Factors influencing cell shape in the mutans group of streptococci

PBP1a-deficiency causes major defects in cell division, growth and biofilm formation by Streptococcus mutans

Streptococcus mutans, a key etiological agent of human dental caries, lives almost exclusively on the tooth surface in plaque biofilms and is known for its ability to survive and respond to various environmental insults, including low pH, and antimicrobial agents from other microbes and oral care products. In this study, a penicillin-binding protein (PBP1a)-deficient mutant, strain JB467, was generated by allelic replacement mutagenesis and analyzed for the effects of such a deficiency on S. mutans’ stress tolerance response and biofilm formation. Our results so far have shown that PBP1a-deficiency in S. mutans affects growth of the deficient mutant, especially at acidic and alkaline pHs. As compared to the wild-type, UA159, the PBP1a-deficient mutant, JB467, had a reduced growth rate at pH 6.2 and did not grow at all at pH 8.2. Unlike the wild-type, the inclusion of paraquat in growth medium, especially at 2 mM or above, significantly reduced the growth rate of the mutant. Acid killing assays showed that the mutant was 15-fold more sensitive to pH 2.8 than the wild-type after 30 minutes. In a hydrogen peroxide killing assay, the mutant was 16-fold more susceptible to hydrogen peroxide (0.2%, w/v) after 90 minutes than the wild-type. Relative to the wild-type, the mutant also had an aberrant autolysis rate, indicative of compromises in cell envelope integrity. As analyzed using on 96-well plate model and spectrophotometry, biofilm formation by the mutant was decreased significantly, as compared to the wild-type. Consistently, Field Emission-SEM analysis also showed that the PBP1a-deficient mutant had limited capacity to form biofilms. TEM analysis showed that PBP1a mutant existed primarily in long rod-like cells and cells with multiple septa, as compared to the coccal wild-type. The results presented here highlight the importance of pbp1a in cell morphology, stress tolerance, and biofilm formation in S. mutans.

The elongation of ovococci

The morphogenesis of ovococci has been reviewed extensively. Recent results have provided new insights concerning the mechanisms of elongation in ovoid bacteria. We present here the proteins involved in the elongation (firmly established and more or less hypothetical) and discuss the relationship between elongation and division of ovococci.

A new morphogenesis pathway in bacteria: unbalanced activity of cell wall synthesis machineries leads to coccus-to-rod transition and filamentation in ovococci

Bacteria display a variety of shapes, which have biological relevance. In most eubacteria, cell shape is maintained by the tough peptidoglycan (PG) layer of the cell wall, the sacculus. The organization of PG synthesis machineries, orchestrated by different cytoskeletal elements, determines the specific shapes of sacculi. In rod-shaped bacteria, the actin-like (MreB) and the tubuline-like (FtsZ) cytoskeletons control synthesis of the sidewall (elongation) and the crosswall (septation) respectively. Much less is known concerning cell morphogenesis in cocci, which lack MreB proteins. While spherical cocci exclusively display septal growth, ovococci additionally display peripheral growth, which is responsible of the slight longitudinal expansion that generates their ovoid shape. Here, we report that the ovococcus Lactococcus lactis has the ability to become rod-shaped. L. lactis IL1403 wild-type cells form long aseptate filaments during both biofilm and planktonic growth in a synthetic medium. Nascent PG insertion and the division protein FtsK localize in multiple peripheral rings regularly spaced along the filaments. We show that filamentation results from septation inhibition, and that penicillin-binding proteins PBP2x and PBP2b play a direct role in this process. We propose a model for filament formation in L. lactis, and discuss the possible biological role of such morphological differentiation.

Defects in D-alanyl-lipoteichoic acid synthesis in Streptococcus mutans results in acid sensitivity

In the cariogenic organism, Streptococcus mutans, low pH induces an acid tolerance response (ATR). To identify acid-regulated proteins comprising the ATR, transposon mutagenesis with the thermosensitive plasmid pGh9:ISS1 was used to produce clones that were able to grow at neutral pH, but not in medium at pH 5.0. Sequence analysis of one mutant (IS1A) indicated that transposition had created a 6.3-kb deletion, one end of which was in dltB of the dlt operon encoding four proteins (DltA-DltD) involved in the synthesis of D-alanyl-lipoteichoic acid. Inactivation of the dltC gene, encoding the D-alanyl carrier protein (Dcp), resulted in the generation of the acid-sensitive mutant, BH97LC. Compared to the wild-type strain, LT11, the mutant exhibited a threefold-longer doubling time and a 33% lower growth yield. In addition, it was unable to initiate growth below pH 6.5 and unadapted cells were unable to survive a 3-h exposure in medium buffered at pH 3.5, while a pH of 3.0 was required to kill the wild type in the same time period. Also, induction of the ATR in BH97LC, as measured by the number of survivors at a pH killing unadapted cells, was 3 to 4 orders of magnitude lower than that exhibited by the wild type. While the LTA of both strains contained a similar average number of glycerolphosphate residues, permeabilized cells of BH97LC did not incorporate D-[(14)C]alanine into this amphiphile. This defect was correlated with the deficiency of Dcp. Chemical analysis of the LTA purified from the mutant confirmed the absence of D-alanine-esters. Electron micrographs showed that BH97LC is characterized by unequal polar caps and is devoid of a fibrous extracellular matrix present on the surface of the wild-type cells. Proton permeability assays revealed that the mutant was more permeable to protons than the wild type. This observation suggests a mechanism for the loss of the characteristic acid tolerance response in S. mutans.

Transformation efficiency of EMS-induced mutants of Streptococcus mutans of altered cell shape

Some Streptococcus mutans strains change shape from bacillary to coccal or ellipsoid form in response to the ratio of bicarbonate to potassium or of borate to potassium in growth media. So that insight into determinants of shape of these streptococci could be gained, and future genetic studies facilitated, the shapes of a series of transformable and nontransformable strains of S. mutans were studied and attempts made to isolate a mutant of augmented transformability. Several strains were mutagenized by ethylmethane sulfonate and mutants with altered colonial and cellular morphologies isolated. Cell shapes were studied by Gram stain and Nomarski interference microscopy, and by scanning and transmission electron microscopy. Diverse shape-altered mutants were isolated from seven transformable and two nontransformable strains of S. mutans. Among these, length-to-width ratios ranged from > 10 to about 0.25. Regulation of timing of cell division, septum formation, or septum completion events may have been altered in these mutants. While most mutants substantially or completely lost transformability, mutant LT11 had transformation efficiency of 1.3 x 10(-4) to 2.3 x 10(-3), more than two to three orders of magnitude greater than its parental UA159 and the well-known transformable strain GS5(HK), respectively. There was no evidence of production of competence factor by LT11. Competence of LT11 was maintained for at least six months upon storage at -70 degrees C, facilitating its use for genetic studies. While the morphologies of several shape-altered mutants were no longer responsive to changes of the bicarbonate/potassium, unlike those of their parentals, the morphology of LT11 persisted in its response to this condition.(ABSTRACT TRUNCATED AT 250 WORDS)

Identification of several rod loci and cloning of the rodD locus of Streptococcus mutans

Previous work has shown that Streptococcus mutans is normally a short rod or a sphere, depending on its environment. This paper describes two distinct genetic approaches used to identify multiple loci and isolate one locus, rodD, controlling S. mutans rod shape. The first method involved isolation of a group of rod- mutants caused by transposon Tn916 insertion, and analysis of the inactivated genes by Southern hybridization. The second method involved mutagenesis via a shotgun insertion-duplication technique, isolation of a rod- mutant, and cloning the intact rod locus, employing an integration shuttle plasmid, pVA891. These approaches have led to the identification of multiple rod loci involved in determining the rod shape of S. mutans, and also cloning of one rod locus, rodD. The cloning strategy may also be useful for cloning other streptococcal genes which cannot be detected by their expression in Escherichia coli.