Tunable blue-green-emitting wurtzite ZnS:Mg nanosheet-assembled hierarchical spheres for near-UV white LEDs

ZnS:Eu @ZIF-8: Selective formation of ZnS:Eu QDs within a zinc methylimidazole framework for chemical sensing applications

Light harvesting based on a microporous zeolite imidazole backbone (MOF) has attracted considerable interest as a fluorescent sensor for the detection of analytes. In this work, we have prepared a novel complex containing quantum dots of doped rare earth elements by a one-pot method. to be applied to the fluorescence detection of pollution hazards. Because of the solid framework, the prepared ZnS:Eu@ZIF-8 composite shows desirable fluorescence properties. The selectivity and sensitivity of ZnS:Eu@ZIF -8 to TNP, which has a detection limit of 0.19 μmol/L, is further investigated and its sensing mechanism is discussed by means of fluorescence lifetime measurements in combination with emission and UV spectra. It should also be noted that this is the first doped quantum dot to be encapsulated in a MOF to be used for the potential detection of phenolic compounds in the aqueous environment, while the framework remains in place and no structural changes have occurred.

Optical Glucose Sensors Based on Chitosan-Capped ZnS-Doped Mn Nanomaterials

The primary goal of glucose sensing at the point of care is to identify glucose concentrations within the diabetes range. However, lower glucose levels also pose a severe health risk. In this paper, we propose quick, simple, and reliable glucose sensors based on the absorption and photoluminescence spectra of chitosan-capped ZnS-doped Mn nanomaterials in the range of 0.125 to 0.636 mM glucose corresponding to 2.3 mg/dL to 11.4 mg/dL. The detection limit was 0.125 mM (or 2.3 mg/dL), much lower than the hypoglycemia level of 70 mg/dL (or 3.9 mM). Chitosan-capped ZnS-doped Mn nanomaterials retain their optical properties while improving sensor stability. This study reports for the first time how the sensors' efficacy was affected by chitosan content from 0.75 to 1.5 wt.%. The results showed that 1 %wt chitosan-capped ZnS-doped Mn is the most-sensitive, -selective, and -stable material. We also put the biosensor through its paces with glucose in phosphate-buffered saline. In the same range of 0.125 to 0.636 mM, the sensors-based chitosan-coated ZnS-doped Mn had a better sensitivity than the working water environment.

Influence of Ag+ and Mn2+ ions on structural, optical and photoluminescence features of ZnS quantum dots

The current study deals with the structural, morphological, elemental, optical and photoluminescence behaviors of Ag⁺, Mn²⁺ dual doped ZnS quantum dots (QDs). The X-ray diffraction (XRD) and Transmission Electron Microscope (TEM) studies confirmed the cubic structure and size of the crystallites (~2 nm). The Scanning Electron Microscope (SEM) photographs portrayed the surface and morphological structure of prepared samples. Energy dispersive X-ray (EDX) and Fourier Transform Infrared Spectra (FTIR) ensured the presence of Zn, Ag, Mn and, S in the samples as per the anticipated stoichiometry ratio. The UV-visible spectra showed a red shift in optical absorption and band gap gets narrowed due to the incorporation of Ag⁺ ions. The size effect has overcome the quantum confinement effect in this case. Through photoluminescence (PL) studies, a weak UV emission and strong red wavelength emissions were received and discussed on the basis of sulfur vacancies. This red emission was dealt in terms of d-electrons transition between host and dopant ions.

Shell thickness effects on quantum dot brightness and energy transfer

Heterostructured core/shell quantum dots (QDs) are prized in biomedical imaging and biosensing applications because of their bright, photostable emission and effectiveness as Förster resonance energy transfer (FRET) donors. However, as nanomaterials chemistry has progressed beyond traditional QDs to incorporate new compositions, ultra-thick shells, and alloyed structures, few of these materials have had their optical properties systematically characterized for effective application. For example, thick-shelled QDs, also known as 'giant' QDs (gQDs) are useful in single-particle tracking microscopy because of their reduced blinking, but we know only that CdSe/CdS gQDs are qualitatively brighter than thin-shelled CdSe/CdS in aqueous media. In this study, we quantify the impact of shell thickness on the nanoparticle molar extinction coefficient, quantum yield, brightness, and effectiveness as a FRET donor for CdSe/xCdS core/shell and CdSe/xCdS/ZnS core/shell/shell QDs, with variable thicknesses of the CdS shell (x). Molar extinction coefficients up to three orders of magnitude higher than conventional dyes and forty-fold greater than traditional QDs are reported. When thick CdS shells are combined with ZnS capping, quantum yields following thiol ligand exchange reach nearly 40%-5-10× higher than either the commercially available QDs or gQDs without ZnS caps treated the same way. These results clearly show that thick CdS shells and ZnS capping shells work in concert to provide the brightest possible CdSe-based QDs for bioimaging applications. We demonstrate that thicker shelled gQDs are over 50-fold brighter than their thin-shelled counterparts because of significant increases in their absorption cross-sections and higher quantum yield in aqueous milieu. Consistent with the point-dipole approximation commonly used for QD-FRET, these data show that thick shells contribute to the donor-acceptor distance, reducing FRET efficiency. Despite the reduction in FRET efficiency, even the thickest-shell gQDs exhibited energy transfer. Through this systematic study, we elucidate the tradeoffs between signal output, which is much higher for the gQDs, and FRET efficiency, which decreases with shell thickness. This study serves as a guide to nanobiotechnologists striving to use gQDs in imaging and sensing devices.

Optical, phonon and efficient visible and infrared photocatalytic activity of Cu doped ZnS micro crystals

We report, the enhanced photocatalytic behaviour of Cu doped ZnS micro crystals. ZnS and different concentrations of Cu doped ZnS microcrystals were prepared. X-ray diffraction confirms the crystalline and phase of the particles. Morphology and sizes were studied using Scanning Electron Microscopy (SEM). Recorded optical absorption spectra show a band for around 365nm for pure ZnS, but there is a broad band in the near infrared regime for the Cu-doped ZnS microcrystals which are attributed to the d-d transitions of Cu²⁺ ions. Phonon properties of as-prepared samples were investigated using Raman spectroscopy. Present work we investigate the potential of ZnS and Cu doped ZnS as a photocatalyst. For this from the degradation of methylene blue dye in aqueous media the photocatalytic activity of pure and highest doped ZnS samples with the irradiation of white light and infrared, enhanced photocatalytic activity were observed. Mechanism of white light an IR light based photocatalytic activity is explained based on the electron-hole pair production.

Role of Cu+ on ZnS:Cu p-type semiconductor films grown by sputtering: influence of substitutional Cu in the structural, optical and electronic properties

ZnS:Cu films were synthetized by co-sputtering. A Cu content higher than 10.6 at% lead to changes as the shrinkage of the ZnS:Cu cell and development of a p-type behavior. These results are explained by the substitution of Zn⁺² ions by Cu⁺ ones.

Synthesis and enhanced humidity detection response of nanoscale Au-particle-decorated ZnS spheres

We successfully prepared Au-nanoparticle-decorated ZnS (ZnS-Au) spheres by sputtering Au ultrathin films on surfaces of hydrothermally synthesized ZnS spheres and subsequently postannealed the samples in a high-vacuum atmosphere. The Au nanoparticles were distributed on ZnS surfaces without substantial aggregation. The Au nanoparticle diameter range was 5 to 10 nm. Structural information showed that the surface of the annealed ZnS-Au spheres became more irregular and rough. A humidity sensor constructed using the Au-nanoparticle-decorated ZnS spheres demonstrated a substantially improved response to the cyclic change in humidity from 11% relative humidity (RH) to 33% to 95% RH at room temperature. The improved response was associated with the enhanced efficiency of water molecule adsorption onto the surfaces of the ZnS because of the surface modification of the ZnS spheres through noble-metal nanoparticle decoration.