Application of a Metal Cobalt Based on 4,6-Bis(imidazol-1-yl)isophthalicacid Metal-Organic -Framework Materials in Photocatalytic CO2 Reduction, Antibacterial, and Dye Adsorption

In this paper, the reported MOF ([Co(bimip)(H2O)0.5]·0.5H2O) was employed in photocatalytic CO2 reduction, antibacterial, and dye adsorption experiments. The photocatalytic activity of the MOF for CO2 reduction was systematically investigated. The high average CO generation rate of 3421.59 μmol·g-1·h-1 after 12 h confirms the efficient photocatalytic CO2 reduction ability of the MOF. At the same time, the MOF can completely inhibit the growth of S. aureus and C. albicans within 24 h when its concentration reaches 400 μg/mL and 500 μg/mL, respectively. The MOF has an adsorption capacity for CR. The adsorption rate was 83.42% at 60 min, and the adsorption capacity of the MOF for CR reached 500.00 mg·g-1.

Tailoring confined CdS quantum dots in polysulfone membrane for efficiently durable performance in solar-driven wastewater remediating systems

In this work, CdS quantum dots (QDs) were successfully confined in polysulfone membrane (PSM) to develop a photoactive membrane under solar illumination that was suited in wastewater remediating system. The CdS@PSM membranes were prepared using the nonsolvent induced phase separation (NIPS) approach. Optical measurements show the confinement of CdS quantum dots (QDs) in the PS matrix within the narrowest band gap (2.41 eV) at 5 wt% loading. PS has two strong emission peaks at 411 and 432 nm due to photoelectron-hole recombination on pure PSM's surface. Adding 1 wt% CdS QDs to PSM reduced the earlier peak and blue-shifted the latter, within the appearance of three emission peaks attributed to the near band-edge emission of confined CdS QDs. Overloading CdS reduced all emission peaks. Moreover, fluorimetric monitoring of ^•OH radicals indicates that PSM produces the least amount of photogenerated ^•OH radicals while CdS@PSM(5 wt%) achieved the highest productivity. Examining the developed membranes in detoxifying methylene blue (MB) from aqueous solution of natural pH 8.1 showed weak adsorption in dark over 90 min of contact while switching to solar illumination significantly photodegrade MB where the degradation efficiency starts from 49% for pure PSM to 79% for CdS@PSM(5 wt%). Influence of pH was found crucial on photodegradation efficacy. Acidic pH 3 showed the weakest photodegradation efficacy, while the alkaline pH 12 was 18.88 times more effective. The used CdS@PSM (5 wt%) was successfully photo-renovated by soaking in 10 mL of NaOH solution under Solar illumination for 15 min to be used in 4 consecutive photodegradation cycles with insignificant decrease in efficacy. These findings are promising and could lead to a high-efficiency, sustainable photocatalytic suite.

Hybrid solvothermal/sonochemical-mediated synthesis of ZnO NPs generative of OH radicals: Photoluminescent approach to evaluate OH scavenging activity of Egyptian and Yemeni Punica granatum arils extract

Zinc oxide NPs were synthesized solvothermally within sonochemical mediation and characterized by XRD, FTIR, SEM, EDX, elemental mapping, TEM and UV-vis. spectrophotometry. To evaluate the hydroxyl radicals (OH) scavenging activity of arils extract of Egyptian (EGY-PAM) and Yemeni Punica granatum (YEM-PAM), the developed zinc oxide nano particles (ZnO NPs) as a highly productive source of hydroxyl radicals (under Solar-illumination) was used. The yield of OH was trapped and probed via fluorimetric monitoring. This suits the first sensitive/selective photoluminescent avenue to evaluate the OH scavenging activity. The high percentage of DPPH radical scavenging reflected higher contents of phenolics, flavonoids, and anthocyanins that were found in EGY-PAM and YEM-PAM. Although, some secondary metabolites contents were significantly different in EGY-PAM and YEM-PAM, the traditional DPPH radical scavenging methodology revealed insignificant IC50. Unlike, the developed fluorimetric probing, sensitively discriminated the OH scavenging activity with IC50 (105.7 µg/mL) and lower rate of OH productivity (k = 0.031 min-1) in case of EGY-PAM in comparison to IC50 (153.4 µg/mL) and higher rate of OH productivity (k = 0.053 min-1) for YEM-PAM. Our findings are interestingly superior to the TBHQ that is synthetic antioxidant. Moreover, our developed methodology for fluorimetric probing of OH radicals scavenging, recommends EGY-PAM as OH radicals scavenger for diabetic patients while YEM-PAM exhibited a better OH radicals scavenging appropriate for high blood pressure patients. More interestingly, EGY-PAM and YEM-PAM exhibited high anticancer potentiality. The aforementioned OH and DPPH scavenging activities as well as the anticancer potentiality present EGY-PAM and YEM-PAM as promising sources of natural antioxidants, that may have crucial roles in some chronic diseases such as diabetics and hypertension in addition to cancer therapeutic protocols.

Synthesis and characterization of chitosan/polyacrylamide hydrogel grafted poly(N-methylaniline) for methyl red removal

Chitosan/polyacrylamide hydrogel grafted poly(N-methylaniline) (CS/PACM-gr-PNMA) was good synthesized by chemical oxidative radical polymerization using potassium persulphate (KPS). The obtained polymer samples are characterized using IR and Uv-visible spectroscopy. Both surface properties and thermal stability were studied using XRD, SEM, BET and TGA techniques respectively. The characterized polymeric samples were used as a new sorbent for methyl red (MR). MR as an example of azo-dyes presence as pollutants in industrial wastewater which cause physiological damages was chosen to uptake. The influence of contact time, adsorbent dose, and temperature on the efficiency of CS/PACM-gr-PNMA towards the removal of MR was investigated. The efficacy was equal to 98% through 120 min at room temperature. The obtained data show that, ∆H = -21.478 kJ mol^-1, so adsorption process is physically spontaneous and follow Freundlich isotherm. The sorption process of MR on the surface of CS/PACM-gr-PNMA is proceed via the Lagergren pseudo-second order reaction. This confirms the removal mechanism by both chemical and physical adsorption of MR with both unpaired and π electrons present in polymer structure on NH, NH_2, and benzene or quinoid units respectively. In addition, it can explain the chemical adsorption type which occurs through sharing between the used adsorbent materials and the dissolved materials beside the physical adsorption.