Photo-catalytic activity of Zn1-xMnxS nanocrystals synthesized by wet chemical technique

Effect of isovalent dopants on photodegradation ability of ZnS nanoparticles

Isovalent (Mn, Cd, Cu, Co)-doped-ZnS nanoparticles having size vary in between 2 to 5nm are synthesized by co-precipitation route. Their photocatalytic activity for decoloration of Cango Red and Malachite Green dyes is tested in visible radiation under natural conditions. Structural and morphological features of the samples are investigated by X-ray diffraction, Raman spectroscopy, Scanning Electron Microscope (SEM), Transmission Electron Microscope (TEM) and UVVis spectrometer. Single phase zinc blende structure of as-synthesized undoped and doped-ZnS is confirmed by XRD and revealed by Rietveld fitting. SEM and TEM images show ultrafine nanoparticles having size in the range of 2 to 5nm. UV-Vis absorption spectra exhibit blue shift in absorption edge of undoped and doped ZnS as compared to bulk counterpart. The photocatalytic activity as a function of dopant concentration and irradiation time is systematically studied. The rate of de-coloration of dyes is detected by UVVis absorption spectroscopy and organic dye mineralization is confirmed by table of carbon (TOC) study. The photocatalytic activity of Mn-doped ZnS is highest amongst all dopants; however Co as a dopant is found to reduce photocatalytic activity than pure ZnS.

Tunable blue-green-emitting wurtzite ZnS:Mg nanosheet-assembled hierarchical spheres for near-UV white LEDs

Mg-doped ZnS hierarchical spheres have been synthesized via hydrothermal method using mixed solvents of ethylenediamine and DI water without any surface-active agent. The surface morphology and microstructure studies revealed that the hierarchical spheres were consisted of many well-aligned nanosheets with width 10 nm and length about 50 ~ 100 nm. X-Ray diffraction results show that the ZnS:Mg hierarchical spheres have wurtzite structure with high crystallinity. The absorption edge in the diffuse reflection spectra shifts towards lower wavelength with increasing Mg concentration, indicating an expansion in the bandgap energy that is estimated to be in the range of 3.28 to 3.47 eV. Blue-green photoluminescence with tunable intensity and peak position was observed depending on the Mg content. The Mg2+-activated ZnS phosphor can be good candidates for blue-green components in near-UV white light-emitting diodes.

One-step fabrication of biocompatible chitosan-coated ZnS and ZnS:Mn2+ quantum dots via a γ-radiation route

Biocompatible chitosan-coated ZnS quantum dots [CS-ZnS QDs] and chitosan-coated ZnS:Mn2+ quantum dots [CS-ZnS:Mn2+ QDs] were successfully fabricated via a convenient one-step γ-radiation route. The as-obtained QDs were around 5 nm in diameter with excellent water-solubility. These QDs emitting strong visible blue or orange light under UV excitation were successfully used as labels for PANC-1 cells. The cell experiments revealed that CS-ZnS and CS-ZnS:Mn2+ QDs showed low cytotoxicity and good biocompatibility, which offered possibilities for further biomedical applications. Moreover, this convenient synthesis strategy could be extended to fabricate other nanoparticles coated with chitosan.PACS: 81.07.Ta; 78.67.Hc; 82.35.Np; 87.85.Rs.