Genetic characterization of aggregation-defective developmental mutants of Myxococcus xanthus

Exopolysaccharide biosynthesis genes required for social motility in Myxococcus xanthus

Social (S)-motility in Myxococcus xanthus is a flagellum-independent gliding motility system that allows bacteria to move in groups on solid surfaces. S-motility has been shown to require type IV pili (TFP), exopolysaccharide (EPS; a component of fibrils) and lipopolysaccharide (LPS). Previously, information concerning EPS biogenesis in M. xanthus was lacking. In this study, we screened 5000 randomly mutagenized colonies for defects in S-motility and EPS and identified two genetic regions essential for EPS biogenesis: the EPS synthesis (eps) region and the EPS-associated (eas) region. Mutants with insertions in the eps and eas regions were defective in S-motility and fruiting body formation. These mutants failed to bind the dye calcofluor white, indicating that they lacked EPS; however, they retained normal TFP and LPS. Analysis of the eps locus showed several open reading frames (ORFs) that encode homologues to glycosyltransferases, glucanases and EPS transporters as well as regulatory proteins; the eas locus contains two ORFs: one exhibits homology to hypothetical proteins with a conserved domain of unknown function and the other displays no apparent homology to other proteins in the database. Further genetic mutagenesis analysis indicates that the whole eps region is involved in the biosynthesis of fibrils and fibril EPS. The operon at the proximal end of the eps region was analysed by generating in-frame deletion mutations. These mutants showed varying degrees of defects in the bacterium's ability to produce EPS or perform EPS-related functions, confirming the involvement of these genes in M. xanthus EPS biogenesis.

Cell-cell interactions that direct fruiting body development in Myxococcus xanthus

The soil bacterium, Myxococcus xanthus initiates a developmental program when nutrients are limited. This results in the formation of a multicellular fruiting body structure filled with differentiated, environmentally resistant spores. At least four cell-cell signals, cell motility, and aggregation functions are required for the completion of fruiting body formation.

Social and developmental biology of the myxobacteria

Myxobacteria are soil bacteria whose unusually social behavior distinguishes them from other groups of procaryotes. Perhaps the most remarkable aspect of their social behavior occurs during development, when tens of thousands of cells aggregate and form a colorful fruiting body. Inside the fruiting body the vegetative cells convert into dormant, resistant myxospores. However, myxobacterial social behavior is not restricted to the developmental cycle, and three other social behaviors have been described. Vegetative cells have a multigene social motility system in which cell-cell contact is essential for gliding in multicellular swarms. Cell growth on protein is cooperative in that the growth rate increases with the cell density. Rippling is a periodic behavior in which the cells align themselves in ridges and move in waves. These social behaviors indicate that myxobacterial colonies are not merely collections of individual cells but are societies in which cell behavior is synchronized by cell-cell interactions. The molecular basis of these social behaviors is becoming clear through the use of a combination of behavioral, biochemical, and genetic experimental approaches.

Social and developmental biology of the myxobacteria

Myxobacteria are soil bacteria whose unusually social behavior distinguishes them from other groups of procaryotes. Perhaps the most remarkable aspect of their social behavior occurs during development, when tens of thousands of cells aggregate and form a colorful fruiting body. Inside the fruiting body the vegetative cells convert into dormant, resistant myxospores. However, myxobacterial social behavior is not restricted to the developmental cycle, and three other social behaviors have been described. Vegetative cells have a multigene social motility system in which cell-cell contact is essential for gliding in multicellular swarms. Cell growth on protein is cooperative in that the growth rate increases with the cell density. Rippling is a periodic behavior in which the cells align themselves in ridges and move in waves. These social behaviors indicate that myxobacterial colonies are not merely collections of individual cells but are societies in which cell behavior is synchronized by cell-cell interactions. The molecular basis of these social behaviors is becoming clear through the use of a combination of behavioral, biochemical, and genetic experimental approaches.

Genetic analysis of tag mutants of Myxococcus xanthus provides evidence for two developmental aggregation systems

Temperature-dependent aggregation mutants (tag) of the myxobacterium Myxococcus xanthus aggregated into mounds and developed into fruiting bodies normally at 28 degrees C; however, they failed to form mounds at 34 degrees C. The timing of sporulation was unaffected by the mutations, and normal numbers of spores were produced at both permissive and restrictive temperatures. This class of mutations was originally identified through screening of ethyl methanesulfonate (EMS)-generated mutations. Subsequent work identified a linked insertion of transposon Tn5, which was used to map the EMS-generated mutations to four loci. In this paper, we describe the cloning of the tag loci and the use of transposon mutagenesis to further analyze the tag loci. Nine tag complementation groups spanning 8.5 kilobase pairs of DNA were identified through mapping of 28 independent Tn5 insertions. All insertion and deletion mutants had the same phenotype as the EMS mutants: they were temperature sensitive for mound formation. This result suggests that M. xanthus has at least two sets of genes for developmental aggregation. The tag genes constitute one set of these genes; they are required for normal development at 34 degrees C but are not required for normal development at 28 degrees C.

Control of morphogenesis in myxobacteria

The myxobacteria are Gram-negative soil bacteria that live in large communities known as swarms. The most remarkable characteristic of myxobacteria is their ability to form fruiting bodies that have a species-specific shape and color. Fruiting body formation requires the concerted effort of hundreds of thousands of cells. Development is initiated only when two conditions are satisfied. The cells must be nutritionally deprived (environmental signal) and there must be many other cells in the vicinity (intercellular signal). The development of one species, Myxococcus xanthus, has been studied in the most detail. M. xanthus uses amino acids as its primary carbon, nitrogen, and energy source. Starvation for a single amino acid, or for inorganic phosphate, serves as the environmental signal. A variety of intercellular signals appear to control the initiation of development and the timing of subsequent developmental events.

Genetic analysis of Myxococcus xanthus and isolation of gene replacements after transduction under conditions of limited homology

Genetic analysis of Myxococcus xanthus is greatly facilitated by the ability to introduce cloned DNA into M. xanthus to generate gene replacement and merodiploid strains. However, gene replacement strains are difficult to obtain when the region(s) of homology between the cloned DNA and the M. xanthus chromosome is limited (less than 1 kilobase). We found that gene replacements can be obtained at an increased frequency by a two-step procedure involving the use of bacteriophage P1 to isolate merodiploid strains followed by generalized transduction to another M. xanthus strain by using phage Mx4.

Changes in cell surface hydrophobicity of Myxococcus xanthus are correlated with sporulation-related events in the developmental program

Cell surface hydrophobicity was measured in the bacterium Myxococcus xanthus during vegetative growth, fruiting body formation, and glycerol-induced spore formation by the method of Rosenberg et al. (FEMS Microbiol. Lett. 9:29-33, 1980). A significant decrease in cell surface hydrophobicity was observed 12 to 36 h after fruiting body formation and 60 to 120 min after glycerol-induced sporulation. The hydrophilic shift was correlated with the ability of the cells to sporulate but not with their ability to aggregate. Sucrose gradient purification removed the hydrophilic substance from the fruiting body spores but not from the glycerol-induced spores. The change in cell surface hydrophobicity in M. xanthus should be a useful developmental marker.

Coliphage P1-mediated transduction of cloned DNA from Escherichia coli to Myxococcus xanthus: use for complementation and recombinational analyses

We have found that coliphage P1 can be used to transduce cloned DNA from Escherichia coli to Myxococcus xanthus. Transduction occurred at a high efficiency, and no evidence for DNA restriction was observed. The analysis of the transductants showed that they fall into three general categories: (i) haploid cells which contain portions of the cloned DNA substituted for homologous chromosomal DNA; (ii) heterozygous merodiploids which contain the recombinant plasmid integrated into the chromosome at a region of homology; and (iii) homozygous merodiploids which contain two copies of a portion of the cloned DNA with the loss of the chromosomal copy of the genes. The merodiploids, once formed, are relatively stable. They were used to analyze two genes necessary for aggregation and thus fruiting body formation. P1 transduction also permits the reintroduction and substitution of mutated regions of cloned DNA into M. xanthus for the analysis of the role of the DNA in cellular physiology and development.

Insertions of Tn5 near genes that govern stimulatable cell motility in Myxococcus

Insertions of transposon Tn5 were used to examine the genetics of motility mutants in Myxococcus. Fifteen independent insertions of Tn5 were isolated that were linked to seven different loci that govern motility. Among the motility mutants that can be stimulated to move transiently by contact with other cells, a one-to-one correspondence was confirmed between specificity of stimulation and genetic locus. There are six different specificities and six corresponding loci, as if each locus governs a different protein required for gliding motility.

RNA polymerase of Myxococcus xanthus: purification and selective transcription in vitro with bacteriophage templates

DNA-dependent RNA polymerase from vegetative cells of the gram-negative, fruiting bacterium Myxococcus xanthus was purified more than 300-fold by a modified Burgess procedure (Lowe et al., Biochemistry 18:1344-1352, 1979), using Polymin P precipitation, 40 to 65% saturated ammonium sulfate fractional precipitation, double-stranded DNA cellulose chromatography, A5m gel filtration chromatography, and single-stranded DNA agarose chromatography. The last step separated the RNA polymerase into a core fraction and an enriched holoenzyme fraction. The core enzyme showed a subunit structure similar to that of the Escherichia coli polymerase, as follows: beta' and beta (145,000 and 140,000 daltons, respectively) and alpha (38,000 daltons). A comparison of the core enzyme and the holoenzyme implicated two polypeptides as possible sigma subunits. These polypeptides were closely related, as indicated by peptide analysis. M. xanthus RNA polymerase was capable of transcribing DNAs from E. coli phages T7, T4, and lambda, Bacillus subtilis phage phi 29, and M. xanthus phages Mx1, Mx4, and Mx8. Transcription of T7 and phi 29 DNAs was stimulated by KCl, whereas transcription of Mx1, Mx4, and Mx8 DNAs was inhibited by KCl. Magnesium ion dependence, rifampin and heparin sensitivities, and spermidine stimulation of M. xanthus RNA polymerase activity were similar to those found with E. coli RNA polymerase. The pH optimum of M. xanthus RNA polymerase activity was more basic than that of E. coli polymerase. M. xanthus RNA polymerase was capable of selective transcription in vitro when DNAs from phages T7 delta 111, phi 29, and Mx1 were used. The molecular weights of the resulting phage RNA transcripts made by M. xanthus RNA polymerase (as determined by agarose-acrylamide slab gel electrophoresis) were the same as the molecular weights of the transcripts synthesized by E. coli RNA polymerase. No discrete transcripts were detected as the in vitro RNA products of M. xanthus phage Mx4 and Mx8 DNA transcription. Southern transcript synthesized by M. xanthus RNA polymerase. Three transcripts (transcripts A, B, and C; molecular weights, 2.55 X 10(6), 1.95 X 10(6), and 1.56 X 10(6), respectively) were identified as in vitro RNA products of M. xanthus phage Mx1 DNA transcription when either E. coli or M. xanthus RNA polymerase was used. A Southern blot hybridization analysis indicated that the E. coli RNA polymerase and the M. xanthus RNA polymerase transcribe common SalI restriction fragments of Mx1 DNA.

"Frizzy" mutants: a new class of aggregation-defective developmental mutants of Myxococcus xanthus

During fruiting-body formation in Myxococcus xanthus, cells aggregate into raised mounds, where they sporulate. A new class of aggregation-defective developmental mutants was identified within a collection of nonfruiting mutants of M. xanthus. The mutants failed to aggregate into discrete mounds, but rather aggregated into "frizzy" filaments. Many cells within the filaments sporulated normally. Pairwise mixtures of representative frizzy mutants were unable to stimulate each other to aggregate normally. Two strains of M. xanthus were isolated which contained transposon Tn5 insertions mapping near one frizzy mutation. A search through 36 mutants exhibiting the frizzy phenotype showed that all were linked to the same Tn5 insertion sites. Three-factor cross-analysis of 22 of these mutants allowed the mapping of these mutations into many loci. The localization of Tn5 inserts adjacent to this region make possible further manipulation of these genes.