Simultaneous Burst Imaging of Dual Species Using Planar Laser-Induced Fluorescence at 50 kHz in Turbulent Premixed Flames

Simultaneous single-shot imaging of H and O atoms in premixed turbulent flames using femtosecond two-photon laser-induced fluorescence

A method based on femtosecond two-photon excitation has been developed for simultaneous visualization of interference-free fluorescence of H and O atoms in turbulent flames. This work shows pioneering results on single-shot simultaneous imaging of these radicals under non-stationary flame conditions. The fluorescence signal, showing the distribution of H and O radicals in premixed CH₄/O₂ flames was investigated for equivalence ratios ranging from ϕ = 0.8 to ϕ = 1.3. The images have been quantified through calibration measurements and indicate single-shot detection limits on the order of a few percent. Experimental profiles have also been compared with profiles from flame simulations, showing similar trends.

10 kHz simultaneous PIV/PLIF study of the diffusion flame response to periodic acoustic forcing

Response of a laminar diffusion dimethyl-ether flame forced by an acoustic field is provided. A forcing frequency of 100 Hz, which is chosen based on the typical thermo-acoustic instability frequency in a practical combustor, is applied to the flame at a Reynolds number of 250. The development of the forced vortical structures present in this flame has been investigated utilizing a burst mode laser with a repetition rate of 10 kHz. Flame/vortex interaction is visualized by planar laser-induced fluorescence (PLIF) of formaldehyde, which is used to identify the early-stage fuel decomposition in the flame. The flame structure is also correlated with the velocity field, which is obtained utilizing particle imaging velocimetry (PIV). The resulting phase-resolved and time-averaged velocity and vortex images indicate that the amplitude of excitation has pronounced effects on the flame via modifying the local heat release.

Burst-mode OH/CH2O planar laser-induced fluorescence imaging of the heat release zone in an unsteady flame

The paper presents simultaneous high-speed (7.5 kHz) planar laser-induced fluorescence (PLIF) of formaldehyde (CH₂O) and the hydroxyl-radical (OH) for visualization of the flame structure and heat release zone in a non-premixed unsteady CH₄/O₂/N₂ flame. For this purpose, a dye laser designed for high-speed operation is pumped by the second-harmonic 532 nm output of a Nd:YAG burst-mode laser to produce a tunable, 566 nm beam. After frequency doubling a high-energy kHz-rate narrowband pulse train of approximately 2.2 mJ/pulse at 283 nm is used for excitation of the OH radical. Simultaneously, CH₂O is excited by the frequency-tripled output of the same Nd:YAG laser, providing a high-frequency pulse train over 10 ms in duration at high pulse energies (>100 mJ/pulse). The excitation energies enable signal-to-noise ratios (SNRs) of ~10 and ~60 for CH₂O and OH PLIF, respectively, using a single high-speed intensified CMOS camera equipped with an image doubler. This allows sufficient SNR for investigation of the temporal evolution of the primary heat release zone and the local flame structure at kHz rates from the spatial overlap of the OH- and CH₂O-PLIF signals.

Compact burst-mode Nd:YAG laser for kHz-MHz bandwidth velocity and species measurements

A compact-footprint (0.18  m²) flash-lamp-pumped, burst-mode Nd:YAG-based master-oscillator pulsed-amplifier laser is reported with a fundamental 1064 nm output of over 14 J per burst. A directly modulated diode laser seed source is used to generate 10 ms duration arbitrary sequences of 500 kHz doublet or MHz singlet pulses for flow-field velocity or species measurements, respectively. Flexible pulse widths are used to balance the energy distribution of pulse doublets and achieve second-harmonic conversion efficiencies up to 42%. Burst-mode laser performance characteristics, measurement accuracies in turbulent flows, and prospects for kHz-MHz flow-field diagnostics are discussed.

Ultra-high-speed PLIF imaging for simultaneous visualization of multiple species in turbulent flames

In order to obtain more detailed characteristics and information in highly turbulent flames, for a better understanding of the transient behavior of eddies in such flames, a measurement technique with sufficient temporal resolution is requested. However, the probing of species distributions relevant in combustion (e.g. OH, CH₂O) with ultra-high-speed laser diagnostics still remains a challenge. Nd:YAG clusters commercially available can generate only 4-8 pulses, although with high laser energy. Systems based on a diode-pumped solid-state Nd:YAG laser combined with a dye laser produce only about 100 μJ pulse energy at ultra-high repetition rates (≥50 kHz). Even more comprehensive information on the flame structure can be gained if simultaneous recording of multi-species is performed. In the present work, the development of the first ultra-high-speed diagnostic technique capable of simultaneous probing of hydroxyl radicals and formaldehyde distributions at a repetition rate of 50 kHz is outlined. This has been achieved by employing a burst laser pumped optical parametric oscillator system for the simultaneous detection of CH₂O excited at 355 nm and OH-radicals excited at 283 nm, where the interference of scattering laser light can be avoided. The applicability of the proposed technique was demonstrated in a highly turbulent jet flame. Moreover, the presented improvement in terms of the number of consecutive images recorded with ultra-high-speed planar laser induced fluorescence imaging is significant. Due to the high temporal resolution, the movement of CH₂O pocket enclosed by OH at the flame tip can be clearly captured. The transport velocity of the CH₂O pocket was calculated and found to be in good agreement with previous LDV results.