Bimetallic chips for a surface plasmon resonance instrument

Influence of the configuration of metal sensing layers on the performance of a bimetallic (Ag-Cu) surface plasmon resonance biosensor

Bimetallic surface plasmon resonance (SPR) sensors have the potential to overcome the drawbacks of individual metals, but the effect of the configuration of the two metallic layers on the performance of the sensors has not been explored. This study examines the influence of different positions of a thin layer of silver in relation to a copper layer on the sensitivity of such a bimetallic SPR sensor. The design of this configuration aims to improve the SPR reflectance curve and strengthen the evanescent electric field to improve the sensor efficiency. Our findings indicate that, by optimizing the architectures of SPR sensors and using a silver-copper bimetallic structure, we can achieve superior performance compared to devices that utilize only silver or copper. The optimized Ag (5 nm)/Cu (55 nm) sensor design, with the best sensitivity of 299.09° RIU-1, can detect a change of 0.43°/(g dl-1) for hemoglobin in blood, 0.35°/(g dl-1) for glucose in urine, and 0.1°/(%) for methanol in ethanol. We also demonstrate the importance of signal quality by introducing two new parameters that offer a better quantitative indication of the efficiency of a sensor than is obtained by using only sensitivity.

Enhanced Biosensing Activity of Bimetallic Surface Plasmon Resonance Sensor

Surface plasmon resonance (SPR) sensors present a challenge when high sensitivity and small FWHM (full width at half maximum) are required to be achieved simultaneously. FWHM is defined by the difference between the two extreme values of the independent variable at which the value of the dependent variable is equal to half of its maximum. A smaller value of FWHM indicates better accuracy of SPR measurements. Theoretically, many authors have claimed the possibility of simultaneously achieving high sensitivity and small FWHM, which in most of the cases has been limited by experimental validation. In this report, an experimental study on the improved surface plasmon resonance (SPR) characteristics of gold over silver bimetallic sensor chips of different film thicknesses is presented. A comparative study of antigen–antibody interaction of the bimetallic chip using a custom-made, low-cost, and portable SPR device based on an angular interrogation scheme of Kretschmann configuration is performed. Pulsed direct current (DC) magnetron-sputtered bimetallic films of gold over silver were used in the construction of the SPR chip. The FWHM and sensitivity of the bimetallic sensors were firstly characterized using standard solutions of known refractive index which were later immobilized with monoclonal anti-immunoglobulin G (IgG) in the construction of the SPR biochip. Spectroscopic measurements such as ultraviolet–visible light spectroscopy (UV–Vis) and Fourier-transform infrared spectroscopy (FTIR) were used for the confirmation of the immobilization of the antibody. The performance of the bimetallic SPR biochip was investigated by exposing the sensor to various concentrations of the target protein. The results indicated that the bimetallic sensors of silver/gold had a 3.5-fold reduced FWHM compared to pure gold-based sensors, indicating a higher detection accuracy. In addition, they exhibited a significant shift in resonance angle as high as 8.5 ± 0.2 due to antigen–antibody interaction, which was ~1.42-fold higher than observed for pure silver-based sensors.

Dispersion Curve Engineering of TiO₂/Silver Hybrid Substrates for Enhanced Surface Plasmon Resonance Detection

As surface plasmon resonance (SPR)-based biosensors are well translated into biological, chemical, environmental, and clinical fields, it is critical to further realize stable and sustainable systems, avoiding oxidation susceptibility of metal films—in particular, silver substrates. We report an enhanced SPR detection performance by incorporating a TiO₂ layer on top of a thin silver film. A uniform TiO₂ film fabricated by electron beam evaporation at room temperature is an effective alternative in bypassing oxidation of a silver film. Based on our finding that the sensor sensitivity is strongly correlated with the slope of dispersion curves, SPR sensing results obtained by parylene film deposition shows that TiO₂/silver hybrid substrates provide notable sensitivity improvement compared to a conventional bare silver film, which confirms the possibility of engineering the dispersion characteristic according to the incidence wavelength. The reported SPR structures with TiO₂ films enhance the sensitivity significantly in water and air environments and its overall qualitative trend in sensitivity improvement is consistent with numerical simulations. Thus, we expect that our approach can extend the applicability of TiO₂-mediated SPR biosensors to highly sensitive detection for biomolecular binding events of low concentrations, while serving a practical and reliable biosensing platform.

Detection of amyloid-β42 using a waveguide-coupled bimetallic surface plasmon resonance sensor chip in the intensity measurement mode

The waveguide-coupled bimetallic (WcBiM) surface plasmon resonance (SPR) chip had been utilized in the intensity interrogation detection mode to detect amyloid-β42 (Aβ42), a biomarker of the Alzheimer disease. The SPR reflectance curve of the WcBiM chip has the narrower full-width-at-half-maximum (FWHM) compared with the SPR reflectance curve of the conventional gold (Au) chip, resulting in the steeper gradient. For the enhancement of resolution, the light source was fixed at an angle where the slope of the reflectance curve is the steepest, and the change in the reflectance was monitored. For the detection of Aβ42, the antibody of Aβ42 (anti-Aβ42) was immobilized on the WcBiM SPR chip using the self-assembled monolayer. The SPR responses, the average changes in the reflectance to the Aβ42 at the concentrations of 100 pg/ml, 250 pg/ml, 500 pg/ml, 750 pg/ml, 1,000 pg/ml, and 2,000 pg/ml were 0.0111%, 0.0305%, 0.0867%, 0.1712%, 0.3021%, and 0.5577%, respectively, for the three replicates. From linear regression analysis, the calibration curve indicated that the SPR response had a linear relation with Aβ42 with the concentration in the range of 100 pg/ml to 2,000 pg/ml. A control experiment showed the anti-Aβ42-modified surface of the WcBiM chip had a high specificity to Aβ42. Thus, the enhanced resolution by utilizing the WcBiM SPR chip in the intensity interrogation detection mode aids the diagnosis of the Alzheimer disease by detecting the Aβ42 around the criteria concentration (500 pg/ml) without any labeling.

Stable and sensitive silver surface plasmon resonance imaging sensor using trilayered metallic structures

The silver surface plasmon resonance (SPR) sensor has long been explored due to its intrinsic sensitivity enhancement over the conventional single-layered gold SPR sensor. However, the silver SPR sensor has not been exploited for practical applications because of pronounced instability problems. We propose a novel gold-silver-gold trilayered SPR sensor chip, in which an extra buffer layer of gold is added between the silver and substrate adhesion layer (i.e., chromium) compared to the previously reported silver-gold bilayered SPR sensors. Subjected to prolonged agitation in phosphate-buffered saline (PBS) solution, the new chip exhibited high integrity according to both optical and atomic force microscopy (AFM) analysis. Having undergone repeated cycles of calibration, binding, and regeneration in various chemical solutions, 25 regions of interest (ROIs) over a 14 mm ×14 mm area were chosen and monitored by large detection area SPR microscopy; the new sensor chip exhibited stability comparable to the single gold layered SPR chip. In terms of sensing performances, over 50% increases in sensitivity and signal-to-noise ratio (S/N) than those of the single gold layered SPR chip were determined by SPR microscopy at 660 nm. Protein arrays of protein A and bovine serum albumin (BSA) on both the new chip and single-layered gold SPR chip were fabricated and underwent biomolecular interactions with human IgG, for the purpose of consistency, comparison on kinetics parameters, values from the microarray trilayered chip showed reasonable consistency with those from the single gold layered SPR chip. This study suggests that the new chip is a viable alternative to the conventional single gold layered SPR chip with improved sensing performances.

Quality assessment of SPR sensor chips; case study on L1 chips

Surface quality of the Surface Plasmon Resonance (SPR) chips is a major limiting issue in most SPR analyses, even more for supported lipid membranes experiments, where both the organization of the lipid matrix and the subsequent incorporation of the target molecule depend on the surface quality. A novel quantitative method to characterize the quality of SPR sensors chips is described for L1 chips subject to formation of lipid films, injection of membrane disrupting compounds, followed by appropriate regeneration procedures. The method consists in analysis of the SPR reflectivity curves for several standard solutions (e.g. PBS, HEPES or deionized water). This analysis reveals the decline of sensor surface as a function of the number of experimental cycles (consisting in biosensing assay and regeneration step) and enables active control of surface regeneration for enhanced reproducibility. We demonstrate that quantitative evaluation of the changes in reflectivity curves (shape of the SPR dip) and of the slope of the calibration curve provides a rapid and effective procedure for surface quality assessment. Whereas the method was tested on L1 SPR sensors chips, we stress on its amenability to assess the quality of other types of SPR chips, as well.

Micro energy dispersive x-ray fluorescence as a powerful complementary technique for the analysis of bimetallic Au/Ag/glass nanolayer composites used in surface plasmon resonance sensors

It is demonstrated that any theoretical analysis of experimental surface plasmon resonance (SPR) curves of metallic nano bilayers preferably should be accompanied by a more sensitive technique that is less prone to experimental errors. Micro energy dispersive x-ray fluorescence has been shown to be a powerful technique for predicting SPR angle and assessing Au/Ag nanolayer composite spatial homogeneity.