Application of the interface equilibria-triggered dynamic diffusion model of the boundary potential for the numerical simulation of neutral carrier-based ion-selective electrodes response

It is shown that a simple dynamic diffusion model of the boundary potential based on a separate, step-by-step, account of ion transfer across the membrane/aqueous solution interface and the diffusion processes within both phases which was proposed earlier for describing the response of ionophore-free membranes, can be successfully used for ionophore-based membranes as well. The model makes it possible to carry out both separate and joint account of the effects of co-extraction, transmembrane transport and ion exchange on the boundary potential and retains robustness in all the variants studied. The model adequately describes the ionophore-based electrode response over the entire range of concentrations and allows one to clearly demonstrate the dependence of lower detection limit on such parameters as the diffusion coefficients and the concentration of electroactive substances in the membrane phase, the thickness of the diffusion layer in the sample solution, the duration of the measurement, and the composition of the internal reference solution. The results of numerical simulation are in good agreement with the experimental data presented in the literature. As all the factors of influence considered above can easily be regulated in more or less wide limits, but at the same time, an estimation of their cumulative effect is not always possible on an intuitive level, the present model can be of practical interest for justifying the ways of optimizing the design of the ISE and the algorithm for performing measurements in solving specific analytical problems.