Analysis of the Release Process of Phenylpropanolamine Hydrochloride from Ethylcellulose Matrix Granules II. Effects of the Binder Solution on the Release Process

Evaluation of Bitterness Suppression of Macrolide Dry Syrups by Jellies

The purpose of this study was to evaluate the bitterness-suppressing effect of three jellies, all commercially available on the Japanese market as swallowing aids, on two dry syrups containing the macrolides clarithromycin (CAM) or azithromycin (AZM). The bitterness intensities of mixtures of the dry syrups and acidic jellies were significantly greater than those of water suspensions of the dry syrups in human gustatory sensation tests. On the other hand, the mixture with a chocolate jelly, which has a neutral pH, was less bitter than water suspensions of the dry syrups. The bitterness intensities predicted by the taste sensor output values correlated well with the observed bitterness intensities in human gustatory sensation tests. When the concentrations of CAM and AZM in solutions extracted from physical mixtures of dry syrup and jelly were determined by HPLC, concentrations in the solutions extracted from mixtures with acidic jellies were higher than those from mixtures with a neutral jelly (almost 90 times higher for CAM, and almost 7-10 times higher for AZM). Thus, bitterness suppression is correlated with the pH of the jelly. Finally, a drug dissolution test for dry syrup with and without jelly was performed using the paddle method. There was no significance difference in dissolution profile. It was concluded the appropriate choice of jelly with the right pH is essential for taste masking. Suitable jellies might be used to improve patient compliance, especially in children. The taste sensor may be used to predict the bitterness-suppressing effect of the jelly.

Analysis of the Release Process of Phenylpropanolamine Hydrochloride from Ethylcellulose Matrix Granules III. Effects of the Dissolution Condition on the Release Process

In the pharmaceutical preparation of a controlled release drug, it is very important and necessary to understand the entire release properties. As the first step, the dissolution test under various conditions is selected for the in vitro test, and usually the results are analyzed following Drug Approval and Licensing Procedures. In this test, 3 time points for each release ratio, such as 0.2-0.4, 0.4-0.6, and over 0.7, respectively, should be selected in advance. These are analyzed as to whether their values are inside or outside the prescribed aims at each time point. This method is very simple and useful but the details of the release properties can not be clarified or confirmed. The validity of the dissolution test in analysis using a combination of the square-root time law and cube-root law equations to understand all the drug release properties was confirmed by comparing the simulated value with that measured in the previous papers. Dissolution tests under various conditions affecting drug release properties in the human body were then examined, and the results were analyzed by both methods to identify their strengths and weaknesses. Hereafter, the control of pharmaceutical preparation, the manufacturing process, and understanding the drug release properties will be more efficient. It is considered that analysis using the combination of the square-root time law and cube-root law equations is very useful and efficient. The accuracy of predicting drug release properties in the human body was improved and clarified.