Interferometric adaptive optics testbed for laser pointing, wave-front control and phasing

Simple single-shot complete spatiotemporal intensity and phase measurement of an arbitrary ultrashort pulse using coherent modulation imaging

We propose a simple single-shot spatiotemporal measurement technique called coherent modulation imaging for the spatio-spectrum (CMISS), which reconstructs the full three-dimensional high-resolution characteristics of ultrashort pulses based on frequency-space division and coherent modulation imaging. We demonstrated it experimentally by measuring the spatiotemporal amplitude and phase of a single pulse with a spatial resolution of 44 µm and a phase accuracy of 0.04 rad. CMISS has good potential for high-power ultrashort-pulse laser facilities and can measure even spatiotemporally complicated pulses with important applications.

Phase control requirements of high intensity laser beam combining

Aiming at getting the general requirements of the beam combine for ignition scale laser facilities, the analytical expressions including the factors affecting the combine results are derived. The physical meanings of every part are illustrated. Based on these expressions, the effects of the factors, including the beam configuration, piston error, and tip/tilt error, are studied analytically and numerically. The results show that the beam configuration cannot affect the Strehl ratio (SR) of the combined beam, but it influences the FWHM of the main peak and the ratio of the main peak and the side peak. The beam separation should be no more than 1.24 times the individual beam width for the multibeam combine, and be close to the individual beam width for the two-beam combine as much as possible. The piston error can change the characteristics of the combine beam focus, including the peak intensity, the focal spot morphology, the fractional energy contained within a certain area, and the center of mass. For the two-beam combine, a piston error less than 2π/5 rad is suitable, and for the multibeam combine, the standard deviation of the piston error should be no more than 2π/10 rad. The tip/tilt error has a great influence on the combined results. It affects the superposition degree of the focal spots of the combined elements directly. A requirement of 0.5~1 μrad for the standard deviation of the tip/tilt error is adequate.

Measurement of the repeatability of the prompt flashlamp-induced wavefront aberration on beamlines at the National Ignition Facility

We have undertaken a measurement campaign to determine the repeatability of the prompt flashlamp-induced wavefront aberration on beamlines at the National Ignition Facility (NIF) and determine the extent to which shot-to-shot variations in this aberration may degrade the performance of a proposed adaptive optics system for the short-pulse Advanced Radiographic Capability beamline on NIF. In this paper we will describe the unique NIF configuration that was required to make this measurement, present the results of the experiment, and discuss the implications of these results for the adaptive optics system design.

Phasing beams with different dispersions and application to the petawatt-class beamline at the National Ignition Facility

In order to achieve the highest intensities possible with the short-pulse Advanced Radiographic Capability beamline at the National Ignition Facility (NIF), it will be necessary to phase the individual ARC apertures. This is made especially challenging because the design of ARC results in two laser beams with different dispersions sharing the same NIF aperture. The extent to which two beams with different dispersions can be phased with each other has been an open question. This paper presents results of an analysis showing that the different dispersion values that will be encountered by the shared-aperture beams will not preclude the phasing of the two beams. We also highlight a situation in which dispersion mismatch will prevent good phasing between apertures, and discuss the limits to which higher-order dispersion values may differ before the beams begin to dephase.

A high-resolution, adaptive beam-shaping system for high-power lasers

A high-resolution, high-precision beam-shaping system for high-power-laser systems is demonstrated. A liquid-crystal-on-silicon spatial light modulator is run in closed-loop to shape laser-beam amplitude and wavefront. An unprecedented degree of convergence is demonstrated, and important practical issues are discussed. Wavefront shaping for the applications in OMEGA EP laser is demonstrated, and other interesting examples are presented.

Villous tumors of the duodenum

Five cases of villous tumors of the duodenum are reported, all of which involve the ampulla of Vater. Three of the five lesions contained either infiltrating carcinoma or carcinoma in situ. Although preoperative endoscopic biopsy was performed on all tumors no malignancy was identified. Frozen sections done at the time of operation on the three patients with carcinoma also failed to identify malignancy. One patient underwent pancreaticoduodenectomy and four patients had local excision of the tumor. Three of the patients treated with local excision developed recurrence and two subsequently had pancreaticoduodenectomy. Because of the difficulty in making an accurate diagnosis and the chance of recurrence when local excision is employed, strong consideration should be given to pancreaticoduodenectomy as the initial form of treatment of these lesions.