An experimental study on foaming of linear low-density polyethylene/high-density polyethylene blends

In this research work, foaming behavior of selected polyethylene blends was studied in a solid-state batch process, using CO2 as the blowing agent. Special emphasis was paid towards finding a relationship between foamability and thermal and rheological properties of blends. Pure high-density polyethylene, linear low-density polyethylene, and their blends with two weight fraction levels of high-density polyethylene (10 and 25%wt.) were examined. The dry blended batches were mixed using an internal mixer in a molten state, and then the disk-shaped specimens, 1.8 mm in thickness, were produced for foaming purposes. The foaming step was conducted over a wide range of temperatures (120–170℃), and the overall expansion and cellular morphology were evaluated via density measurements and captured SEM micrographs, respectively. Three-dimensional structural images were also captured using a high resolution X-ray micro CT for different foamed samples and were compared. Rheological and DSC tests for the virgin and blends were also performed to seek for a possible correlation with the formability. Based on the results, blended polyethylene foams exhibited remarkable expansion and highly enhanced cell structure compared to pure polymers. Bulk density, as low as 0.33 g/cm3, was obtained for blends, while for the virgin high-density polyethylene  and linear low-density polyethylene, bulk density lower than 0.5 g/cm3 was not attainable. The lowest density was observed at a foaming temperature of 10–20℃ above the melting (peak) temperature obtained via DSC test. Rheological characteristics, including storage modulus and cross-over frequency value, were also found to be the indicators for the materials foaming behavior. Moreover, blends with 25% wt. of high-density polyethylene exhibited the highest expansion values over a wider range of temperature compared with 90% linear low-density polyethylene/10% high-density polyethylene.

Effect of the skin layer on the overall behavior of closed-cell polyethylene foam sheets

This article presents an experimental investigation of the effect of the skin layer on the mechanical behavior of a closed-cell polymeric foam material. The skin layer is a thin layer with increased density due to the manufacturing processes, which results in inhomogeneity. The skin-layer effect is investigated by comparing the stretch-stress characteristics of specimens with and without this skin layer on a particular closed-cell polyethylene foam sheet. The characteristics were recorded via uniaxial tension and compression tests, respectively, in all principal manufacturing directions. Thus, the skin-layer effect can be obtained by analyzing the recorded data points, which are also presented. The skin-layer-free specimens are prepared with a particularly designed assembly in accordance with the ASTM standards.