Development and Utilization of 3D Printed Material for Thoracotomy Simulation

Use of Low-Cost Task Trainer for Emergency Department Thoracotomy Training in General Surgery Residency Program

OBJECTIVE

Emergency department thoracotomy (EDT) is an uncommon but potentially lifesaving procedure that warrants familiarity with anatomy, instruments, and indications necessary for completion. To address this need, we developed a low-cost EDT trainer. The primary objective of this study was to compare the effectiveness of a low-cost EDT trainer to teach emergency department thoracotomy with a discussion-based teaching session. Secondary objective was to study the face validity of the low-cost EDT trainer.

DESIGN

A prospective 2-phase randomized control study was conducted. Participants were randomly divided into two groups. In phase one, baseline medical knowledge for both groups was assessed using a multiple-choice question pretest. In Group 1, each participant was taught EDT using a one-on-one discussion with a trauma surgeon, whereas Group 2 used the EDT trainer and debriefing for training. In phase 2 (1 month later), all participants completed a knowledge retention test and performed a videoed EDT using our EDT trainer, the video recordings were later reviewed by content experts blinded to the study participants using a checklist with a maximum score of 22. The participants also completed a reaction survey at the end of phase 2 of the study.

SETTING

OhioHealth Riverside Methodist Hospital, an urban tertiary care academic hospital in Columbus, Ohio.

PARTICIPANTS

Nine senior surgery residents from training years 3 to 5.

RESULTS

The mean score for the performance of the procedure for the simulation-based (Group 2) was significantly higher than that of the discussion-based (Group 1) (Rater 1: 21.2 ± 0.8 vs. 19.0 ± 2.0, p = 0.05, Rater 2: 20.4 ± 1.5 vs. 18.3±1.0, p = 0.04). Group 2 also was quicker than Group 1 in deciding to start the procedure by approximately 56 seconds. When comparing the mean pretest knowledge score to the mean knowledge retention score 30 days after training, the discussion-based group improved from 58.33% to 81.25% (p = 0.01); the simulation-trained group's scores remained at 68.33%. All the participants agreed or strongly agreed that the simulator provided a realistic opportunity to perform EDT and improved their confidence.

CONCLUSIONS

The results of this pilot study support our hypothesis that using a low-cost EDT trainer effectively improves general surgery residents' confidence and procedural skills scores in a simulated environment. Further training with low-cost simulators may provide surgical residents with deliberate practice opportunities and improve performance when learning low-frequency procedures.

Needs Assessment for a Resuscitative Thoracotomy Curriculum for General Surgery Residents in the Northeast Region

INTRODUCTION

Resuscitative thoracotomy (RT) is a high-acuity low occurrence (HALO) procedure with which general surgical resident (GSR) experience and confidence are unknown. We sought to identify and describe this educational gap by conducting a targeted needs assessment for an RT curriculum for GSRs.

METHODS

An online regional needs assessment survey was conducted for an RT curriculum for GSRs. The survey was developed by a group of trauma stakeholders and revised after being piloted on a small, representative group of GSRs. We surveyed GSRs in the Northeast region regarding their experience and confidence with RT; interest in an RT curriculum; and content, format, and scope for an RT curriculum.

RESULTS

The survey response rate was 43%, reflecting the viewpoints of GSRs at 8 major training centers across the Northeast. Only 13% of respondents were interested in pursuing a career in Trauma and Critical Care despite 97% of them training at a Level I Trauma Center. Twenty-nine percent and 33% of GSRs had ever assisted with or performed RT, respectively. Twenty-one percent of GSRs reported feeling confident performing RT. Most respondents (98%) agreed or strongly agreed that an RT curriculum would add value to their general surgery education. The most positively rated content topics were resuscitative maneuvers (100% positive responses [PR]), when to cease resuscitative efforts (100% PR), and morbidity and mortality associated with RT (98% PR). The most highly rated learning methods were individual RT simulation time (97% PR) and a tour of the trauma bay equipment (97% PR).

CONCLUSIONS

This needs assessment demonstrates a lack of experience and confidence with RT, a strong learner interest in an RT curriculum, and a desire for experiential learning methods. Learning objectives are defined herein, and the next steps involve developing educational materials for an RT curriculum for GSRs.

Development of a Gastight Thoracotomy Model for Investigation of Carbon Dioxide Field-Flooding Efficacy

Carbon dioxide (CO₂) field-flooding during cardiac surgery is a prevention technique to avoid blood-air contact and subsequent embolization. Although it was first used more than 60 years ago, there is still some perplexity around its efficacy, mainly because the gas is invisible and air embolization is difficult to quantify.

An accurate assessment of field-flooding can, therefore, best be performed in models where various methods can be tried in a controlled environment and evaluated with industrial-grade sensors. Multiple options are available for anatomically correct models that reproduce a sternotomy situation, but models for minimally invasive cardiac surgery are expensive and normally meant for training of surgical techniques where only the top side of the model is important.

We created a low-cost and “home-made” gastight mini-thoracotomy model with internal organs and left atrial incision to investigate CO₂ insufflation in a simulated minimally invasive mitral valve surgery. The model was validated with CO₂ field-flooding tests with a commercial diffuser, while three sensors continuously registered the local concentration of CO₂ gas.

3D printing in critical care: a narrative review

BACKGROUND

3D printing (3DP) has gained interest in many fields of medicine including cardiology, plastic surgery, and urology due to its versatility, convenience, and low cost. However, critical care medicine, which is abundant with high acuity yet infrequent procedures, has not embraced 3DP as much as others. The discrepancy between the possible training or therapeutic uses of 3DP in critical care and what is currently utilized in other fields needs to be addressed.

OBJECTIVE

This narrative literature review describes the uses of 3DP in critical care that have been documented. It also discusses possible future directions based on recent technological advances.

METHODS

A literature search on PubMed was performed using keywords and Mesh terms for 3DP, critical care, and critical care skills.

RESULTS

Our search found that 3DP use in critical care fell under the major categories of medical education (23 papers), patient care (4 papers) and clinical equipment modification (4 papers). Medical education showed the use of 3DP in bronchoscopy, congenital heart disease, cricothyroidotomy, and medical imaging. On the other hand, patient care papers discussed 3DP use in wound care, personalized splints, and patient monitoring. Clinical equipment modification papers reported the use of 3DP to modify stethoscopes and laryngoscopes to improve their performance. Notably, we found that only 13 of the 31 papers were directly produced or studied by critical care physicians.

CONCLUSION

The papers discussed provide examples of the possible utilities of 3DP in critical care. The relative scarcity of papers produced by critical care physicians may indicate barriers to 3DP implementation. However, technological advances such as point-of-care 3DP tools and the increased demand for 3DP during the recent COVID-19 pandemic may change 3DP implementation across the critical care field.

Creation and Implementation of a Mastery Learning Curriculum for Emergency Department Thoracotomy

Introduction

Emergency department thoracotomy (EDT) is a lifesaving procedure within the scope of practice of emergency physicians. Because EDT is infrequently performed, emergency medicine (EM) residents lack opportunities to develop procedural competency. There is no current mastery learning curriculum for residents to learn EDT. The purpose of this study was to develop and implement a simulation-based mastery learning curriculum to teach and assess EM residents’ performance of the EDT.

Methods

We developed an EDT curriculum using a mastery learning framework. The minimum passing standard (MPS) for a previously developed 22-item checklist was determined using the Mastery Angoff approach. EM residents at a four-year academic EM residency program underwent baseline testing in performing an EDT on a simulation trainer. Performance was scored by two raters using the checklist. Learners then participated in a novel mastery learning EDT curriculum that included an educational video, hands-on instruction, and deliberate practice. After a three-month period, residents then completed initial post testing. Residents who did not meet the minimum passing standard after post testing participated in additional deliberate practice until mastery was obtained. Baseline and post-test scores, and time to completion of the procedure were compared with paired t-tests.

Results

Of 56 eligible EM residents, 54 completed baseline testing. Fifty-two residents completed post-testing until mastery was reached. The minimum passing standard was 91.1%, (21/22 items correct on the checklist). No participants met the MPS at the baseline assessment. After completion of the curriculum, all residents subsequently reached the MPS, with deliberate practice sessions not exceeding 40 minutes. Scores from baseline testing to post-testing significantly improved across all postgraduate years from a mean score of 10.2/22 to 21.4/22 (p <0.001). Mean time to complete the procedure improved from baseline testing (6 minutes [min] and 21 seconds [sec], interquartile range [IQR] = 4 min 54 sec - 7 min 51 sec) to post-testing (5 min 19 seconds, interquartile range 4 min 17sec - 6 min 15 sec; p = 0.001).

Conclusion

This simulation-based mastery learning curriculum resulted in all residents performing an EDT at a level that met or exceeded the MPS with an overall decrease in time needed to perform the procedure.