Compositional Tailoring of Mg-2Zn-1Ca Alloy Using Manganese to Enhance Compression Response and In-Vitro Degradation

The present study investigates Mg–2Zn–1Ca/XMn alloys as biodegradable implants for orthopedic fracture fixation applications. The effect of the presence and progressive addition of manganese (X = 0.3, 0.5, and 0.7 wt.%) on the degradation, and post-corrosion compressive response were investigated. Results suggest that the addition of manganese at 0.5 wt.% improved the corrosion resistance of Mg–2Zn–1Ca alloys. The pH values stabilized for the 0.5Mn-containing alloy and displayed a lower corrosion rate when compared to other Mg–2Zn–1Ca/Mn alloys. Mg–2Zn–1Ca showed a progressive reduction in the compressive strength properties at the end of day 21 whereas Mg–2Zn–1Ca/0.3Mn and Mg–2Zn–1Ca/0.5Mn samples showed a decrease until day 14 and stabilized around the same strength range after day 21. The ability of Mg–2Zn–1Ca/0.5Mn alloy to develop a network of protective hydroxide and phosphate layers has resulted in the corrosion control of the alloy. Mg–2Zn–1Ca/0.7Mn displays segregation of Mn particles at the grain boundaries resulting in decreased corrosion protection. The mechanism behind the corrosion protection of Mg–2Zn–1Ca alloys was discussed.

Quenching of the Eu3+ Luminescence by Cu2+ Ions in the Nanosized Hydroxyapatite Designed for Future Bio-Detection

The hydroxyapatite nanopowders of the Eu3+-doped, Cu2+-doped, and Eu3+/Cu2+-co-doped Ca10(PO4)6(OH)2 were prepared by a microwave-assisted hydrothermal method. The structural and morphological properties of the products were investigated by X-ray powder diffraction (XRD), transmission electron microscopy techniques (TEM), and infrared spectroscopy (FT-IR). The average crystal size and the unit cell parameters were calculated by a Rietveld refinement tool. The absorption, emission excitation, emission, and luminescence decay time were recorded and studied in detail. The 5D0 → 7F2 transition is the most intense transition. The Eu3+ ions occupied two independent crystallographic sites in these materials exhibited in emission spectra: one Ca(1) site with C3 symmetry and one Ca(2) sites with Cs symmetry. The Eu3+ emission is strongly quenched by Cu2+ ions, and the luminescence decay time is much shorter in the case of Eu3+/Cu2+ co-doped materials than in Eu3+-doped materials. The luminescence quenching mechanism as well as the schematic energy level diagram showing the Eu3+ emission quenching mechanism using Cu2+ ions are proposed. The electron paramagnetic resonance (EPR) technique revealed the existence of at least two different coordination environments for copper(II) ion.

Effect of the usage of Er,Cr:YSGG laser with and without different remineralization agents on the enamel erosion of primary teeth

The aim of the present study was to evaluate the effects of different remineralization agents associated with erbium, chromium:yttrium-scandium-gallium-garnet (Er,Cr:YSGG) (0.5 W power, 20 Hz frequency, 60% water, 40% air, 25 mJ pulse energy, 8.84 J/cm² fluence, 60 μs pulse duration, 600 μm tip diameter, and an approximate 1-1.5 mm distance to the target) laser irradiation on erosion induced by the consumption of carbonated drinks in human primary enamel. There were 8 groups and 10 primary teeth in each g0roup. The distribution was as follows: group 1, casein phosphopeptide-amorphous calcium phosphate with fluoride (CPP-ACPF); group 2, Er,Cr:YSGG laser+CPP-ACPF; group 3, fluor varnish; group 4, Er,Cr:YSGG Laser+fluoride varnish; group 5, ROCS® medical mineral gel; group 6, Er,Cr:YSGG laser + ROCS® medical mineral gel; group 7, Er,Cr:YSGG laser; and group 8, artificial saliva. The samples in the groups were submerged in artificial saliva and acid twice a day for 6 s at 6-h intervals and were then exposed to an erosion cycle 15 times. In the groups in which the Er,Cr:YSGG laser was applied in combination with the remineralization agents, the laser application was made first, and then the remineralization agents were applied for 4 min in each group. The Friedman and Wilcoxon signed-rank tests and the Bonferroni correction were used in statistical analyses, and the significance level was taken as p < 0.05. According to the results, all agents had a statistically significant difference (groups 1, 2, 3, 4, and 6: p = 0.005, p < 0.017; groups 5 and 7: p = 0.007, p < 0.017) between BL-RM periods. However, all agents had a statistically significant remineralization effect on primary teeth enamel (groups 1, 2, 3, 6, and 7: p = 0.005, p < 0.017; group 4: p = 0.011, p < 0.017) except that group 5 (p = 0.074, p < 0.017) between DM-RM periods. The coadministration of an agent with the laser did not make any difference at a statistical level (p = 0.804, p > 0.05). The results were supported by scanning electron microscopy (SEM) and X-ray diffraction (XRD) analysis. As a result of this study, CPP-ACPF had a notable impact in terms of the remineralization effect on eroded enamel, and the Er,Cr:YSGG laser alone may be an alternative method, which may be related to the modified hydroxyapatite structure, 38.5% H_0.56Ca_4.56O₁₃P₃Y_0.44, that was determined in XRD analysis.

Identification of the chromophore in the apatite pigment [Sr10(PO4)6(Cu(x)OH(1-x-y))2]: linear OCuO- featuring a resonance Raman effect, an extreme magnetic anisotropy, and slow spin relaxation

A new chromophore has been identified in copper-doped apatite pigments having the general composition [Sr(10)(PO(4))(6)(Cu(x)OH(1-x-y))(2)], in which x=0.1, 0.3 and y=0.01-0.42. By using X-ray absorption spectroscopy, low-temperature magnetization measurements, and synchrotron X-ray powder structure refinement, it has been shown that the oxygenated compounds contain simultaneously diamagnetic Cu(1+) and paramagnetic Cu(3+) with S=1. Cu(3+) is located at the same crystallographic position as Cu(1+), being linearly coordinated by two oxygen atoms and forming the OCuO(-) anion. The Raman spectroscopy study of [A(10)(PO(4))(6)(Cu(x)OH(1-x-y))(2)], in which A=Ca, Sr, Ba, reveals resonance bands at 651-656 cm(-1) assigned to the symmetric stretching vibration (ν(1)) of OCuO(-). The strontium apatite pigment exhibits a strong paramagnetic anisotropy with an unprecedentedly large negative zero-field splitting parameter (D) of ≈-400 cm(-1). The extreme magnetic anisotropy causes slow magnetization relaxation with relaxation times (τ) up to 0.3 s at T=2 K, which relates the compounds to single-ion magnets. At low temperature, τ is limited by a spin quantum-tunneling, whereas at high temperature a thermally activated relaxation prevails with U(eff)≈48 cm(-1). Strong dependence of τ on the paramagnetic center concentration at low temperature suggests that the spin-spin relaxation dominates in the spin quantum-tunneling process. The compound is the first example of a d-metal-based single-ion magnet with S=1, the smallest spin at which an energy barrier arises for the spin flipping.