Remote sensing of the Earth's atmosphere from space with high-resolution Fourier-transform spectroscopy: development and methodology of data processing for the Atmospheric Trace Molecule Spectroscopy experiment

Simulations of the accuracy in retrieving stratospheric aerosol effective radius, composition, and loading from infrared spectral transmission measurements

We examine the extent to which three physical aerosol parameters--effective radius, composition (sulfate weight percent), and total volume-can be determined from infrared transmission spectra. Using simulated transmission data over the range 800-4750 cm(-1) (12.5-2.1 microm) and errors taken from the infrared spectral measurements of the Atmospheric Trace Molecule Spectroscopy (ATMOS) instrument, we use optimal estimation to recover these aerosol parameters. Uncertainties in these are examined as a function of the size, composition, and loading of stratospheric aerosols and of the spectral range employed. Using the entire spectral range above, we retrieve all three parameters with a precision to within 3% if the size distribution form is known. Additional errors result, however, from an uncertainty in the size distribution width. These are small (only a few percent) for composition and total volume but are substantial (as much as 50%) for effective radius. Errors also increase substantially when the spectral range is reduced. The retrieved effective radius can have an error of 100% or greater for typical stratospheric aerosol sizes when the spectral range is restricted to the lower wavenumber part of the range. For good accuracy in effective radius, the spectral range must extend beyond approximately 3000 cm(-1). Composition and total volume are less sensitive to the spectral range than effective radius. These simulations were carried out with modeled data to test the potential accuracy of stratospheric sulfate aerosol retrievals from the Atmospheric Chemistry Experiment (ACE). Because of the limitations that result from the use of simulated data, we have tested our retrieval algorithm using ATMOS spectra in different filter regions and present here the aerosol parameters obtained.

Retrieval of trace gases from aerosol-influenced infrared transmission spectra observed by low-spectral-resolution Fourier-transform spectrometers

A method for the simultaneous retrieval of gas concentrations and an extinction spectrum of aerosols and polar stratospheric clouds from infrared transmission spectra observed in the solar occultation geometry is described. It is particularly suited to measurements by Fourier-transform spectrometers with relatively low spectral resolution (0.1-1 cm(-1)). The method does not require a priori assumptions on aerosol properties; it utilizes only the fact that the wave-number dependence of aerosol extinction is much weaker than that of gas absorption. In this method, an aerosol extinction spectrum is approximated by a straight line within a relatively wide spectral range defined as mediumwindow.

Atmospheric Trace Molecule Spectroscopy (ATMOS) Experiment Version 3 data retrievals

Version 3 of the Atmospheric Trace Molecule Spectroscopy (ATMOS) experiment data set for some 30 trace and minor gas profiles is available. From the IR solar-absorption spectra measured during four Space Shuttle missions (in 1985, 1992, 1993, and 1994), profiles from more than 350 occultations were retrieved from the upper troposphere to the lower mesosphere. Previous results were unreliable for tropospheric retrievals, but with a new global-fitting algorithm profiles are reliably returned down to altitudes as low as 6.5 km (clouds permitting) and include notably improved retrievals of H2O, CO, and other species. Results for stratospheric water are more consistent across the ATMOS spectral filters and do not indicate a net consumption of H2 in the upper stratosphere. A new sulfuric-acid aerosol product is described. An overview of ATMOS Version 3 processing is presented with a discussion of estimated uncertainties. Differences between these Version 3 and previously reported Version 2 ATMOS results are discussed. Retrievals are available at http://atmos.jpl.nasa.gov/atmos.

Pressure sounding of the middle atmosphere from ATMOS solar occultation measurements of atmospheric CO(2) absorption lines

A method for retrieving the atmospheric pressure corresponding to the tangent point of an infrared spectrum recorded in the solar occultation mode is described and applied to measurements made by the Atmospheric Trace Molecule Spectroscopy (ATMOS) Fourier-transform spectrometer. Tangent pressure values are inferred from measurements of isolated CO(2) lines with temperature-insensitive strengths by measuring the slant-column CO(2) amount and by adjusting the viewing geometry until the calculated column matches the observed column. Tangent pressures are determined with a spectroscopic precision of l%-3%, corresponding to a tangent-point height precision of 70-210 m. The total uncertainty is limited primarily by the quality of the spectra and ranges between 4% and 6% (280-420 m) for spectra with signal-to-noise ratios of 300:1 and between 4% and 10% for spectra with signal-to-noise ratios of 100:1. The retrieval of atmospheric pressure increases the accuracy of the retrieved-gas concentrations by minimizing the effect of systematic errors introduced by climatological pressure data, ephemeris parameters, and the uncertainties in instrumental pointing.

Observations of the infrared solar spectrum from space by the ATMOS experiment

The final flight of the Atmospheric Trace Molecule Spectroscopy experiment as part of the Atmospheric Laboratory for Applications and Science (ATLAS-3) Space Shuttle mission in 1994 provided a new opportunity to measure broadband (625-4800 cm(-1), 2.1-16 µm) infrared solar spectra at anunapodized resolution of 0.01 cm(-1) from space. The majority of the observations were obtained as exoatmospheric, near Sun center, absorption spectra, which were later ratioed to grazing atmospheric measurements to compute the atmospheric transmission of the Earth's atmosphere and analyzed for vertical profiles of minor and trace gases. Relative to the SPACELAB-3 mission that produced 4800 high Sun spectra (which were averaged into four grand average spectra), the ATLAS-3 mission produced some 40,000 high Sun spectra (which have been similarly averaged) with an improvement in signal-to-noise ratio of a factor of 3-4 in the spectral region between 1000 and 4800 cm(-1). A brief description of the spectral calibration and spectral quality is given as well as the location of electronic archives of these spectra.