Double pulse laser-induced breakdown spectroscopy of bulk aqueous solutions at oceanic pressures: interrelationship of gate delay, pulse energies, interpulse delay, and pressure

Detection of Low Lithium Concentrations Using Laser-Induced Breakdown Spectroscopy (LIBS) in High-Pressure and High-Flow Conditions

This paper describes the effects of laser pulse rate and solution flow rate on the determination of lithium at high pressure for water and 2.5% sodium chloride solutions using laser-induced breakdown spectroscopy (LIBS). Preliminary studies were performed with 0-40 mg L^-1 Li solutions, at ambient pressure and at 210 bar, and in static and flowing (6 mL · min^-1) regimes, for a combination of four different measurement conditions. The sensitivity of calibration curves depended on the pressure and the flow rate, as well as the laser pulse rate. The sensitivity of the calibration curve increased about 10% and 18% when the pressure was changed from 1 to 210 bar for static and flowing conditions, respectively. However, an effect of flow rate at high pressure for both 2 and 10 Hz laser pulse rates was observed. At ambient pressure, the effect of flow rate was negligible, as the sensitivity of the calibration curve decreased around 2%, while at high pressure the sensitivity increased around 4% when measurements were performed in a flow regime. Therefore, it seems there is a synergistic effect between pressure and flow rate, as the sensitivity increases significantly when both changes are considered. When the pulse rate is changed from 2 to 10 Hz, the sensitivity increases 26-31%, depending on the pressure and flow conditions. For lithium detection limit studies, performed with a laser pulse energy of 2.5 mJ, repetition rate of 10 Hz, gate delay of 500 ns, gate width of 1000 ns, and 1000 accumulations, a value around 40 µg L^-1 was achieved for Li solutions in pure water for all four measurement conditions, while a detection limit of about 92 µg L^-1 was determined for Li in 2.5% sodium chloride solutions, when high pressure and flowing conditions were employed. The results obtained in the present work demonstrate that LIBS is a powerful tool for the determination of Li in deep ocean conditions such as those found around hydrothermal vent systems.

Mineral carbonate dissolution with increasing CO2 pressure measured by underwater laser induced breakdown spectroscopy and its application in carbon sequestration

In this study, the ability of laser-induced breakdown spectroscopy (LIBS) to measure the in situ aqueous dissolution of various mineral carbonates with increasing CO₂ pressure was examined. Dissolution experiments included four geologically common mineral carbonates (CaCO₃, MgCO₃, MnCO₃, SrCO₃) and the CO₂ pressure ranged from ambient to 250 bar. The ensuing plasma emission was spectrally analyzed, and the intensities of Ca, Mg, Mn, and Sr emission lines were used to monitor the respective metal cations released to the aqueous solution. The strong emission lines of Ca (Ca II 393.36, Ca II 396.84, Ca I 422.67 nm), Mg (unresolved magnesium doublet: Mg I 383.230, Mg I 383.829 nm), Mn (unresolved manganese triplet: Mn I 403.076, Mn I 403.307, Mn I 403.449 nm), and Sr (Sr II 407.77, Sr II 421.55, Sr I 460.73 nm) were identified in the spectra. The amounts of metals released from their respective carbonates were estimated at different time intervals following the CO₂ injection (5 m, 1, 2, 3, 4, 24 h) and at different pressures (50, 100, 150, 200, 250 bar) using calibration models developed at corresponding pressure settings. The results demonstrated that the pressure-induced dissolution of all carbonates was consistent with their expected and selective pH-dependent solubility. The dissolution rate of CaCO₃, MgCO₃, and SrCO₃ was found to be higher than that of MnCO₃. The dissolution of constituents in a Mt. Simon sandstone associated with a deep saline reservoir at elevated CO₂ pressure was also studied and Ca release was quantified. The results demonstrated that real-time monitoring of carbonate dissolution by LIBS may provide a useful indirect detection system indicative of CO₂ leakage from geologic carbon storage sites.

Underlying Physical Process for the Unusual Spectral Quality of Double Pulse Laser Spectroscopy in He Gas

This study is aimed at elucidating the physical processes responsible for the excellent spectral qualities in terms of full width at half-maximum (fwhm) and signal-to-noise (S/N) ratio shown in a special double pulse laser-induced spectroscopy. Apart from the use of atmospheric He ambient gas, the achievement is due to the first laser for generating He gas plasma and the subsequent use of the second laser pulse for target ablation, in opposite order of the two-laser operations in conventional double pulse LIBS. This setup allows adjustments of the many experimental parameters to yield the optimal condition resulting in 0.03 nm fwhm and around 1000× S/N ratio of Cu I 521.8 nm and far surpasses the spectral qualities obtained by other techniques. This is obtained by allowing the crucial separation of the target plasma from the He gas plasma and thereby enabling the He-assisted excitation (HAE) to play its full and unique role of nonthermal excitation, taking advantage of metastable excited He atoms in the He plasma and the Penning-like energy transfer process. This excellent performance is further verified by its successful application analysis of Cr in low alloy steel samples, with the presence of smooth linear calibration lines, signifying the absence of the self-absorption effect well-known in ordinary LIBS.

H-D Analysis Employing Energy Transfer from Metastable Excited-State He in Double-Pulse LIBS with Low-Pressure He Gas

A laser-induced-breakdown-spectroscopy (LIBS) experiment with a unique double-pulse setup and operated in low-pressure (3 kPa) He ambient gas is performed to study the detection of light elements, such as hydrogen (H) and deuterium (D), as well as elements of high excitation energies, such as fluorine (F) and chlorine (Cl), which are usually difficult to detect using ordinary LIBS techniques. A nanosecond Nd:YAG laser operated in its fundamental wavelength with energy of 54 mJ is focused onto the Al target to generate the He plasma. Another picosecond Nd:YAG laser operated in its fundamental wavelength with energy of 2 mJ is focused onto the sample surface and activated 2 μs before the operation of the nanosecond laser. The application to polyvinyl chloride (PVC) and polytetrafluoroethylene (PTFE) samples produces sharp and high-intensity Cl- and F-emission lines. Meanwhile, the sharp and well-resolved H-D-emission lines with merely 0.18 nm wavelength separation are also clearly detected from a zircaloy sample. Further measurement of a set of zircaloy samples containing different concentrations of D yields a linear calibration curve with a zero intercept. The detection limit of D is found to be about 10 ppm.

Laser-induced breakdown spectroscopy (LIBS), part II: review of instrumental and methodological approaches to material analysis and applications to different fields

The first part of this two-part review focused on the fundamental and diagnostics aspects of laser-induced plasmas, only touching briefly upon concepts such as sensitivity and detection limits and largely omitting any discussion of the vast panorama of the practical applications of the technique. Clearly a true LIBS community has emerged, which promises to quicken the pace of LIBS developments, applications, and implementations. With this second part, a more applied flavor is taken, and its intended goal is summarizing the current state-of-the-art of analytical LIBS, providing a contemporary snapshot of LIBS applications, and highlighting new directions in laser-induced breakdown spectroscopy, such as novel approaches, instrumental developments, and advanced use of chemometric tools. More specifically, we discuss instrumental and analytical approaches (e.g., double- and multi-pulse LIBS to improve the sensitivity), calibration-free approaches, hyphenated approaches in which techniques such as Raman and fluorescence are coupled with LIBS to increase sensitivity and information power, resonantly enhanced LIBS approaches, signal processing and optimization (e.g., signal-to-noise analysis), and finally applications. An attempt is made to provide an updated view of the role played by LIBS in the various fields, with emphasis on applications considered to be unique. We finally try to assess where LIBS is going as an analytical field, where in our opinion it should go, and what should still be done for consolidating the technique as a mature method of chemical analysis.

Laser induced breakdown spectroscopy for elemental analysis in environmental, cultural heritage and space applications: a review of methods and results

Analytical applications of Laser Induced Breakdown Spectroscopy (LIBS), namely optical emission spectroscopy of laser-induced plasmas, have been constantly growing thanks to its intrinsic conceptual simplicity and versatility. Qualitative and quantitative analysis can be performed by LIBS both by drawing calibration lines and by using calibration-free methods and some of its features, so as fast multi-elemental response, micro-destructiveness, instrumentation portability, have rendered it particularly suitable for analytical applications in the field of environmental science, space exploration and cultural heritage. This review reports and discusses LIBS achievements in these areas and results obtained for soils and aqueous samples, meteorites and terrestrial samples simulating extraterrestrial planets, and cultural heritage samples, including buildings and objects of various kinds.