[Predictive factors of aseptic loosening of cemented total hip prostheses]

Poor success rates with double pelvic osteotomy for craniodorsal luxation of total hip prosthesis in 11 dogs

OBJECTIVE

To report the outcome of double pelvic osteotomy (DPO) for craniodorsal luxation of total hip replacement (THR).

STUDY DESIGN

Retrospective case series.

ANIMALS

Eleven client-owned animals.

METHODS

Dogs with craniodorsal luxation of THR and high angle of lateral opening (ALO) were considered candidates for DPO. The ALO and the version angle (VA) were measured on pre- and post-DPO radiographs. Pre- and post-DPO ALO and VA were compared using a Wilcoxon signed-rank test. Clinical and radiographic outcomes were assessed at 2 and 6 months post-DPO.

RESULTS

Eleven DPOs were performed on 11 dogs after THR luxation. The ALO was reduced from a median of 66.2° (range 37.3-73.1°) to 55.9° (range 13.2-60.0°) (p ≤ .001), and VA increased from a median of 25.6° (range 6.8-51.9°) to 35.3° (range 15.1-51.7°) (p ≤ .03). Craniodorsal luxation recurred in five dogs and was managed with closed reduction (one dog), capsulorrhaphy (one dog), or repositioning of the acetabular cup (three dogs). The median clinical follow-up duration was 19.7 months (range 3.4-73.0). In the long term, seven dogs required explantation (five aseptic loosenings, two infections) (median 8.2 months, range 2.6-50.6).

CONCLUSION

Reluxation was frequent after DPO, 5/11 dogs requiring additional procedures, including three cup revisions. The long-term outcome was considered to be poor due to frequent explantation.

CLINICAL SIGNIFICANCE

Double pelvic osteotomy may be considered to avoid cup replacement when managing craniodorsal THR luxations in dogs but is not recommended due to high complication rates.

Low-Molecular-Weight Heparins (LMWH) and Synthetic Factor X Inhibitors Can Impair the Osseointegration Process of a Titanium Implant in an Interventional Animal Study

Background and objectives: Cementless total hip arthroplasty is a common surgical procedure and perioperative thromboprophylaxis is used to prevent deep vein thrombosis or pulmonary embolism. Osseointegration is important for long-term implant survival, and there is no research on the effect of different thromboprophylaxis agents on the process of osseointegration. Materials and Methods: Seventy rats were allocated as follows: Group I (control group), Group II (enoxaparin), Group III (nadroparin), and Group IV (fondaparinux). Ovariectomy was performed on all subjects, followed by the introduction of an intramedullary titanium implant into the femur. Thromboprophylaxis was administered accordingly to each treatment group for 35 days postoperatively. Results: Group I had statistically significantly lower anti-Xa levels compared to treatment groups. Micro-CT analysis showed that nadroparin had lower values compared to control in bone volume (0.12 vs. 0.21, p = 0.01) and percent bone volume (1.46 vs. 1.93, p = 0.047). The pull-out test showed statistically significant differences between the control group (8.81 N) compared to enoxaparin, nadroparin, and fondaparinux groups (4.53 N, 4 N and 4.07 N, respectively). Nadroparin had a lower histological cortical bone tissue and a higher width of fibrous tissue (27.49 μm and 86.9 μm) at the peri-implant area, compared to control (43.2 μm and 39.2 μm), enoxaparin (39.6 μm and 24 μm), and fondaparinux (36.2 μm and 32.7 μm). Conclusions: Short-term administration of enoxaparin, nadroparin, and fondaparinux can reduce the osseointegration of titanium implants, with nadroparin having the most negative effect. These results show that enoxaparin and fondaparinux are preferred to be administered due to a lesser negative impact on the initial implant fixation.

Pulsatile Lavage Systems with High Impact Pressure and High Flow Produce Cleaner Cancellous Bone Prior to Cementation in Cemented Arthroplasty

In cemented joint arthroplasty, state-of-the-art cementing techniques include high-pressure pulsatile saline lavage prior to cementation. Even with its outstanding importance in cementation, there are surprisingly few studies regarding the physical parameters that define pulsatile lavage systems. To investigate the parameters of impact pressure, flow rate, frequency and the cleaning effect in cancellous bone, we established a standardized laboratory model. Standardized fat-filled carbon foam specimens representing human cancellous bone were cleaned with three different high-pressure pulsatile lavage systems. Via CT scans before and after cleaning, the cleaning effect was evaluated. All systems showed a cleaning depth of at least 3.0 mm and therefore can be generally recommended to clean cancellous bone in cemented joint arthroplasty. When comparing the three lavage systems, the study showed significant differences regarding cleaning depths and volume, with one system being superior to its peer systems. Regarding the physical parameters, high impact pressure in combination with high flow rate and longer distance to the flushed object seems to be the best combination to improve the cleaning of cancellous bone and therefore increase the chances of a deeper cement penetration that is required in cemented joint arthroplasty. In summary, this study provides the first standardized comparison of different lavage systems and thus gives initial guidance on how to optimally prepare cancellous bone for cemented joint arthroplasty.

Does Additive Pressurized Carbon Dioxide Lavage Improve Cement Penetration and Bond Strength in Cemented Arthroplasty?

The modern cementing technique in cemented arthroplasty is a highly standardized and, therefore, safe procedure. Nevertheless, aseptic loosening is still the main reason for revision after cemented total knee or cemented total hip arthroplasty. To investigate whether an additional carbon dioxide lavage after a high-pressure pulsatile saline lavage has a positive effect on the bone-cement interface or cement penetration, we set up a standardized laboratory experiment with 28 human femoral heads. After a standardized cleaning procedure, the test implants were cemented onto the cancellous bone. Subsequently, the maximum failure load of the bone-cement interface was determined using a material testing machine to pull off the implant, and the cement penetration was determined using computed tomography. Neither the maximum failure load nor cement penetration into the cancellous bone revealed significant differences between the groups. In conclusion, according to our experiments, the additive use of the carbon dioxide lavage after the high-pressure pulsatile lavage has no additional benefit for the cleaning of the cancellous bone and, therefore, cannot be recommended without restrictions.