Characterization of PAH/DPPG layer-by-layer films by VUV spectroscopy

Electronic States of Epigallocatechin-3-Gallate in Water and in 1,2-dipalmitoyl-sn-glycero-3-phospho-(1'-rac-glycerol) (Sodium Salt) Liposomes

In this work, the spectroscopy of epigallocatechin-3-gallate (EGCG) and EGCG bonded to 1,2-dipalmitoyl-sn-glycero-3-phospho-(1'-rac-glycerol) (sodium salt) (DPPG) lipid is studied both experimentally by combining high-resolution vacuum ultraviolet (VUV) photo-absorption measurements in the 4.0-9.0 eV energy range and by theoretical calculations using density functional theory (DFT) methodology. There is a good agreement between the experimental and theoretical data, and the inclusion of the solvent both implicitly and explicitly further improves this agreement. For all experimentally measured absorption bands observed in the VUV spectra of EGCG in water, assignments to the calculated electronic transitions are provided. The calculations reveal that the spectrum of DPPG-EGCG has an intense peak around 150 nm, which is in accordance with experimental data, and it is assigned to an electron transfer transition from resorcinol-pyrogallol groups to different smaller groups of the EGCG molecule. Finally, the increase in absorbance observed experimentally in the DPPG-EGCG spectrum can be associated with the interaction between the molecules.

Liposome Formulations for the Strategic Delivery of PARP1 Inhibitors: Development and Optimization

The development of a lipid nano-delivery system was attempted for three specific poly (ADP-ribose) polymerase 1 (PARP1) inhibitors: Veliparib, Rucaparib, and Niraparib. Simple lipid and dual lipid formulations with 1,2-dipalmitoyl-sn-glycero-3-phospho-rac-(1'-glycerol) sodium salt (DPPG) and 1,2-dipalmitoyl-sn-glycero-3-phosphocoline (DPPC) were developed and tested following the thin-film method. DPPG-encapsulating inhibitors presented the best fit in terms of encapsulation efficiency (>40%, translates into concentrations as high as 100 µM), zeta potential values (below -30 mV), and population distribution (single population profile). The particle size of the main population of interest was ~130 nm in diameter. Kinetic release studies showed that DPPG-encapsulating PARP1 inhibitors present slower drug release rates than liposome control samples, and complex drug release mechanisms were identified. DPPG + Veliparib/Niraparib presented a combination of diffusion-controlled and non-Fickian diffusion, while anomalous and super case II transport was verified for DPPG + Rucaparib. Spectroscopic analysis revealed that PARP1 inhibitors interact with the DPPG lipid membrane, promoting membrane water displacement from hydration centers. A preferential membrane interaction with lipid carbonyl groups was observed through hydrogen bonding, where the inhibitors' protonated amine groups may be the major players in the PARP1 inhibitor encapsulation mode.

Graphene Oxide Layer-by-Layer Films for Sensors and Devices

Layer-by-layer films of poly (allylamine hydrochloride) (PAH) and graphene oxide (GO) were characterized, looking at growth with the number of bilayers, morphology, and electrical properties. The PAH/GO films revealed a linear increase in absorbance with the increase in the number of deposited bilayers, allowing the determination that 10.7 ± 0.1 mg m-2 of GO is adsorbed per unit of area of each bilayer. GO absorption bands at 146, 210, 247 and 299 nm, assigned to π-π* and n-π* transitions in the aromatic ring (phenol) and of the carboxylic group, respectively, were characterized by vacuum ultraviolet spectroscopy. The morphological characterization of these films demonstrated that they are not completely uniform, with a bilayer thickness of 10.5 ± 0.7 nm. This study also revealed that the films are composed of GO and/or PAH/GO fibers and that GO is completely adsorbed on top of PAH. The electrical properties of the films reveal that PAH/GO films present a semiconductor behavior. In addition, a slight decrease in conduction was observed when films were prepared in the presence of visible light, likely due to the presence of oxygen and moisture that contributes to the damage of GO molecules.

In Situ AFM Imaging of Adsorption Kinetics of DPPG Liposomes: A Quantitative Analysis of Surface Roughness

The adsorption of intact liposomes on surfaces is of great importance for the development of sensors and drug delivery systems and, also, strongly dependent on the surface roughness where the liposomes are adsorbed. In this paper, we analyzed, by using atomic force microscopy in liquid, the evolution of the morphology of gold surfaces and of poly(allylamine hydrochloride) (PAH) surfaces with different roughness during the adsorption of liposomes prepared with the synthetic phospholipid 1,2-dipalmitoyl-sn-glycero-3-[phospho-rac-(1-glycerol)]. Our results reveal the following. On smooth surfaces of Au only and Au with PAH, the liposomes open and deploy on the substrate, creating a supported-lipid bilayer, with the opening process being faster on the Au/PAH surface. On rough substrates of Au coated with polyelectrolyte multilayers, the liposomes were adsorbed intact on the surface. This was corroborated by power spectral density analysis that demonstrates the presence of superstructures with an average lateral size of 43 and 87 nm, in accordance with two and four times the mean liposome hydrodynamic diameter of about 21 nm. In addition, this work presents an adequate and effective methodology for analysis of adsorption phenomena of liposomes on rough surfaces.

Distinguishment, identification and aroma compound quantification of Portuguese olive oils based on physicochemical attributes, HS-GC/MS analysis and voltammetric electronic tongue

BACKGROUND

In this paper, various extra-virgin and virgin olive oils samples from different Portuguese markets were studied. For this purpose, a voltammetric electronic tongue (VE-tongue), consisting of two kinds of working electrode within the array, together with physicochemical analysis and headspace gas chromatography coupled with mass spectrometry (HS-GC-MS), were applied. In addition, preliminary considerations of relationships between physicochemical parameters and multisensory system were reported.

RESULTS

The physicochemical parameters exhibit significant differences among the analyzed olive oil samples that define its qualities. Regarding the aroma profile, 14 volatile compounds were characterized using HS-GC-MS; among these, hex-2-enal, hexanal, acetic acid, hex-3-ene-1-ol acetate and hex-3-en-1-ol were semi-quantitatively detected as the main aroma compounds in the analyzed samples. Moreover, pattern recognition methods demonstrate the discrimination power of the proposed VE-tongue system. The results reveal the VE-tongue's ability to classify olive oil samples and to identify unknown samples based of built models. In addition, the correlation between VE-tongue and physicochemical analysis exhibits a remarkable prediction model aimed at anticipating carotenoid content.

CONCLUSION

The preliminary results of this investigation indicate that physicochemical and HS-GC-MS analysis, together with multisensory system coupled with chemometric techniques, presented a satisfactory performance regarding olive oil sample discrimination and identification. © 2017 Society of Chemical Industry.

Layer-by-layer films containing emodin or emodin encapsulated in liposomes for transdermal applications

Dermal drug release systems are an important area of research because they can be applied to the skin in a non-invasive procedure using a lower concentration of drugs. In this study, we have developed two types of Layer-by-Layer (LbL) films for releasing emodin (EM). In one system, EM was intercalated with poly(ethylenimine) PEI and poly(vinyl sufonate) (PVS) polyelectrolytes, forming (PEI/PVS)₂(PEI/EM)₇; in another, EM was incorporated in liposomes obtained by mixing dipalmitoyl phosphatidyl glycerol (DPPG) and palmitoyl oleoyl phosphatidyl glycerol (POPG) lipids, forming (PEI/PVS)₂(PEI/DPPG-POPG-EM)₇. UV-vis and FTIR spectroscopies were used to characterize the LbL films. These showed that the depositions of material by LbL were efficient, with increases in the absorbance of each bilayer evidencing the presence of EM in the film. The (PEI/PVS)₂(PEI/EM)₇ and (PEI/PVS)₂(PEI/DPPG-POPG-EM)₇ films released EM in three and five days, respectively. The cyclic voltammetry (CV) assay of the (PEI/PVS)₂(PEI/EM)₇ results are in agreement with UV-vis measurements, which suggest that EM was protonated in acid environments, while the CV of (PEI/PVS)₂(PEI/DPPG-POPG-EM)₇ demonstrated distinct protonation behaviour for EM within the inner liposome structure, even in acid solutions. Therefore, this study presents two systems based on LbL films and provides additional details about the release of EM from these films to create a viable alternative for transdermal applications.

Effects of Two Types of Melatonin-Loaded Nanocapsules with Distinct Supramolecular Structures: Polymeric (NC) and Lipid-Core Nanocapsules (LNC) on Bovine Embryo Culture Model

Melatonin has been used as a supplement in culture medium to improve the efficiency of in vitro produced mammalian embryos. Through its ability to scavenge toxic oxygen derivatives and regulate cellular mRNA levels for antioxidant enzymes, this molecule has been shown to play a protective role against damage by free radicals, to which in vitro cultured embryos are exposed during early development. In vivo and in vitro studies have been performed showing that the use of nanocapsules as active substances carriers increases stability, bioavailability and biodistribution of drugs, such as melatonin, to the cells and tissues, improving their antioxidant properties. These properties can be modulated through the manipulation of formula composition, especially in relation to the supramolecular structures of the nanocapsule core and the surface area that greatly influences drug release mechanisms in biological environments. This study aimed to evaluate the effects of two types of melatonin-loaded nanocapsules with distinct supramolecular structures, polymeric (NC) and lipid-core (LNC) nanocapsules, on in vitro cultured bovine embryos. Embryonic development, apoptosis, reactive oxygen species (ROS) production, and mRNA levels of genes involved in cell apoptosis, ROS and cell pluripotency were evaluated after supplementation of culture medium with non-encapsulated melatonin (Mel), melatonin-loaded polymeric nanocapsules (Mel-NC) and melatonin-loaded lipid-core nanocapsules (Mel-LNC) at 10⁻⁶, 10⁻⁹, and 10⁻¹² M drug concentrations. The highest hatching rate was observed in embryos treated with 10⁻⁹ M Mel-LNC. When compared to Mel and Mel-NC treatments at the same concentration (10⁻⁹ M), Mel-LNC increased embryo cell number, decreased cell apoptosis and ROS levels, down-regulated mRNA levels of BAX, CASP3, and SHC1 genes, and up-regulated mRNA levels of CAT and SOD2 genes. These findings indicate that nanoencapsulation with LNC increases the protective effects of melatonin against oxidative stress and cell apoptosis during in vitro embryo culture in bovine species.

DPPG Liposomes Adsorbed on Polymer Cushions: Effect of Roughness on Amount, Surface Composition and Topography

The adsorption of intact liposomes onto solid supports is a fundamental issue when preparing systems with encapsulated biological molecules. In this work, the adsorption kinetic of 1,2-dipalmitoyl-sn-glycero-3-[phospho-rac-(1-glycerol)] (sodium salt) liposomes onto cushions prepared from commom polyelectrolytes by the layer-by-layer technique was investigated with the main objective of finding the surface conditions leading to the adsorption of intact liposomes. For this purpose, different cushion surface roughnesses were obtained by changing the number of cushion bilayers. The adsorbed amount per unit area was measured through quartz crystal microbalance, surface morphology was characterized by atomic force microscopy, and the surface composition was assessed by X-ray photoelectron spectroscopy. The results show that (1) the amount of adsorbed lipids depends on the number of cushion bilayers, (2) the cushions are uniformly covered by the adsorbed lipids, and (3) the surface morphology of polymer cushions tunes liposome rupture and its adsorption kinetics. The fraction of ruptured liposomes, calculated from the measured amount of adsorbed lipids, is a function of surface roughness together with other surface morphology parameters, namely the dominating in-plane spatial feature size, the fractal dimension, and other textural features as well as amplitude and hybrid parameters.

Study of in situ adsorption kinetics of polyelectrolytes and liposomes using quartz crystal microbalance: Influence of experimental layout

Quartz Crystal Microbalance (QCM) is a widely used technique to characterize adsorption/desorption phenomena at the solid/liquid interface. However, the obtained adsorption/desorption kinetics curves are often not reproducible and present some noise and long term fluctuations. In this work, the accuracy of a commercial QCM to measure the adsorbed amount of polyelectrolytes and biological molecules was evaluated in terms of experimental QCM configurations with respect to quality, stability, and reproducibility of the measured data. Evaluation consisted in comparing the adsorption kinetics curves of the cationic polyelectrolyte poly(ethyleneimine) and the anionic 1,2-dipalmitoyl-sn-glycero-3-phospho-(1'-rac-glycerol) (sodium salt) liposomes, when setting the quartz crystal surface in stationary horizontal open, stationary horizontal closed, stationary vertical open, continuous vertical closed, and stationary vertical closed measuring configuration. For this last configuration, a new cell was designed and implemented. The analysis of the kinetics curves revealed that horizontal modes are more unstable when subjected to fostering noise due to the mechanical vibrations and lead to resonance frequency shift. This shift is caused by the measurement of non-adsorbed molecules which are deposited on the quartz crystal due to gravity force. The vertical modes proved to be more reproducible and reliable.