Preparation and in vitro / in vivo evaluation of flurbiprofen nanosuspension-based gel for dermal application

Flurbiprofen (FB) is an analgesic and anti-inflammatory drug, but its low water solubility (BCS Class II) limits its dermal bioavailability. The aim of this study is to develop a FB nanosuspension (NS) based gel and to evaluate its analgesic and anti-inflammatory activities in rats. FB-NS was produced by the wet milling method with Plantacare 2000^Ⓡ, as stabilizer. The FB-NS was then incorporated in different carrier gels such as hydroxypropyl methyl cellulose (HPMC), polycarbophil, oleogel, and chitosan. To select the optimum gel type, visual examinations, pH and rheological property measurements, texture profile analysis, in vitro release and ex vivo permeation studies were performed. Following these tests, the analgesic and anti-inflammatory activities of the optimum NS based gel were evaluated using the tail flick and carrageenan-induced paw edema methods consecutively. The NS was successfully prepared with the wet milling method, and the PS, PDI and ZP values were found to be 237.7 ± 6.8 nm, 0.133±0.030, and -30.4 ± 0.7 mV; respectively. Among the NS-based gels, HPMC gel showed more suitable rheological and mechanical properties, also the percentage of permeated FB and the flux value observed for HPMC gel were higher for HPMC than for the other gels. Thus, HPMC gel was selected as a carrier gel for in vivo pharmacodynamics studies. The anti-inflammatory activity of FB-NS HPMC gel was higher than that of the physical mixture gel and that of the coarse suspension gel. Results of our analgesic activity studies showed that, in the 180th min of FB nanosuspension treatment, the latency time was significantly prolonged compared to that of the control group (p<0.05). As a conclusion, while nanosuspensions increased the in vivo pharmacodynamics effect of FB by means of nanosized particles and a large surface area, the HPMC gel as a carrier prolonged the contact time of NSs with skin and eased the dermal application.

Solid-state characterization of Felodipine-Soluplus amorphous solid dispersions

The aim of the current study is to develop amorphous solid dispersion (SD) via hot melt extrusion technology to improve the solubility of a water-insoluble compound, felodipine (FEL). The solubility was dramatically increased by preparation of amorphous SDs via hot-melt extrusion with an amphiphilic polymer, Soluplus® (SOL). FEL was found to be miscible with SOL by calculating the solubility parameters. The solubility of FEL within SOL was determined to be in the range of 6.2-9.9% (w/w). Various techniques were applied to characterize the solid-state properties of the amorphous SDs. These included Fourier Transform Infrared Spectrometry spectroscopy and Raman spectroscopy to detect the formation of hydrogen bonding between the drug and the polymer. Scanning electron microscopy was performed to study the morphology of the SDs. Among all the hot-melt extrudates, FEL was found to be molecularly dispersed within the polymer matrix for the extrudates containing 10% drug, while few small crystals were detected in the 30 and 50% extrudates. In conclusion, solubility of FEL was enhanced while a homogeneous SD was achieved for 10% drug loading.