Relationship between the Apical Preparation Diameter and the Apical Seal: An In Vitro Study

The Effect of Different Obturation Techniques in Primary Teeth on the Apical Microleakage using Endoflas: A Comparative In Vitro Study

Objectives

This study was carried out to quantitatively evaluate and compare the sealing ability of Endoflas by using different obturation techniques.

Materials and Methods

After 42 extracted primary maxillary incisors and canines were decoronated, their canals were instrumented with K files of size ranging from #15 to #50. In accordance with the obturation technique, the samples were divided into three experimental groups, namely, group I: endodontic pressure syringe, group II: modified disposable syringe, and group III: reamer technique, and two control groups. Dye extraction method was used for leakage evaluation. Data were analyzed using one-way ANOVA and Dunnett's T3 post hoc tests. The level of significance was set at p < 0.05.

Results

Endodontic pressure syringe had significantly less leakage than the modified disposable syringe and reamer techniques (p < 0.05). Meanwhile, no significant difference was found in the mean leakage between the modified disposable syringe and the reamer techniques.

Conclusion

Amongst all the techniques used in this study, endodontic pressure syringe could be preferred as an obturation technique in primary teeth when used with Endoflas obturation material because of its potential to provide good apical seal.

Analysis of Instrumentation Protocols Regarding the Quality of Mesial Canal Preparation in Mandibular Molars: A Micro-computed Tomographic Study

INTRODUCTION

This study aimed to use micro-computed tomographic imaging to analyze the quality of the endodontic preparation of mesial canals in mandibular molars provided by 3 instrumentation protocols.

METHODS

Forty-five extracted mandibular molars with 2 independent mesial canals were selected, and the initial micro-computed tomographic imaging was performed. The initial volume values of the canals were submitted to statistical analysis for paired division. The groups were determined according to the final enlargement of the canal and the working length adopted (ie, G25.06/+1 mm, G35.05/foramen, and G50.01/-1 mm). At the end of each instrumentation sequence, the root canals were scanned and analyzed with regard to the increase in the total and apical volume, centralization, and preparation transportation and the percentage of the total and apical uninstrumented walls.

RESULTS

For the intragroup comparison, the Wilcoxon test was used, and for the intergroup analysis, the Kruskal-Wallis and Dunn tests were used (P < .05). In the analysis of the canal total volume, a statistical difference was found between G25.06/+1 mm and the remaining groups (P < .05). In the apical third, a statistical difference was observed between G25.06/+1 mm and G50.01/-1 mm (P < .05). No statistical difference was found between the groups in terms of centralization and transportation of the preparation or in terms of the percentage of the total or apical uninstrumented walls.

CONCLUSIONS

The preparation of the mesial canals of mandibular molars up to larger tip files but with a lower taper at 1 mm before the foramen resulted in a larger volume of apical preparation, kept the preparation centralized, and provided safe apical dentin wear without excessive cervical wear.

In vitro Interrelationship between Apical Fill and Apical Leakage Using Three Different Obturation Techniques

AIM AND OBJECTIVES

To evaluate the apical fill in relation to apical leakage using three different obturating techniques - Single Cone, Ultrafil 3D, and lateral condensation.

MATERIALS AND METHODS

Sixty-six mandibular single-rooted premolar teeth were selected and were randomly assigned into three different groups of obturating techniques. The canals were prepared using 0.4/25 HyFlex CM (Coltene Endo) rotary system file and obturated with corresponding HyFlex CM Single Cone, Ultrafil 3D injectable technique, and lateral condensation. AH Plus (Dentsply, Detrey) has been used as the sealer. Twenty teeth each were assigned to the three experimental groups, and six teeth were used as positive and negative controls (3 in each group). Fluid filtration technique was used to determine the amount of apical leakage. The evaluation was done for 8 min at the interval of every 2 min. The same teeth were sectioned and a spectroscopic examination was done at 2 mm and 4 mm distance from the apices. The obtained data were statistically analyzed using analysis of variance test followed by post hoc turkeys test for multiple comparisons.

RESULTS

The mean apical leakage was maximum for lateral condensation when compared to the Single Cone and Ultrafil 3D. The amount of apical fill at 2 mm and at 4 mm was found to be more in the Single Cone than the other two techniques.

CONCLUSION

The present study concluded that Single Cone obturation technique exhibited more gutta-percha filled area in the canal which led to decreased apical leakage than Ultrafil 3D and lateral condensation techniques, proving to be more effective in achieving a complete three-dimensional apical seal.