores

Simulation of a heat process used in the terminal dry-heat decontamination of the Viking spacecraft is reported. Naturally occurring airborne bacterial spores were collected on Teflon ribbons in selected spacecraft assembly areas and subsequently subjected to dry heat. Thermal inactivation experiments were conducted at 105, 111.7, 120, 125, 130, and 135 degrees C with a moisture level of 1.2 mg of water per liter. Heat survivors were recovered at temperatures of 135 degrees C when a 30-h heating cycle was employed. Survivors were recovered from all cycles studied and randomly selected for identification. The naturally occurring spore population was reduced an average of 2.2 to 4.4 log cycles from 105 to 135 degrees C. Heating cycles of 5 and 15 h at temperature were compared with the standard 30-h cycle at 111.7, 120, and 125 degrees C. No significant differences in inactivation (alpha = 0.05) were observed between 111.7 and 120 degrees C. The 30-h cycle differs from the 5-and 15-h cycles at 125 degrees C. Thus, the heating cycle can be reduced if a small fraction (about 10-3 to 10-4) of very resistant spores can be tolerated.