Practical utilization of cardiac computed tomography for the success in complex coronary intervention

Percutaneous coronary intervention (PCI) for complex lesions is still technically demanding and is associated with less favorable procedural parameters such as lower success rate, longer procedural time, higher contrast volume and unexpected complications. Because the conventional angiographic analysis is limited by the inability to visualize the plaque information and the occluded segment, cardiac computed tomography has evolved as an adjunct to invasive angiography to better characterize coronary lesions to improve success rates of PCI. Adding to routine image reconstructions by coronary computed tomography angiography, the thin-slab maximum intensity projection method, which is a handy reconstruction technique on an ordinary workstation, could provide easy-to-understand images to reveal the anatomical characteristics and the lumen and plaque information simultaneously, and then assist to build an in-depth strategy for PCI. Especially in the treatment of chronic total occlusion lesion, these informations have big advantages in the visualization of the morphologies of entry and exit, the occluded segment and the distribution of calcium compared to invasive coronary angiography. Despite of the additional radiation exposure, contrast use and cost for cardiac computed tomography, the precise analysis of lesion characteristics would consequently improve the procedural success and prevent the complication in complex PCI.

The utility of the combination of the corrosion cast method and post mortem MSCT scans

A careful post-mortem investigation is needed to determine the cause of death of patients bearing coronary stents and to describe complications of stent implantation. The main purpose of this study was to combine post mortem methods of CT angiography and corrosion cast preparation for the visualization of coronary stenoses, coronary stents, instent restenosis, and stent occlusion. Injection-corrosion method was combined with post-mortem MSCT angiography to characterize the pathomorphological changes after stent implantation in 6 male cadaver hearts. Multi-slice computed tomography was employed to visualize the coronary artery system. For image post processing, multiplanar reconstructions, maximal intensity projections and three dimensional reconstructions were used. This study was assessing the feasibility of post mortem MSCT for intracoronary stent evaluation. We described a method for characterization of the coronary side branch stenosis caused by stent implantation. Post mortem CT imaging proved to be a feasible and highly reproducible technique for the characterization of pathological changes in the coronary system.

Procoagulant activity of circulating microparticles is associated with the presence of moderate calcified plaque burden detected by multislice computed tomography

BACKGROUND

Circulating microparticles (MPs) have been reported to be associated with coronary artery disease (CAD). In this study, we explored the relationship between MPs procoagulant activity and characteristics of atherosclerotic plaque detected by 64-slice computed tomography angiography (CTA).

METHODS

In 127 consecutive patients with CAD but without acute coronary syndrome and who underwent 64-slice CTA, MPs procoagulant activity in plasma (by a thrombin generation test), soluble form of lectin-like oxidized low-density lipoprotein receptor-1 (sLOX-1) and N(epsilon)-(carboxymethyl) lysine (CML) circulating levels (by ELISA) were measured. A quantitative volumetric analysis of the lumen and plaque burden of the vessel wall (soft and calcific components), for the three major coronary vessels, was performed. The patients were classified in three groups according to the presence of calcium volume: non-calcified plaque (NCP) group (calcium volume (%) = 0), moderate calcified plaque (MCP) group (0 < calcium volume (%) < 1), and calcified plaque (CP) group (calcium volume (%) ≥ 1).

RESULTS

MPs procoagulant activity and CML levels were higher in MCP group than in CP or NCP group (P = 0.009 and P = 0.027, respectively). MPs procoagulant activity was positively associated with CML (r = 0.317, P < 0.0001) and sLOX-1 levels (r = 0.216, P = 0.0025).

CONCLUSIONS

MPs procoagulant activity was higher in the MCP patient group and correlated positively with sLOX-1 and CML levels, suggesting that it may characterize a state of blood vulnerability that may locally precipitate plaque instability and increase the risk of subsequent major cardiovascular events.

Inverse association between circulating levels of soluble receptor for advanced glycation end-products and coronary plaque burden

AIM

Low levels of soluble receptor for advanced glycation end-products (sRAGE) have been reported to be associated with coronary artery disease (CAD) and peripheral atherosclerosis. This study explored the relationship between circulating levels of sRAGE and the characteristics of coronary vessels detected by 64-slice computed tomography angiography (CTA).

METHODS

In this cross-sectional study we included 127 consecutive patients with CAD but without acute coronary syndrome. Quantitative volumetric analysis of the lumen and plaque burden of the vessel wall (soft and calcific components) was performed for the three major coronary vessels. Each component was expressed as a percentage of vessel volume and utilized in per-patient analysis. The patients were classified into two groups according to the presence of calcium volume: non-calcified plaque (NCP) group (calcium volume %=0) and calcified plaque (CP) group (calcium volume % >0).

RESULTS

In the NCP group, but not in the CP group, simple regression analysis revealed a negative association of total plaque burden % with sRAGE (β=-0.378, p=0.0019) and HDL cholesterol (β=-0.368, p=0.003) and a positive association with creatinine (β=0.258, p=0.041) and male gender (β=0.317, p=0.01). After adjusting for confounding factors, the total plaque burden % remained significantly associated only with sRAGE (β=-0.358, p=0.011).

CONCLUSIONS

Circulating sRAGE levels are associated in an inverse manner with non-calcified plaque burden, suggesting that it may be related with early atherosclerosis and plaque progression.

Diagnostic accuracy of angiographic view image for the detection of coronary artery stenoses by 64-detector row CT: a pilot study comparison with conventional post-processing methods and axial images alone

BACKGROUND

The angiographic view (AGV) image is a new post-processing method that is similar to conventional coronary angiography (CAG). The purpose of this study was to evaluate its accuracy for coronary stenosis detection by 64-detector row computed tomography (CT).

METHODS AND RESULTS

CT evaluation results of 17 patients were compared with the results of invasive CAG on a coronary segment basis concerning the presence of stenoses>50% diameter reduction. All images of the 3 viewing methods (combination of conventional methods, AGV image alone, and axial images alone) were evaluated in consensus by 3 cardiovascular radiologists. Among 196 assessable segments, invasive CAG showed significant coronary artery stenoses in 44 segments. 43 of 44 lesions were detected with the AGV image, and absence of significant stenosis was correctly identified in 135 of 152 segments (sensitivity 98%; specificity 89%; accuracy 91%; positive predictive value 72%, negative predictive value 99%). The sensitivity of the AGV image was the same as that of conventional methods (98%). There was no significant difference in accuracy between the AGV image (91%) and conventional methods (94%). The accuracy of the AGV image was significantly higher than the axial images alone (78%).

CONCLUSIONS

AGV image shows promise as a post-processing method for identifying coronary artery stenosis with high accuracy.

Novel three-dimensional imaging of the anatomical relationship between the pulmonary vein and left atrium

BACKGROUND

Visualization of the inner anatomical relationship of the pulmonary veins (PVs) and left atrium (LA) is important for achieving a better success rate and avoiding complications in circumferential LA ablation for atrial fibrillation (AF).

METHODS AND RESULTS

Twelve patients with AF underwent computed tomography and novel post-processing images that emphasized the boundaries of the PVs and LA were produced.

CONCLUSIONS

The "Transparent View" images enabled visualization of the inner anatomical relationship of the PVs and LA in the same geometry as in pulmonary venography in all cases.

Anatomical investigation of the sinus node artery using dual-source computed tomography

BACKGROUND

Few investigators have studied the anatomy of the sinus node artery (SNA) using noninvasive imaging modalities, so the objective of this study was to visualize the in-vivo 3-dimensional anatomical relations of the SNA using dual-source computed tomography (DSCT).

METHODS AND RESULTS

In the 101 patients included in this study, the visualization rate, anatomical type and diameter of the SNA, the distance between the orifice and coronary artery, and the terminal type of SNA were recorded. The visualization rate was 95.2% (96/101). Of 96 patients, 106 SNAs were detected among which 51 (48.1%, 51/106) originated from the right coronary artery, 52 (49.1%, 52/106) from the left circumflex artery, and 3 (2.7%, 3/106) from other branches. There were 3 types of SNA: right (n = 52), left (n = 45), and posterior (n = 9). The distance between the orifice of the right SNA and the right coronary sinus was 14.2+/-15.2 mm, for the left SNA it was 5.5+/-3.5 mm, and for the posterior SNA, 33.7+/-12.8 mm. The average diameter was 1.27+/-0.29 mm. The SNA approached the nodal tissue by 1 of 3 routes: retrocaval (51.5%), precaval (25.2%), or pericaval (22.3%).

CONCLUSION

The SNA can be visualized in vivo using DSCT, which is important for preoperative knowledge of its origin, course, termination, and anatomical type.