Synchrotron infrared reflectivity measurements of iron at high pressures

Optical properties and structural phase transitions of W-doped VO2(R) under pressure

The structure transition sequence of W–VO₂(R) nanoparticles follows rutile (R) → orthorhombic (CaCl₂-type) → monoclinic (Mx) within metallic phases.

The pressure-induced metallization of monoclinic vanadium dioxide

The structure transition sequence follow M₁ → M'₁ → X, the PIM in M′₁ phase occurs at 43.2 GPa and mainly driven by electron-correlation.

Note: visible reflectivity system for high-pressure studies

A near-normal visible reflectivity system was constructed for investigating the optical properties of materials at high pressure and temperatures. The system consists of focusing optics, spectrometers, and imaging cameras for use with a resistively-heated membrane-controlled diamond anvil cell (DAC). The DAC allows optical access on two sides: one dedicated to pressure measurement via fluorescence, the other side dedicated to absolute reflectance measurements. With this configuration, pressure and temperature may be controlled and measured without disturbing the sample position, permitting quantitative reflectivity measurements as a function of thermodynamic state variables. The system was tested on gold at high pressure conditions, and compared to data obtained on a commercial ellipsometer system at 1 bar.

High pressure ellipsometry: a novel method for measuring the optical properties and electronic structure of materials in diamond anvil cells

High pressure ellipsometry (HPE) method was developed for determining the index of refraction of opaque materials in a diamond anvil cell (DAC). A main difficulty in DAC-based HPE, namely, the pressure-induced birefringence developed in the diamond, was overcome enabling the extraction of the ellipsometric parameters of the sample. The method used was based on the fact that an unpolarized light is unaffected by a retarding optical element and thus reduces the number of unknown parameters in the problem. Because of technical difficulties in using unpolarized light, a linear combination of orthogonal polarizations was applied. In the experimental procedure, multiangle measurements of the ellipsometric parameter ψ are collected at each pressure and the data is fitted together with a measurement of the near normal reflectivity, in order to extract the complex index of refraction. As a test case, this procedure was used to measure the high pressure index of refraction of iron up to 30 GPa for light with wavelengths of 532 and 633 nm. From the index of refraction as a function of pressure the diamond-iron interface emissivity for different pressures was derived and from which the phase transition α → ε could be identified and characterized. The emissivity increases with pressure both at the α (0-9 GPa) and the ε phase (21-30 GPa) however decreases at the mixed α - ε (9-21 GPa) range. From the imaginary part of the index of refraction the pressure dependence of the energy skin depth of iron was extracted. It was found that the energy skin depth increases by an order of magnitude at 30 GPa relative to ambient conditions.

Anomalous optical and electronic properties of dense sodium

Synchrotron infrared spectroscopy on sodium shows a transition from a high reflectivity, nearly free-electron metal to a low-reflectivity, poor metal in an orthorhombic phase at 118 GPa. Optical spectra calculated within density functional theory (DFT) agree with the experimental measurements and predict a gap opening in the orthorhombic phase at compression beyond its stability field, a state that would be experimentally attainable by appropriate choice of pressure-temperature path. We show that a transition to an incommensurate phase at 125 GPa results in a partial recovery of good metallic character up to 180 GPa, demonstrating the strong relationship between structure and electronic properties in sodium.