Angular-interrogation attenuated total reflection metrology system for plasmonic sensors

Opto-Electronic Refractometric Sensor Based on Surface Plasmon Resonances and the Bolometric Effect

The bolometric effect allows us to electrically monitor spectral characteristics of plasmonic sensors; it provides a lower cost and simpler sample characterization compared with angular and spectral signal retrieval techniques. In our device, a monochromatic light source illuminates a spectrally selective plasmonic nanostructure. This arrangement is formed by a dielectric low-order diffraction grating that combines two materials with a high-contrast in the index of refraction. Light interacts with this structure and reaches a thin metallic layer, that is also exposed to the analyte. The narrow absorption generated by surface plasmon resonances hybridized with low-order grating modes, heats the metal layer where plasmons are excited. The temperature change caused by this absorption modifies the resistance of a metallic layer through the bolometric effect. Therefore, a refractometric change in the analyte varies the electric resistivity under resonant excitation. We monitor the change in resistance by an external electric circuit. This optoelectronic feature must be included in the definition of the sensitivity and figure of merit (FOM) parameters. Besides the competitive value of the FOM (around 400 RIU − 1 , where RIU means refractive index unit), the proposed system is fully based on opto-electronic measurements. The device is modeled, simulated and analyzed considering fabrication and experimental constrains. The proposed refractometer behaves linearly within a range centered around the index of refraction of aqueous media, n ≃ 1.33 , and can be applied to the sensing for research in bio-physics, biology, and environmental sciences.

Enhancing the blinking fluorescence of single-molecule localization imaging by using a surface-plasmon-polariton-enhanced substrate

Super-resolution imaging based on single-molecule localization microscopy combined with the surface plasmon polariton (SPP)-enhanced fluorescence of spontaneously blinking fluorophores was demonstrated to visualize the nanoscale-level positioning information of cell-adhesion-associated proteins. Glass substrates with a deposited silver layer were utilized to induce a SPP-enhanced field on the silver surface and significantly strengthen the fluorescence signals of the fluorophores by more than 300%. The illumination power density for localization imaging at a spatial resolution of 25 ± 11 nm was 31.6 W cm-2. This low illumination power density will facilitate the reduction of phototoxicity of the biospecimens for single-molecule localization imaging. The proposed strategy provides a uniform distribution of the SPP-enhanced field on the silver surface, enabling visualization of the spatial distribution of labeled proteins without interference caused by the enhanced field distribution.

Sensitive voltage interrogation method using electro-optically tunable SPR sensors

A novel voltage interrogation method using electro-optically tunable waveguide-coupled surface plasmon resonance sensors is demonstrated. Before measurements, we use a bicell photodetector to detect the reflectance from the sensor and take the differential signal from the photodetector as the resonance condition. For different analytes, by scanning the DC voltage on the waveguide layer of the sensor chip, the resonance condition can be maintained the same. Under this condition, we record the values of this voltage, namely the resonant voltage. Theoretical calculations and experimental results show the resonant voltage has a highly linear and sensitive response to analyte's refractive index. This method is simple in configuration, and complicated signal processing algorithms can be avoided.

Recent developments and applications of hybrid surface plasmon resonance interfaces in optical sensing

Nanostructured noble metals exhibit an intense optical near field due to surface plasmon resonance, therefore promising widespread applications and being of interest to a broad spectrum of scientists, ranging from physicists, chemists, and materials scientists to biologists. A wealth of research is available discussing the synthesis, characterization, and application of noble metal nanoparticles in optical sensing. However, with respect to the sensitivity of the frequency and width of these surface plasmon resonance modes to the particle's shape, size, and environment, in nearly every case, success strongly depends on the availability of highly stable, adhesive, and sensitive nanoparticles. This undoubtedly presents a challenging task to nanofabrication. The past decade has witnessed fascinating advances in this field, in particular, the construction of oxide-based hybrid plasmonic interfaces to overcome the problem addressed above by (1) coating the metallic nanostructures with thin overlayers to form sandwiched structures or (2) embedding metallic nanostructures in a dielectric matrix to obtain metal/dielectric matrix nanocomposite films. In this critical review, we focus on recent work related to this field, beginning with a presentation of hybrid films with enhanced structural and optical stability, readily and selectively designed using chemical and physical techniques. We then illustrate their interesting optical properties and demonstrate exciting evidence for the postulated application in surface plasmon sensing fields. Finally, we survey the work remaining to be done for that potential to be realized.

Study of cell-biosubstrate contacts via surface plasmon polariton phase microscopy

This study utilized a developed surface plasmon polariton (SPP) phase microscopy to observe cell-biosubstrate contacts. The developed SPP phase microscopy is highly sensitive to cell membrane contact with biosubstrates and also provides long-term phase stability to achieve time-lapse living cell observation. As such, an SPP intensity and phase sensitivity comparison demonstrates that the sensitivity of the phase measurement can be 100-fold greater than that of the intensity measurement. Also, a more than 2-hour cell apoptosis observation via the SPP phase microscopy is presented. To implement the incident angle from 70° to 78°, cell-biosubstrate contact images corresponding to the surface plasmon resonance (SPR) angles are obtained by utilizing the SPP phase measurement. According to the information of the corresponding SPR angle image and a multilayer simulation, the contact distances between a living melanoma cell and a bovine serum albumin substrate at four different locations have been estimated.

Hybrid differential interrogation method for sensitive surface plasmon resonance measurement enabled by electro-optically tunable SPR sensors

A novel detection method enabled by electro-optically tunable waveguide-coupled surface plasmon resonance sensors is demonstrated. Both the WCSPR response of sensor and the interrogation light are varied simultaneously in this hybrid scheme. Modulation and demodulation of the sensor's response are achieved by applying a high-frequency AC electrical signal and electrically filtering the detected signal. Scanning the incident angle at a lower speed yields an angular dependent response. Theoretical analyses and experimental results show that the angular-dependent signal is closely related to the derivative of the SPR reflectivity with a sharp, linear jump near the minimum of the SPR peak. Thus, simple linear-fitting and zero-finding algorithms can be used to locate the SPR angle, and sophisticated data processing algorithms and electronic hardware can be avoided.

Plasmon-controlled fluorescence towards high-sensitivity optical sensing

Fluorescence spectroscopy is widely used in chemical and biological research. Until recently most of the fluorescence experiments have been performed in the far-field regime. By far-field we imply at least several wavelengths from the fluorescent probe molecule. In recent years there has been growing interest in the interactions of fluorophores with metallic surfaces or particles. Near-field interactions are those occurring within a wavelength distance of an excited fluorophore. The spectral properties of fluorophores can dramatically be altered by near-field interactions with the electron clouds present in metals. These interactions modify the emission in ways not seen in classical fluorescence experiments. Fluorophores in the excited state can create plasmons that radiate into the far-field and fluorophores in the ground state can interact with and be excited by surface plasmons. These reciprocal interactions suggest that the novel optical absorption and scattering properties of metallic nanostructures can be used to control the decay rates, location, and direction of fluorophore emission. We refer to these phenomena as plasmon-controlled fluorescence (PCF). An overview of the recent work on metal-fluorophore interactions is presented. Recent research combining plasmonics and fluorescence suggest that PCF could lead to new classes of experimental procedures, novel probes, bioassays, and devices.

Plasmon-controlled fluorescence: a new paradigm in fluorescence spectroscopy

Fluorescence spectroscopy is widely used in biological research. Until recently, essentially all fluorescence experiments were performed using optical energy which has radiated to the far-field. By far-field we mean at least several wavelengths from the fluorophore, but propagating far-field radiation is usually detected at larger macroscopic distances from the sample. In recent years there has been a growing interest in the interactions of fluorophores with metallic surfaces or particles. Near-field interactions are those occurring within a wavelength distance of an excited fluorophore. The spectral properties of fluorophores can be dramatically altered by near-field interactions with the electron clouds present in metals. These interactions modify the emission in ways not seen in classical fluorescence experiments. In this review we provide an intuitive description of the complex physics of plasmons and near-field interactions. Additionally, we summarize the recent work on metal-fluorophore interactions and suggest how these effects will result in new classes of experimental procedures, novel probes, bioassays and devices.

Coupled waveguide–surface plasmon resonance biosensor with subwavelength grating

This study develops a coupled waveguide-surface plasmon resonance (CWSPR) biosensor with a subwavelength grating structure for the real-time analysis of biomolecular interactions. In the proposed optical metrology system, normally incident white light is coupled into the waveguide layer through the subwavelength grating structure thereby enhancing the wave vector which excites the surface plasmons on the metal sensing surface. The proposed CWSPR biosensor not only retains the same sensing sensitivity as that of a conventional surface plasmon resonance device, but also yields a sharper dip in the reflectivity spectrum and therefore provides an improved measurement precision. Moreover, the metrology setup overcomes the limitations of the conventional Kretschmann attenuated total reflection approach and is less sensitive to slight variations in the angle of the incident light. The experimental results confirm that the current CWSPR biosensor provides a straightforward yet powerful technique for real-time biomolecular interaction analysis.

Precise determination of the dielectric constant and thickness of a nanolayer by use of surface plasmon resonance sensing and multiexperiment linear data analysis

Surface plasmon resonance (SPR) sensing and an enhanced data analysis technique are used to obtain precise predictions of the dielectric constant and thickness of a nanolayer. In the proposed approach, a modified analytical method is used to obtain initial estimates of the dielectric constants and thicknesses of the metal film and a nanolayer on the sensing surface of a SPR sensor. A multiexperiment data analysis approach based on a two-solvent SPR method is then employed to improve the initial estimates by suppressing the noise in the measurement data. The proposed two-stage approach is employed to determine the dielectric constant and thickness of a molecular imprinting polymer nanolayer. It is found that the results are in good agreement with those obtained with an ellipsometer and a high-resolution scanning electron microscope.

Immunodetection of pentamer and modified C-reactive protein using surface plasmon resonance biosensing

In clinical practices, the examination of pentamer C-reactive protein (pCRP) is commonly used as a prognostic indicator of the risk of a patient developing cardiovascular disease (CVD). Structural modification of pCRP produces a modified CRP (mCRP) which exhibits different biological activities in the body. In recent years, mCRP has come to be regarded as a more powerful inducer than pCRP, and hence mCRP measurement has emerged as an important indicator for assessing the risk of developing CVD. The surface plasmon resonance (SPR) biosensing technique can be employed to increase the detection accuracy and real-time response when sensing pCRP or mCRP. In this study, three monoclonal antibodies (Mabs), C8, 8D8, and 9C9, are immobilized on a protein G layer for subsequent CRP detection. The experimental results reveal that the Mab C8 reacts with both pCRP and mCRP, the Mab 8D8 with pCRP, and the Mab 9C9 with mCRP. No false signals caused by non-specific binding are observed. When detecting pCRP using Mab C8, the SPR bioassay provides sufficient sensitivity to evaluate whether or not a patient is at risk of developing CVD. SPR biosensing provides a viable and accurate approach for the real-time evaluation of pCRP and mCRP levels, and is therefore of considerable benefit in clinical examinations of CPR.