Kinetic spectrophotometric determination of certain cephalosporins in pharmaceutical formulations

Quantitative analysis of cefazolin sodium in lyophilized powder by infrared spectrophotometry: Green, low cost, fast and effective

Cefazolin sodium is a broad-spectrum antibiotic used in the treatment of infectious diseases in humans and in the surgical prophylaxis. Thus, since a considerable number of people have access to this drug, it is of great interest of quality control. The aim of this study was development and validation of a green method by Fourier-Transform Infrared (FT-IR) transmission spectrophotometry for the quantification of cefazolin sodium in lyophilized powder. This technique is widely used in the pharmaceutical industry due to its ease of execution, low cost, safety and high precision and accuracy. It has been employed in the quality control routine of numerous pharmaceuticals in order to identify them and quantify their active principles. The proposed method was completely validated according ICH guidelines, showing selectivity, accuracy, precision, robustness and linearity. It was linear over the concentration range of 0.4-1.7 mg with correlation coefficient 0.999, limits of detection and quantification of 0.017 mg and 0.052 mg, respectively, precise, accurate and robust when changes in the time, pressure and mark of potassium bromide were carried out during the preparation of the pellets. The proposed method was successfully applied to the qualitative and quantitative quality control of cefazolin sodium in lyophilized powder. In addition, the method is considered green, clean and sustainable since it uses only a single reagent; it is a fast, low-cost and environmentally friendly method.

Novel kinetic spectrophotometric method for estimation of certain biologically active phenolic sympathomimetic drugs in their bulk powders and different pharmaceutical formulations

A simple, selective and sensitive kinetic spectrophotometric method was described for estimation of four phenolic sympathomimetic drugs namely; terbutaline sulfate, fenoterol hydrobromide, isoxsuprine hydrochloride and etilefrine hydrochloride. This method is depended on the oxidation of the phenolic drugs with Folin-Ciocalteu reagent in presence of sodium carbonate. The rate of color development at 747-760nm was measured spectrophotometrically. The experimental parameters controlling the color development were fully studied and optimized. The reaction mechanism for color development was proposed. The calibration graphs for both the initial rate and fixed time methods were constructed, where linear correlations were found in the general concentration ranges of 3.65×10^-6-2.19×10^-5molL^-1 and 2-24.0μgmL^-1 with correlation coefficients in the following range 0.9992-0.9999, 0.9991-0.9998 respectively. The limits of detection and quantitation for the initial rate and fixed time methods were found to be in general concentration range 0.109-0.273, 0.363-0.910 and 0.210-0.483, 0.700-1.611μgmL^-1 respectively. The developed method was validated according to ICH and USP 30 -NF 25 guidelines. The suggested method was successfully implemented to the estimation of these drugs in their commercial pharmaceutical formulations and the recovery percentages obtained were ranged from 97.63%±1.37 to 100.17%±0.95 and 97.29%±0.74 to 100.14±0.81 for initial rate and fixed time methods respectively. The data obtained from the analysis of dosage forms were compared with those obtained by reported methods. Statistical analysis of these results indicated no significant variation in the accuracy and precision of both the proposed and reported methods.

Determination of Cephalexin Monohydrate in Pharmaceutical Dosage Form by Stability-Indicating RP-UFLC and UV Spectroscopic Methods

An ultra-fast liquid chromatographic method and two UV spectroscopic methods were developed for the determination of cephalexin monohydrate in pharmaceutical dosage forms. Isocratic separation was performed on an Enable C₁₈G column (250 mm × 4.6 mm i.d., 5 μm) using methanol:0.01 M TBAHS (50:50, v/v) as the mobile phase at a flow rate of 1.0 ml/min. The PDA detection wavelength was set at 254 nm. The UV spectroscopic method was performed at 261 nm and at 256–266 nm for the AUC method using a phosphate buffer (pH=5.5). The linearity was observed over a concentration range of 1.0–120 μg/ml for UFLC and both of the UV spectroscopic methods (correlation coefficient=0.999). The developed methods were validated according to ICH guidelines. The relative standard deviation values for the intraday and interday precision studies were < 2%, and the accuracy was > 99% for all of the three methods. The developed methods were used successfully for the determination of cephalexin in dry syrup formulation.

Development and validation of a successful microbiological agar assay for determination of ceftriaxone sodium in powder for injectable solution

Ceftriaxone sodium is a cephalosporin with broad-spectrum antimicrobial activity and belongs to the third generation of cephalosporins. Regarding the quality control of medicines, a validated microbiological assay for the determination of ceftriaxone sodium in powder for injectable solution has not been reported yet. This paper reports the development and validation of a simple, accurate and reproducible agar diffusion method to quantify ceftriaxone sodium in powder for injectable solution. The assay is based on the inhibitory effect of ceftriaxone sodium on the strain of Bacillus subtilis ATCC 9371 IAL 1027 used as test microorganism. The results were treated statistically by analysis of variance and were found to be linear (r = 0.999) in the selected range of 15.0-60.0 μg/mL, precise with a relative standard deviation (RSD) of repeatability intraday = 1.40%, accurate (100.46%) and robust with a RSD lower than 1.28%. The results demonstrated the validity of the proposed bioassay, which allows reliable ceftriaxone sodium quantitation in pharmaceutical samples and therefore can be used as a useful alternative methodology for the routine quality control of this medicine.