Physical and chemical stability of cytarabine in polypropylene syringes

An analysis of the effect of syringe barrel volume on performance and user perception

In the market, there are many types and shapes of syringes. One of the groupings of syringe types is based on barrel volume. The shape of the product design affects performance and user perception. The aim of this study is to investigate the effect of barrel volume on its performance and user perception. We performed analysis following international organization for standardization 7886 procedures on syringe with 1 mL, 3 mL, 5 mL, and 10 mL volume. In addition, a user perception test was conducted on 29 respondents using a questionnaire with the Likert chart method. This study indicates that the bigger the syringe volume, the larger the dead space and the force to operate the piston are. A larger syringe volume also raises the volume that changes due to the plunger position increase. Meanwhile, the barrel volume does not affect water and water leakage, as we did not observe any leak during the syringe tests in our experiment. In addition, the user perception test shows that the barrel's length influences the ease of device control during the injection. The volume of the barrel negatively correlated with its effect to the environment. The safety features of all syringes are similar except for the 3 mL syringe, which has a value of 0.1 points difference to other syringes.

The hypodermic syringe performance based on the ISO 7886-1:2017: A narrative review

A syringe is used to inject fluid or medicine into the patient's soft tissue. The main components of the syringe were the needle, barrel, and plunger. The use of syringes in the medical world is relatively high, and especially since the COVID-19 pandemic, the use of hypodermic syringes increased sharply due to vaccination. The syringe used must be effective and of good quality, so the International Organization for Standardization (ISO) has published test procedures and minimum specifications for hypodermic syringes. The performance of the syringe can be observed from the dead space, force piston operation, water and air leakage, and fitting position of the plunger in the barrel. This review shows that most researchers use the weighing method to measure the dead space, although some use other methods. The researchers found that most of the products met the minimum specifications of the ISO, and that the dimensions and shape of the syringe affected the dead space. Researchers have not examined other performance measures recommended by the ISO. Researchers have focused more on force injection than force piston operation, leakage after injection or back spray than air and water leakage, and reduction the friction of the plunger without considering the fitting position of the plunger in the barrel.

Stability of high concentrated triple intrathecal therapy for pediatrics and mitigation strategies

Stringent formulation requirements are defined to intrathecally administer drug substances, avoiding neurological complications. In case of pediatric patients, these are further complicated due to the limited volumes of the celebrospinal fluid and, therefore, high concentrated solutions of methotrexate (MTX), cytarabine and corticosteroids (i.e., methylprednisolone or hydrocortisone) are prepared based on the patient's age. This work aims to assess the chemical and physical stability of triple intrathecal mixtures differing in volume and composition by a bracketing approach and to identify possible stress causes and mitigation strategies. Low solubility of MTX was the main factor limiting the physical stability of triple mixtures. Regarding solutions containing methylprednisolone, the amount of MTX remaining was about 95% in the solution at highest concentrations with the concomitant formation of a visible particulate sizing bigger than 1 µm after 24 h of storage at 25 °C. This behavior was mainly driven by the pH reduction due to the pH value of the cytarabine solution used; the shear stress also induced drug precipitation. In the case of the hydrocortisone based mixtures, the precipitate formation occurred at a slow rate. To improve the physical stability, a better control of the mixture pH (optimal value ≈ 7) is required or, as an alternative, the addition of the cytarabine solution to a pre-mixed binary mixture containing MTX and a corticosteroid should be preferred.