Distribution law of floor stress during mining of the upper protective coal seam

Study on Overburden Movement and Fissure Evolution Law of Protective Layer Mining in Shallow Coal Seam

This study aims to effectively solve the problem of the destruction of the coal roof and floor overlying rock after mining the protective layer, and determines whether the gas in the protected layer can be effectively released. We do this based on the engineering background of the Weng’an Coal Mine; research and analysis of the movement of the roof and floor overlying rocks; the evolution of cracks and the pressure relief characteristics of the protected layer after mining the protective layer; and through theoretical analysis and similar simulation experiments. Through numerical simulation, it was found that the protected layer was depressurized due to the mining of the protective layer, and the decompression rate of the protected layer was 0.2–0.8. In addition, the overall expansion rate of the protected layer was greater than the requirements of the “Detailed Rules for Prevention and Control of Coal and Gas Outbursts” for coal mines, and the investigation of the residual gas pressure and content of the protected layer revealed that the protected coal seam had been mined in the upper protective layer coal face. The gas pressure dropped to 50.7% of the original coal seam gas pressure, the rate of decrease was 49.3%, the residual gas content dropped by 68.67%, and the gas concentration in the return airway was 0.31% on average, meeting the national regulations that require its value to be less than or equal to 1%. The study comprehensively demonstrates that mining of the protective layer is beneficial to the release of gas from the protected layer, and provides a practical reference for coal and gas outbursts in mines.

The pressure relief protection effect of different strip widths, dip angles and pillar widths of an underside protective seam

To design underside protective seam strip layout. Similarity model experiments, numerical simulations and theoretical calculations are used to quantitatively study the pressure relief protection effect of different strip widths, dip angles and coal pillar widths of a thin underside protective seam under deeply buried conditions. The optimal strip width range is obtained according to the change law of strain during the mining process of the underside protective seam in a similar model experiment. The change law of the expansion of the protected coal seam is obtained and the fitting surfaces among the dip angle and strip width of the coal seam with the protection distance and pressure relief angle along the strike and dip of the protected coal seam are established according to the numerical simulation results of underside protective seam mining. It is concluded that the best pressure relief effect can be achieved when the dip angle is 16.7° and the strip width is 70 m. According to the stability threshold of coal pillars considered in strip mining theory, the coal pillar width is calculated to be 50 m. Similarity model experiments and numerical simulations of protected coal seam mining verify the pressure relief effect of the designed protective seam strip width and pillar width. A calculation method of the protective seam strip width, position and pillar width required by the specific width of the protected seam is proposed.