Study on effects of molecular crowding on G-quadruplex-ligand binding and ligand-mediated telomerase inhibition

The telomere G-quadruplex-binding and telomerase-inhibiting capacity of two cationic (TMPyP4 and PIPER) and two anionic (phthalocyanine and Hemin) G-quadruplex-ligands were examined under conditions of molecular crowding (MC). Osmotic experiments showed that binding of the anionic ligands, which bind to G-quadruplex DNA via π-π stacking interactions, caused some water molecules to be released from the G-quadruplex/ligand complex; in contrast, a substantial number of water molecules were taken up upon electrostatic binding of the cationic ligands to G-quadruplex DNA. These behaviors of water molecules maintained or reduced the binding affinity of the anionic and the cationic ligands, respectively, under MC conditions. Consequently, the anionic ligands (phthalocyanine and Hemin) robustly inhibited telomerase activity even with MC; in contrast, the inhibition of telomerase caused by cationic TMPyP4 was drastically reduced by MC. These results allow us to conclude that the binding of G-quadruplex-ligands to G-quadruplex via non-electrostatic interactions is preferable for telomerase inhibition under physiological conditions.

Volume and hydration changes of DNA–ligand interactions

We report the volumetric and other thermodynamic properties of ethidium bromide (EB), propidium iodide (PI) and daunomycin (DAU) intercalating with poly(dA).poly(dT), poly[d(A-T)].poly[d(A-T)], and poly[d(G-C)].poly[d(G-C)], respectively, as well as minor groove binder Hoechst 33258 binding with poly[d(A-T)].poly[d(A-T)]. The data were obtained using fluorescence titration and hydrostatic pressure measurements. Our thermodynamic data are combined with enthalpies from literature reports to analyze the thermodynamic characteristics of the different interactions. The differences are interpreted based on three processes related to hydration: I. burial of non-polar hydrophobic solvent accessible surface, II. burial of polar surface and formation of solute-solute H-bonds, and III. disruption of "structural" hydration. Sequence dependent conformational changes may also be important when comparing ligand binding to different DNA sequences. We conclude that a combination of different thermodynamic parameters, especially volume change, is essential in order to understand the role of hydration in the energetics of DNA-ligand interactions.

Temperature dependence of the volumetric parameters of drug binding to poly[d(A-T)].Poly[d(A-T)] and Poly(dA).Poly(dT)

We report the temperature and salt dependence of the volume change (DeltaVb) associated with the binding of ethidium bromide and netropsin with poly(dA).poly(dT) and poly[d(A-T)].poly[d(A-T)]. The DeltaV(b) of binding of ethidium with poly(dA).poly(dT) was much more negative at temperatures approximately 70 degrees C than at 25 degrees C, whereas the difference is much smaller in the case of binding with poly[d(A-T)].poly[d(A-T)]. We also determined the volume change of DNA-drug interaction by comparing the volume change of melting of DNA duplex and DNA-drug complex. The DNA-drug complexes display helix-coil transition temperatures (Tm several degrees above those of the unbound polymers, e.g., the Tm of the netropsin complex with poly(dA)poly(dT) is 106 degrees C. The results for the binding of ethidium with poly[d(A-T)].poly[d(A-T)] were accurately described by scaled particle theory. However, this analysis did not yield results consistent with our data for ethidium binding with poly(dA).poly(dT). We hypothesize that heat-induced changes in conformation and hydration of this polymer are responsible for this behavior. The volumetric properties of poly(dA).poly(dT) become similar to those of poly[d(A-T)].poly[d(A-T)] at higher temperatures.

Effects of high hydrostatic pressures on living cells: a consequence of the properties of macromolecules and macromolecule-associated water

Sixty percent of the Earth's biomass is found in the sea, at depths greater than 1000 m, i.e., at hydrostatic pressures higher than 100 atm. Still more surprising is the fact that living cells can reversibly withstand pressure shifts of 1000 atm. One explanation lies in the properties of cellular water. Water forms a very thin film around macromolecules, with a heterogeneous structure that is an image of the heterogeneity of the macromolecular surface. The density of water in contact with macromolecules reflects the physical properties of their different domains. Therefore, any macromolecular shape variations involving the reorganization of water and concomitant density changes are sensitive to pressure (Le Chatelier's principle). Most of the pressure-induced changes to macromolecules are reversible up to 2000 atm. Both the effects of pressure shifts on living cells and the characteristics of pressure-adapted species are opening new perspectives on fundamental problems such as regulation and adaptation.

In vitro increases in plasmid DNA supercoiling by hydrostatic pressure

By conducting topoisomerase I-mediating supercoiling assays, effects of elevated pressure on DNA supercoiling were investigated for the first time. It was found that pressure elevations induced a progressive increase in plasmid DNA linking numbers, winding the DNA duplex by a magnitude of 1.1-1.6x10(-3) angular degree/base/MPa. Implications for the findings were discussed in terms of disturbance of the tertiary structure of DNA by elevated pressure.