Effectiveness of a microabrasion technique using 16% HCL with manual application on fluorotic teeth: A series of studies

Efficacy of Different Solvents for Achieving Patency in Teeth Obturated Using Bioceramic Sealer

INTRODUCTION

The retreatment of teeth obturated with bioceramic sealers has been shown to be challenging. The purpose of this study was to compare the efficacy of 10% formic acid (FA), 20% hydrochloric acid (HCl), and chloroform for achieving patency in teeth obturated with a bioceramic sealer.

METHODS

Forty-five extracted single-canal teeth were instrumented and obturated 1.5 mm short of the working length using gutta-percha and EndoSequence BC Sealer (Brasseler USA, Savannah, GA). Two weeks later, gutta-percha was removed, and apical patency was attempted with a 10 C-file and a solvent (FA, HCl, or chloroform). The time to gain patency through EndoSequence BC Sealer was recorded. Five additional teeth were irrigated with the solvents, and scanning electron microscopy was used to evaluate the effect of solvents on the dentin. The Kruskal-Wallis and Mann-Whitney tests were used for statistical analysis.

RESULTS

Patency was achieved in all canals, except for 1 in the chloroform group. Regarding the time to achieve patency, no significant difference was noted between chloroform and FA (P > .05). However, there was a significant difference between chloroform and HCl (P < .05) and between FA and HCl (P < .05). The erosion of dentinal tubules was more evident when HCl was used compared with the other irrigants.

CONCLUSIONS

Twenty percent HCl was superior to 10% FA and chloroform in achieving patency in teeth obturated with EndoSequence BC Sealer. Regardless of the solvent used, patency may be achieved for most of the cases obturated with gutta-percha and EndoSequence BC Sealer.

Weight-loss and surface roughness of enamel after microabrasion procedure with different agents

Abstract Introduction Enamel microabrasion is achieved by abrasion of the enamel surface and it is a quick, practical and efficient procedure. Objective It was assessed the weight loss and surface aspect of enamel after microabrasion procedures with commercial and mixtures made in-office. Material and method Eighty bovine incisors were divided into four groups (n=10): OpalustreTM (6.6% HCl + silicon carbide); Whiteness RMTM (6% HCl + silicon carbide); 37% H3PO4 + pumice and 10% HCl + pumice. Treatment was performed by 15 applications of 10s duration. The enamel weight loss was determined by the difference in weight before and after the microabrasion. The surfaces were analyzed by a surface roughness equipment and scanning electron microscopy. Data were submitted to paired-T test, one-way ANOVA and Tukey tests (α=0.05). Result It was observed significantly weight loss for all groups. The difference in weight loss ranged from 0.037±0.012 for group 37% H3PO4 and from 0.054±0.009 for group 6,6% HCl. There was a significant increase in surface roughness for all groups and 10% HCl group showed the lower results (0.65±0.09). It was observed different patterns of enamel morphology by SEM images. Conclusion The in-office mixtures resulted in the lowest enamel structure loss (37% H3PO4) and the lowest surface roughness (10% HCl).