Vancomycin powder in total joint replacement

Vancomycin powder in the prevention of infection in primary knee and hip arthroplasty: Case-control study with 1151 arthroplasties

BACKGROUND AND OBJECTIVE

Vancomycin powder (VP) has been positively used in spinal surgery to reduce the rate of infections. Hardly any data have been published on hip and knee joint replacement surgery, and its usefulness is questioned. Our objective was to investigate the effectiveness of VP in reducing prosthetic infection and its possible complications.

METHODS

Primary hip (THA) and knee (TKA) arthroplasties were reviewed, performed by five surgeons in one hospital center, between 2017 and 2018. 1g of VP was used on the implant prior to surgical closure based on the surgeon's preferences. With a 5-year follow-up in which the infection rate and local complications were analyzed.

RESULTS

One thousand one hundred and fifty one arthroplasties were performed, 748 were TKA and 403 were THA. Nine patients were diagnosed with prosthetic infection, of which five received VP and four did not (P=.555). Likewise, another 15 patients suffered wound complications, of which 11 received VP and 4 did not (P=.412). There were no differences, either, in the rest of the complications depending on the use or not of VP (P=.101). Likewise, the number of patients who needed reintervention was similar (P=.999). No systemic complications were detected due to the use of VP.

CONCLUSIONS

It has not been possible to demonstrate that the use of VP reduces the rates of prosthetic infection in the hip and knee, so we cannot recommend its use.

[Translated article] Vancomycin powder in the prevention of infection in primary knee and hip arthroplasty: Case-control study with 1151 arthroplasties

BACKGROUND AND OBJECTIVE

Vancomycin powder (VP) has been positively used in spinal surgery to reduce the rate of infections. Hardly any data have been published on hip and knee joint replacement surgery, and its usefulness is questioned. Our objective was to investigate the effectiveness of VP in reducing prosthetic infection and its possible complications.

METHODS

Primary hip (THA) and knee (TKA) arthroplasties were reviewed, performed by five surgeons in one hospital centre, between 2017 and 2018. One gram of VP was used on the implant prior to surgical closure based on the surgeon's preferences. With a 5-year follow-up in which the infection rate and local complications were analysed.

RESULTS

One thousand one hundred and fifty-one arthroplasties were performed, 748 were TKA and 403 were THA. Nine patients were diagnosed with prosthetic infection, of which five received VP and four did not (p=0.555). Likewise, another 15 patients suffered wound complications, of which 11 received VP and 4 did not (p=0.412). There were no differences, either, in the rest of the complications depending on the use or not of VP (p=0.101). Likewise, the number of patients who needed reintervention was similar (p=0.999). No systemic complications were detected due to the use of VP.

CONCLUSIONS

It has not been possible to demonstrate that the use of VP reduces the rates of prosthetic infection in the hip and knee, so we cannot recommend its use.

Triple Encapsulation and Controlled Release of Vancomycin, Rifampicin and Silver from Poly (Methyl Methacrylate) or Poly (Lactic-Co-Glycolic Acid) Nanofibers

Although the incidence of infections in orthopedic surgeries, including periprosthetic surgeries, remains low at approximately 1-2%, the number of surgeries and the incidence of drug-resistant bacteria is increasing. The cost and morbidity associated with revision surgeries are huge. More effective drug combinations and delivery methods are urgently needed. In this paper, three anti-infective drugs (vancomycin, rifampicin, and silver sulfadiazine) have been jointly and effectively electrospun in thin (0.1 mm) flexible nanofiber mats of either poly (methyl methacrylate) (PMMA) or poly (lactic-co-glycolic acid) (PLGA). The inclusion of poly (ethylene glycol) (PEG) enabled optimal drug release with a reduced water contact angle for wetting. The controlled release of these three agents from 20% PEG (w/w to polymer)-blended PMMA or PLGA nanofiber mats may allow for the prophylactical prevention of implant-related infections or provide methods to treat orthopedic infections at the time of revision surgeries. These combinations of drugs provide excellent additive or synergistic antibiotic action against a broader spectrum of bacteria than each drug alone.

Intelligent and Bioactive Osseointegration of the Implanted Piezoelectric Bone Cement with the Host Bone Is Realized by Biomechanical Energy

Poly methyl methacrylate (PMMA) bone cement is widely used in orthopedic surgeries, including total hip/knee arthroplasty and vertebral compression fracture treatment. However, loosening due to bone resorption is a common mid-to-late complication. Therefore, developing bioactive bone cement that promotes bone growth and integration is key to reducing aseptic loosening. In this study, we developed a piezoelectric bone cement comprising PMMA and BaTiO3 with excellent electrobioactivity and further analyzed its ability to promote bone integration. Experiments demonstrate that the PMMA and 15 wt % BaTiO3 cement generated an open-circuit voltage of 37.109 V under biomimetic mechanical stress, which effectively promoted bone regeneration and interfacial bone integration. In vitro experiments showed that the protein expression levels of ALP and RUNX-2 in the 0.65 Hz and 20 min group increased by 1.74 times and 2.31 times. In vivo experiments confirmed the osteogenic ability of PMMA and 15 wt % BaTiO3, with the increment of bone growth in the non-movement and movement groups being 4.67 and 4.64 times, respectively, at the second month after surgery. Additionally, Fluo-4 AM fluorescence staining and protein blotting experiments verified that PMMA and 15 wt % BaTiO3 electrical stimulation promoted osteogenic differentiation of BMSCs by activating calcium-sensitive receptors and increasing calcium ion inflow by 1.41 times when the stimulation reached 30 min. Therefore, piezoelectric bioactive PMMA and 15 wt % BaTiO3 cement has excellent application value in orthopedic surgery systems where stress transmission is prevalent.