Aligned Chemically Etched Silver Nanowire Monolayer as Surface-Enhanced Raman Scattering Substrates

Functionalized silver nanoparticles for SERS amplification with enhanced reproducibility and for ultrasensitive optical fiber sensing in environmental and biochemical assays

Plasmonic sensors have broad application potential in many fields and are promising to replace most bulky sensors in the future. There are various method-based chemical reduction processes for silver nanoparticle production with flexible structural shapes due to their simplicity and rapidity in nanoparticle fabrication. In this study, self-assembled silver nanoparticles (Ag NPs) with a plasmon peak at 424 nm were successfully coated onto -NH2-functionalized glass and optical fiber sensors. These coatings were rapidly produced via two denaturation reactions in plasma oxygen, respectively, and an APTES ((3-aminopropyl)triethoxysilane) solution was shown to have high strength and uniformity. With the use of Ag NPs for surface-enhanced Raman scattering (SERS), excellent results and good stability with the detection limit up to 10-10 M for rhodamine B and 10-8 M for methylene blue, and a signal degradation of only ∼20% after storing for 30 days were achieved. In addition, the optical fiber sensor with Ag NP coatings exhibited a higher sensitivity value of 250 times than without coatings to the glycerol solution. Therefore, significant enhancement of these ultrasensitive sensors demonstrates promising alternatives to cumbersome tests of dye chemicals and biomolecules without any complicated process.

Centrifugal Spinning Enables the Formation of Silver Microfibers with Nanostructures

Silver nanowires (AgNWs) have received much attention and application in transparent electrodes, wearable electronic devices, and sensors. The hope is for these nanowires to eventually replace the most commonly used transparent electrode material—indium tin oxide (ITO). However, electrospinning used for the preparation of AgNWs on a large scale is limited by its low productivity and high electric field, while the alcohol-thermal method is limited to mixing by-product silver nanoparticles in silver nanowires. We demonstrate a novel and simple centrifugal spinning approach in order to successfully fabricate ultra-long silver microfibers based on AgNO₃ and polyvinyl pyrrolidone (PVP). The centrifugal-spun precursor fiber and silver fiber can be prepared to as thin as 390 and 310 nm, respectively. Annealed fibers show typical nanostructures with grains down to a minimum size of 51 nm. Combinations of different parameters, including concentrations of PVP, needle size, and annealing temperature are also investigated, in order to optimize the spinning process of ultra-long silver microfibers. The feasibility of preparing silver microfibers by centrifugal spinning is preliminarily verified, examining prospects for mass production. Furthermore, numerous strategies related to assisting the creation of silver nanofibers using centrifugal spinning are presented as possibilities in future development.

Rapid and sensitive detection of Rhodamine B in food using the plasmonic silver nanocube-based sensor as SERS active substrate

The use of dye in food is harmful to human health and is prohibited nowadays. However, it is still used because of the benefits, such as cheap prices and abundant resources. Rhodamine B is usually used as the colorant in food such as chili powder, chili oil, etc. It is colorless at very low concentration 10^-7 M. The sensitive detection of RhB at ultra-low concentration help to prevent some risk for human. Surface-enhanced Raman scattering (SERS) is a great technique to detect the analytes at ultra-low concentration and provide the molecule's information as a fingerprint. In this study, silver nano-cube was facilely synthesized by reducing Ag⁺ in ethylene glycol and upgraded to thin-film as a SERS active substrate. RhB was detected at 10^-10 M by a silver nano-cube sensor. The dynamic linear regression between the Raman intensity and RhB concentration over seven orders of magnitude (from 10^-4 to 10^-10 M) was excellent with high reliability (R² = 0.99). Moreover, the substrate can be used after storing in a dark area for 60 days. This proposed nano-cube silver could serve as a potential substrate for detecting RhB in food at very low concentration.

Flexible and Superhydrophobic Silver Nanoparticles Decorated Aligned Silver Nanowires Films as Surface-Enhanced Raman Scattering Substrates

Flexible and superhydrophobic silver nanoparticles decorated aligned silver nanowires (AgNWs@AgNPs) films were employed as efficient surface-enhanced Raman scattering (SERS) substrates to investigate the SERS properties of the Rhodamine B (RB). Aligned silver nanowires were fabricated via interface self-assembly technique and incorporated into shape memory polyurethane (SMPU) by hot-press method, which not only endow the composites with ordered array characteristics but also flexibility due to the presence of polymer. After an electrochemical deposition combined with a galvanic reaction, AgNWs@AgNPs was obtained. At last, the substrate was functioned with perfluorodecanethiol (PFDT), and the target flexible and superhydrophobic silver nanoparticles decorated aligned silver nanowires substrate was obtained. The substrate confines water droplet in a small area, and the analytes were enriched owing to the concentrating effect. The SERS assay using the as-synthesized flexible and superhydrophobic silver films as substrates can detect Rhodamine B as low as10^-10 M. The mechanism is thought to relate to the formation of robust superhydrophobic film, which is based on micro- and nanoscaled hierarchical structure provided by the AgNWs@AgNPs layer, strong adhesion between the SMPU film and the AgNWs@AgNPs layer, and the low surface energy molecule adsorption on the silver surface. The combined superhydrophobic and flexible properties endow the SERS substrate with improved detection limit for practical SERS applications.

Surface-Nanostructured Single Silver Nanowire: A New One-Dimensional Microscale Surface-Enhanced Raman Scattering Interface

One-dimensional microscale surface-enhanced Raman scattering (SERS)-active interfaces have been intriguing as a newly emerging class of SERS interfaces compared to conventional macroscale SERS substrates. In this work, a stable surface-nanostructured single silver nanowire was fabricated. The nanostructures on the nanowire are formed by nanoscale silver crystal dots with diameters of 20-50 nm. The SERS signals of the crystal violet probe molecules adsorbed on the nanostructures are dramatically enhanced by both electromagnetic and chemical effects. The hot spots generated at the junctions of adjacent nanoscale dots yield highly efficient surface plasmon resonance. Simultaneously, the charge transfer on the atomic-scale silver cluster located at the nanostructured interface causes an enhancement similar to Raman resonance. The intensity distributions of the SERS peaks on the surface-nanostructured single nanowire are characterized by SERS mapping. It is found that, although the intensities of the SERS peaks are different, their SERS mapping images show uniform SERS enhancement distributions, whereas the noticeable SERS intensity distributions on the single smooth silver nanowire are mainly located on the two ends of the nanowire. A large number of nanoscale crystal dots along with the atomic-scale silver clusters are uniformly and densely distributed on the surface of the single roughened nanowire; these structural attributes induce a uniform and large surface plasmon resonance and charge transfer enhancements on the entire surface of the nanowire. This work indicates that the surface-nanostructured single silver nanowire, synthesized using a quite simple preparation method, performs as an excellent one-dimensional microscale SERS substrate with uniform and high enhancement characteristics, which shows high potential for applications as a new class of SERS-active substrates. Furthermore, the higher enhancement factor of the microscale SERS interfaces can be achieved by introducing other roughened nanowires to assemble a dimer and a trimer as micro-SERS substrates, which is consistent with the dark-field measurements.