Primary cup fixation with different designs of trapeziometacarpal total joint trapezium components: a radiostereometric analysis in a pig bone model

Revision rates of trapeziometacarpal total joint arthroplasty in relation to occupational hand force requirements

The purpose was to determine revision rates after trapeziometacarpal total joint arthroplasty in working age patients, hypothesizing that higher occupational hand force requirements lead to higher revision rates. We conducted a follow-up study of patients operated 2003-2015. Self-reported job titles at the time of primary surgery were linked with a job exposure matrix to estimate occupational hand force requirements. Time until revision was analysed using Cox regression. The study comprised 222 patients aged 39-65 years (mean 55, SD 6), including 133 patients in the labour market. The median follow-up period was 5 years (interquartile range 4-7) and the overall revision rate was 5/100 person-years. For high versus low occupational hand force requirements, the hazard ratio was 1.5 (95% confidence interval 0.5-4.4). For patients outside the labour market, the hazard ratio was 2.3 (0.9-5.6). Our results did not indicate large effects of high occupational hand force requirements on revision rates.Level of evidence: IV.

The mechanical fixation of a cementless conical cup in cortical versus cancellous trapezial bone: an experimental study

In a pig bone model mimicking the human trapezium, we assessed the cementless fixation of trapezial cups in cancellous and cortical bone. Thirty-two saddle-shaped pig forefoot bones were prepared for cup fixation. Conical Konos cups (Beznoska, Kladno, Czech Republic) size 9 mm or 10 mm diameter were impacted. Cup migration was evaluated with repeated radiostereometry after intervals of cyclic-load tests. Migration increased for every load-interval up to 750 N and was higher with cancellous bone fixation than with cortical bone fixation. In cancellous bone, 9 mm cups migrated more than 10 mm cups. At the highest load (1050 N), the cumulative implant survival was 88% for 10 mm cups with cortical bone fixation and 13% for 9 mm cups with cancellous bone fixation. We conclude that mechanical fixation of conical Konos cups was better in cortical than in cancellous bone. Our results further suggest that the largest possible cup diameter should be used.

Trapezium Bone Density-A Comparison of Measurements by DXA and CT

Bone density may influence the primary fixation of cementless implants, and poor bone density may increase the risk of implant failure. Before deciding on using total joint replacement as treatment in osteoarthritis of the trapeziometacarpal joint, it is valuable to determine the trapezium bone density. The aim of this study was to: (1) determine the correlation between measurements of bone mineral density of the trapezium obtained by dual-energy X-ray absorptiometry (DXA) scans by a circumference method and a new inner-ellipse method; and (2) to compare those to measurements of bone density obtained by computerized tomography (CT)-scans in Hounsfield units (HU). We included 71 hands from 59 patients with a mean age of 59 years (43–77). All patients had Eaton–Glickel stage II–IV trapeziometacarpal (TM) joint osteoarthritis, were under evaluation for trapeziometacarpal total joint replacement, and underwent DXA and CT wrist scans. There was an excellent correlation (r = 0.94) between DXA bone mineral density measures using the circumference and the inner-ellipse method. There was a moderate correlation between bone density measures obtained by DXA- and CT-scans with (r = 0.49) for the circumference method, and (r = 0.55) for the inner-ellipse method. DXA may be used in pre-operative evaluation of the trapezium bone quality, and the simpler DXA inner-ellipse measurement method can replace the DXA circumference method in estimation of bone density of the trapezium.

The accuracy and precision of radiostereometric analysis in upper limb arthroplasty

Background and purpose - Radiostereometric analysis (RSA) is an accurate method for measurement of early migration of implants. Since a relation has been shown between early migration and future loosening of total knee and hip prostheses, RSA plays an important role in the development and evaluation of prostheses. However, there have been few RSA studies of the upper limb, and the value of RSA of the upper limb is not yet clear. We therefore performed a systematic review to investigate the accuracy and precision of RSA of the upper limb. Patients and methods - PRISMA guidelines were followed and the protocol for this review was published online at PROSPERO under registration number CRD42016042014. A systematic search of the literature was performed in the databases Embase, Medline, Cochrane, Web of Science, Scopus, Cinahl, and Google Scholar on April 25, 2015 based on the keywords radiostereometric analysis, shoulder prosthesis, elbow prosthesis, wrist prosthesis, trapeziometacarpal joint prosthesis, humerus, ulna, radius, carpus. Articles concerning RSA for the analysis of early migration of prostheses of the upper limb were included. Quality assessment was performed using the MINORS score, Downs and Black checklist, and the ISO RSA Results - 23 studies were included. Precision values were in the 0.06-0.88 mm and 0.05-10.7° range for the shoulder, the 0.05-0.34 mm and 0.16-0.76° range for the elbow, and the 0.16-1.83 mm and 11-124° range for the TMC joint. Accuracy data from marker- and model-based RSA were not reported in the studies included. Interpretation - RSA is a highly precise method for measurement of early migration of orthopedic implants in the upper limb. However, the precision of rotation measurement is poor in some components. Challenges with RSA in the upper limb include the symmetrical shape of prostheses and the limited size of surrounding bone, leading to over-projection of the markers by the prosthesis. We recommend higher adherence to RSA guidelines and encourage investigators to publish long-term follow-up RSA studies.

Total arthroplasty of basal thumb joint with Elektra prothesis: an in vitro analysis

The reported outcomes of the Elektra thumb carpo-metacarpal joint implant have been very variable. This study evaluates the influence of daily cyclic loads and the type of the screw-fit cup insertion technique in the trapezium, with and without prior threading, on the structural bone behaviour. The study was performed experimentally to predict initial implant stability and cortical bone strains. Computational models were developed to assess the structural cancellous bone behaviour. The use of Elektra implant considerably changed the bone strain behaviour compared with the intact joint. This may be associated with risks of cancellous bone fatigue failure due to overload, particularly in the trapezium. The joint load magnitude has a more important structural role than that of the screw-fit cup insertion technique. Limiting the magnitude of thumb loads after arthroplasty may contribute positively to the longevity of this procedure.

LEVEL OF EVIDENCE

V.

High revision rates with the metal-on-metal Motec carpometacarpal joint prosthesis

We retrospectively evaluated a consecutive series of 42 Motec thumb carpometacarpal total joint arthroplasties. The primary endpoint was revision with implant removal and trapeziectomy. At follow-up the disability of the arm shoulder and hand (DASH) score, pain on numerical rating scale at rest and with activity and serum chrome and cobalt concentrations were assessed for both unrevised and revised patients. At a mean follow-up of 26 months, 17 patients had been revised. The 2 year cumulative revision rate was 42% (95% CI, 28-60%). The DASH score and pain scores at rest and with activity were comparable between the patients whose thumbs remained unrevised and those revised. Patients with elevated serum chrome and cobalt levels had significantly higher DASH and pain scores, but elevated levels were not associated with revision. The revision rate in this study is unacceptably high. However, pain and DASH scores after revision are acceptable and comparable with patients with non-revised implants.

LEVEL OF EVIDENCE

IV.

Outcome of uncemented trapeziometacarpal prosthesis for treatment of thumb carpometacarpal joint arthritis

BACKGROUND

Osteoarthritis of the trapeziometacarpal joint of thumb occurs frequently and can be very disabling. Numerous surgical techniques including trapeziectomy with or without tendon interposition arthrodesis and partial or total joint arthroplasty with cemented and noncemented prosthesis have been described for the treatment of trapeziometacarpal joint osteoarthritis. Initial problems of osteolysis and implant loosening have been substantially reduced with improvement in implant design. The aim of this study is to demonstrate that trapeziometacarpal osteoarthritis of the thumb can be effectively treated with uncemented total joint replacement prosthesis.

MATERIALS AND METHODS

We retrospectively collected data for 16 trapeziometacarpal joint replacements in 14 patients. One patient was excluded as they required revision with trapeziectomy and ligament reconstruction following fracture of Trapezium. The trapeziometacarpal joint prosthesis was used in all cases and all operations were carried out by one surgeon. Clinical outcome was determined by a pre and postoperative patient rated wrist evaluation (PRWE) and Michigan Hand Questionnaire Score. Range of motion, grip, tip pinch and key pinch strength were measured and compared with the unoperated hand. Radiological assessment was carried out by plain radiographs for preoperative staging of arthritis and postoperative radiographs at latest followup for evaluation of osteolysis and implant loosening. Average followup period was 26 months.

RESULTS

There was an improvement in hand function and pain level based on PRWE and Mischigan Hand outcome Questionnaire Score. One patient had intraoperative fracture of Trapezium and subsequent radiographs at 14 months followup showed loosening of the trapezial component due to nonunion of the fracture and complete disintegration of the trapezium. There were no cases of dislocation or implant loosening for the remaining 15 CMC joints at the latest followup.

CONCLUSION

The use of uncemented prosthesis in treatment of Questionnaire Score. Range of motion joint osteoarthritis gives excellent short term results in improving hand function in terms of strength and stability and achieving pain relief.

Bone mineral density of the trapezium in osteoarthritic trapeziometacarpal joints

The aim of this study was to test the precision and reliability of measurements of the bone mineral density (BMD) of the trapezium in patients with osteoarthritic trapeziometacarpal joints using dual-energy X-ray absorptiometry scans and to assess whether there is an acceptable correlation between the BMD of the trapezium and that of the distal radius, for which normative data exist. We included 66 patients (52 women, 14 men) diagnosed with Eaton-Glickel stage II-IV osteoarthritis and a mean age of 59 years (range 40-77) in a prospective study. We found good intra- and inter-observer agreement of BMD measurements. Reliability was also good in repeated measurements. There was an indication of an increase in BMD with progression in the Eaton-Glickel stage. There was only a moderate correlation between the BMD of the trapezium and that of the radius.

Patients with metal-on-metal articulation in trapeziometacarpal total joint arthroplasty may have elevated serum chrome and cobalt

Serum chrome and cobalt was measured in 50 patients with trapeziometacarpal total joint replacement with metal-on-metal articulation and compared with serum chrome and cobalt values in 23 patients with trapeziometacarpal total joint replacement with metal-on-polyethylene articulation. In 10 of 50 (20%) patients with metal-on-metal articulation, slightly elevated serum chrome or cobalt values were found compared with only one in 23 (4%) patients with metal-on-polyethylene articulation. All metal values were lower than accepted 'normal values' for metal-on-metal hip arthroplasty and so considered not to be a general health risk. However, the mean disabilities of the arm, shoulder and hand (DASH) score was 24 in patients with elevated serum chrome or cobalt compared with 10 in patients with normal metal values (p < 0.05) suggesting a local clinical effect of the elevated serum chrome or cobalt values. We recommend that patients with trapeziometacarpal total joint replacement with metal-on-metal articulation are followed with DASH score and radiological examination every 3-5 years and serum chrome and cobalt should be analysed in symptomatic cases to learn more about possible local complications leading to, or arising from, metal debris.

Equally good fixation of cemented and uncemented cups in total trapeziometacarpal joint prostheses. A randomized clinical RSA study with 2-year follow-up

BACKGROUND AND PURPOSE

Cup failure is a recognized problem in total trapeziometacarpal (TM) joint prostheses; it may be related to poor fixation, which can be revealed by radiostereometric analysis (RSA). We compared the early implant migration of cemented trapezium cups to that of uncemented screw cups.

PATIENTS AND METHODS

In a prospective, parallel-group, randomized patient-blinded clinical trial, we included 32 hands in 28 patients (5 males) with a mean age of 58 (40-77) years and with Eaton stage-2 or -3 osteoarthritis of the trapeziometacarpal joint. Patients were randomized to surgery with a cemented DLC all-polyethylene cup (C) (n = 16) or an uncemented hydroxyapatite-coated chrome-cobalt Elektra screw cup (UC) (n = 16). Uncemented cups were inserted without threading of the bone. Stereoradiographs for evaluation of cup migration (primary effect size) and DASH and pain scores were obtained during 2 years of follow-up.

RESULTS

The 2-year total translation (TT) was similar (p = 0.2): 0.24 mm (SD 0.10) for the C (n = 11) and 0.19 mm (SD 0.16) for the UC (n = 11). Variances were similar (p = 0.4). Judged by RSA, 2 UC cups and 1 C cup became loose (TT > 1 mm). Both UC cups were found to be loose at revision. Grip strength, pain, and DASH scores were similar between groups at all measurement points.

INTERPRETATION

Early implant fixation and clinical outcome were equally good with both cup designs. This is the first clinical RSA study on trapezium cups, and the method appears to be clinically useful for detection of loose implants.

Elektra prosthesis for trapeziometacarpal osteoarthritis: a follow-up of 39 consecutive cases

We present a prospective follow-up of 39 Elektra prostheses in 37 patients (32 women and five men), with a mean age of 56.5 (range 46-71) years; 34 patients had osteoarthritis and three had rheumatoid arthritis. Patients were followed using clinical examination, including measurement of pain on a visual analogue scale, mobility, and strength, after 6, 12, 26, and 52 weeks, and annually thereafter. Radiological examination was done preoperatively and after 6, 26, and 52 weeks, and annually thereafter. The mean follow-up time was 48 (range 3-91) months. Although we observed a fast recovery, including maintenance of mobility and a gradual increase in grip strength, there was a revision rate of 7/38 (24%) after 36 months, increasing to 17/38 (44%) after 72 months. The main reason for revision was loosening of the trapezial component, and biomechanical properties of the trapezial fixation may be the key problem in treating trapeziometacarpal osteoarthritis using a total prosthesis.