Effect of Glycosaminoglycans on Cryptosporidium Oocyst Attachment and Excystation

Cryptosporidium causes severe gastrointestinal disease resulting from the ingestion of oocysts, followed by oocyst excystation in the small intestine and the release of infective sporozoites. An understudied strategy for Cryptosporidium inactivation is purposeful oocyst excystation, as sporozoites do not survive long in the environment. This study showed that C. parvum oocyst excystation was induced by direct contact with various glycosaminoglycans (GAGs), including heparin (Hep), chondroitin sulfate A (CSA), and hyaluronan (HA), assembled on polydopamine (PD)-functionalized surfaces. PD surfaces elicited 97.9 ± 3.6% oocyst attachment, with some of the attached oocysts partially (7.3 ± 1.3%) or fully (4.0 ± 0.6%) excysted after 4 days. The PD-GAG surfaces (GAG concentration = 2 mg/mL) elicited similarly high attachment (>97%) and higher oocyst excystation efficiencies after 4 days. The PD-Hep surfaces elicited the highest number of attached excysted oocysts (11.8 ± 0.63% partially excysted; 11.9 ± 0.49% fully excysted), and the PD-HA surfaces elicited the lowest (8.8 ± 2.1% partially excysted; 7.8 ± 1.2% fully excysted). Surface characterization revealed that the addition of GAGs to the PD surface changed both the surface roughness as well as the surface wettability. Treatment of oocysts with an enzyme that degraded the surface glycocalyx markedly reduced excystation (to <2%) of the oocysts attached to the PD and PD-GAG surfaces. These findings suggest that GAGs provide an important local signal for the excystation of C. parvum oocysts and that certain surface-expressed oocyst receptors are necessary for efficient excystation. These oocyst-receptor relationships may be useful in the design of functionalized surfaces for the purposeful inactivation of oocysts in the environment or in water treatment systems. IMPORTANCE Polydopamine surfaces functionalized with glycosaminoglycans were shown to facilitate the attachment and excystation of Cryptosporidium parvum oocysts. Our findings suggest that a surface-expressed receptor on the oocyst wall plays a key role in excystation, with glycosaminoglycans serving as ligands that trigger the initiation of the process. Future technologies and treatment strategies designed to promote premature excystation of oocysts will minimize the ingestion of sporozoites that initiate infection. Therefore, the results from this study have important implications for the protection of public health from waterborne cryptosporidiosis and may serve as a foundation for engineered surfaces designed to remove oocysts from surface waters or inactivate oocysts in water treatment systems.

High-rate blackwater anaerobic digestion under septic tank conditions with the amendment of biosolids-derived biochar synthesized at different temperatures

Septic tanks have been widely used for blackwater treatment in developing countries, while high-rate septic tanks with improved methane recovery are yet to be achieved. This study investigated biosolids-derived biochar (synthesized at 300℃, 425℃, and 550℃) as an additive for developing high-rate septic tanks. The experiments were conducted with anaerobic bioreactors operated with synthetic blackwater under septic tank conditions. All biochar amended reactors demonstrated a steady increase in daily methane production for increasing OLR from 0.08 to 3 g COD/L/d. The control reactor showed significant process disturbances at OLRs ≥ 2 g COD/L/d with an accumulation of volatile fatty acids followed by pH drop. At OLR of 3 g COD/L/d, the daily methane production from biochar amended reactors was ~ 4.3 times higher than the control (300 vs. 70 mL per day). Biochar addition established a robust microbiome consisted of a higher abundance of hydrogenotrophic and acetoclastic methanogens and hydrogen-producing fermentative bacteria.

Lauryl Phosphate Flotation Chemistry in Barite Flotation

Barite has numerous applications including barium mud for oil well drilling, manufacture of elemental barium, filler for paper and rubber industries, and contrast material for X-ray radiology for the digestive system. Currently, froth flotation is the main method for the beneficiation of barite using fatty acid as a typical collector. In this research, it was found that lauryl phosphate is also a promising collector for barite flotation. Results from microflotation, contact angle, and zeta potential indicate that lauryl phosphate is adsorbed on the barite surface and thus achieves superior flotation efficiency at a wide pH range. The interfacial water structure and wetting characteristics of barite surface with/without lauryl phosphate adsorption were also evaluated by molecular dynamics simulations (MDS). The results from molecular dynamics simulations and interaction energy calculations are in accord with the experimental results, which suggest that lauryl phosphate might be a potential collector for the flotation of barite.

Insight into the Influence of Surface Roughness on the Wettability of Apatite and Dolomite

Surface roughness has an important influence on the wettability of particles. This paper is an innovative exploration to control the surface wettability of apatite and dolomite from the perspective of roughness in the background of phosphate flotation. Roughness characteristics of apatite and dolomite particles and its effects on wettability were investigated with surface roughness, contact angle measurements, and SEM analysis. The relationship between surface energy and wettability of different roughness surfaces was also discussed. The results indicated that the influence of roughness on apatite and dolomite particles showed the same regularity, and wettability increased with the increasing roughness for hydrophilic surfaces, while the wettability decreased for hydrophobic surfaces. The influence of roughness on wettability can be well explained by Wenzel and Cassie models, and the surface energy of different rough surfaces had a strong correlation with their wettability. When sodium oleate was added after acid treatment, the apatite was hydrophilic, while the dolomite was hydrophobic; the difference in wettability between them became greater as surface roughness increased. Thus, it can be predicted that the selective separation of dolomite and apatite under acid reverse flotation conditions can be strengthened by increasing the mineral surface roughness during comminution.