Transverse motion as a source of noise and reduced correlation of the Doppler phase shift in spectral domain OCT

Speckle-dependent accuracy in phase-sensitive optical coherence tomography

Phase-sensitive optical coherence tomography (OCT) is used to measure motion in a range of techniques, such as Doppler OCT and optical coherence elastography (OCE). In phase-sensitive OCT, motion is typically estimated using a model of the OCT signal derived from a single reflector. However, this approach is not representative of turbid samples, such as tissue, which exhibit speckle. In this study, for the first time, we demonstrate, through theory and experiment that speckle significantly lowers the accuracy of phase-sensitive OCT in a manner not accounted for by the OCT signal-to-noise ratio (SNR). We describe how the inaccuracy in speckle reduces phase difference sensitivity and introduce a new metric, speckle brightness, to quantify the amount of constructive interference at a given location in an OCT image. Experimental measurements show an almost three-fold degradation in sensitivity between regions of high and low speckle brightness at a constant OCT SNR. Finally, we apply these new results in compression OCE to demonstrate a ten-fold improvement in strain sensitivity, and a five-fold improvement in contrast-to-noise by incorporating independent speckle realizations. Our results show that speckle introduces a limit to the accuracy of phase-sensitive OCT and that speckle brightness should be considered to avoid erroneous interpretation of experimental data.

Impact of a detector dead time in phase-resolved Doppler analysis using spectral domain optical coherence tomography

For any oblique sample movement containing a transverse velocity component, the commonly used linear relationship between the phase shift and the axial velocity component is erroneous for spectrometer-based optical coherence tomography (spectral domain OCT, SD-OCT). We recently proposed a new Doppler model that assumes a continuous integration of the photocurrent. In this research, we extend the model for detectors with a shutter control by taking detector dead time into account. We present the new relation between phase shift and oblique sample displacement as well as the correlation of the phases of consecutive depth scans, in dependency on the detector dead times ranging from 5% to 90%, as numerically calculated universal contour plots, which are valid for any center wavelength and sample beam size. We found that detector dead time is recommended, especially for oblique sample motion. The reason for this recommendation is the achieved linear relation between the phase shift and the axial velocity component in the velocity range relevant for in vivo measurements, despite the signal damping due to shorter exposure time of the line detector. The theoretical Doppler model is verified using a 1% Intralipid flow phantom model. Because of the results of this research, we believe future measurements in Doppler SD-OCT can be more simple and more accurate by setting a shutter control for the line detector used.

In vivo photothermal optical coherence tomography for non-invasive imaging of endogenous absorption agents

In vivo photothermal optical coherence tomography (OCT) is demonstrated for cross-sectional imaging of endogenous absorption agents. In order to compromise the sensitivity, imaging speed, and sample motion immunity, a new photothermal detection scheme and phase processing method are developed. Phase-resolved swept-source OCT and fiber-pigtailed laser diode (providing excitation at 406 nm) are combined to construct a high-sensitivity photothermal OCT system. OCT probe and excitation beam coaxially illuminate and are focused on tissues. The photothermal excitation and detection procedure is designed to obtain high efficiency of photothermal effect measurement. The principle and method of depth-resolved cross-sectional imaging of absorption agents with photothermal OCT has been derived. The phase-resolved thermal expansion detection algorithm without motion artifact enables in vivo detection of photothermal effect. Phantom imaging with a blood phantom and in vivo human skin imaging are conducted. A phantom with guinea-pig blood as absorber has been scanned by the photothermal OCT system to prove the concept of cross-sectional absorption agent imaging. An in vivo human skin measurement is also performed with endogenous absorption agents.

Imaging of nanoparticle-labeled stem cells using magnetomotive optical coherence tomography, laser speckle reflectometry, and light microscopy

Cell transplantation and stem cell therapy are promising approaches for regenerative medicine and are of interest to researchers and clinicians worldwide. However, currently, no imaging technique that allows three-dimensional in vivo inspection of therapeutically administered cells in host tissues is available. Therefore, we investigate magnetomotive optical coherence tomography (MM-OCT) of cells labeled with magnetic particles as a potential noninvasive cell tracking method. We develop magnetomotive imaging of mesenchymal stem cells for future cell therapy monitoring. Cells were labeled with fluorescent iron oxide nanoparticles, embedded in tissue-mimicking agar scaffolds, and imaged using a microscope setup with an integrated MM-OCT probe. Magnetic particle-induced motion in response to a pulsed magnetic field of 0.2 T was successfully detected by OCT speckle variance analysis, and cross-sectional and volumetric OCT scans with highlighted labeled cells were obtained. In parallel, fluorescence microscopy and laser speckle reflectometry were applied as two-dimensional reference modalities to image particle distribution and magnetically induced motion inside the sample, respectively. All three optical imaging modalities were in good agreement with each other. Thus, magnetomotive imaging using iron oxide nanoparticles as cellular contrast agents is a potential technique for enhanced visualization of selected cells in OCT.

Relation of joint spectral and time domain optical coherence tomography (jSTdOCT) and phase-resolved Doppler OCT

A variety of promising approaches for quantitative flow velocity measurement in OCT have been proposed in recent years. The question is: Which method gets the most precise flow velocity out of the interference signals detected. We have compared the promising joint spectral and time domain optical coherence tomography (jSTdOCT) and the commonly used phase-resolved Doppler OCT (DOCT) and describe the link between these two proven methods for OCT in the Fourier domain (FD OCT). First, we show that jSTdOCT can be significantly improved by calculating the center of gravity via an unbiased complex algorithm instead of detecting the maximum intensity signal of the broadened Doppler frequency spectrum. Secondly, we introduce a unified mathematical description for DOCT and jSTdOCT that differs only in one exponent and call it enhjSTdOCT. Third, we present that enhjSTdOCT has the potential to significantly reduce the noise of the velocity measurement by choosing an exponent depending on the transverse sample velocity component and the signal-to-noise ratio. EnhjSTdOCT is verified numerically and experimentally to find the optimal parameters for maximal velocity noise reduction.

Optical coherence tomography as a novel tool for in-line monitoring of a pharmaceutical film-coating process

Optical coherence tomography (OCT) is a contact-free non-destructive high-resolution imaging technique based on low-coherence interferometry. This study investigates the application of spectral-domain OCT as an in-line quality control tool for monitoring pharmaceutical film-coated tablets. OCT images of several commercially-available film-coated tablets of different shapes, formulations and coating thicknesses were captured off-line using two OCT systems with centre wavelengths of 830nm and 1325nm. Based on the off-line image evaluation, another OCT system operating at a shorter wavelength was selected to study the feasibility of OCT as an in-line monitoring method. Since in spectral-domain OCT motion artefacts can occur as a result of the tablet or sensor head movement, a basic understanding of the relationship between the tablet speed and the motion effects is essential for correct quantifying and qualifying of the tablet coating. Experimental data was acquired by moving the sensor head of the OCT system across a static tablet bed. Although examining the homogeneity of the coating turned more difficult with increasing transverse speed of the tablets, the determination of the coating thickness was still highly accurate at a speed up to 0.7m/s. The presented OCT setup enables the investigation of the intra- and inter-tablet coating uniformity in-line during the coating process.

Noise statistics of phase-resolved optical coherence tomography imaging: single-and dual-beam-scan Doppler optical coherence tomography

Noise statistics of phase-resolved optical coherence tomography (OCT) imaging are complicated and involve noises of OCT, correlation of signals, and speckles. In this paper, the statistical properties of phase shift between two OCT signals that contain additive random noises and speckle noises are presented. Experimental results obtained with a scattering tissue phantom are in good agreement with theoretical predictions. The performances of the dual-beam method and conventional single-beam method are compared. As expected, phase shift noise in the case of the dual-beam-scan method is less than that for the single-beam method when the transversal sampling step is large.

Shear flow-induced optical inhomogeneity of blood assessed in vivo and in vitro by spectral domain optical coherence tomography in the 1.3 μm wavelength range

The optical inhomogeneity of flowing blood, which appears as a waisted double fan-shaped intensity pattern inside vessels in cross-sectional optical coherence tomography (OCT) images, was investigated for the first time. High resolution spectral domain OCT in the 1.3 μm wavelength region is used to assess this inhomogeneous intravascular backscattering of light in an in vivo mouse model and flow phantom measurements. Based on a predicted alignment of the red blood cells toward laminar shear flow, an angular modulation of the corresponding backscattering cross-section inside the vessels is assumed. In combination with the signal attenuation in depth by absorption and scattering, a simple model of the intravascular intensity modulation is derived. The suitability of the model is successfully demonstrated in the in vivo experiments and confirmed by the in vitro measurements. The observed effect appears in flowing blood only and shows a strong dependency on the shear rate. In conclusion, the shear-induced red blood cell alignment in conjunction with the vessel geometry is responsible for the observed intensity distribution. This inherent effect of blood imaging has to be considered in attenuation measurements performed with OCT. Furthermore, the analysis of the intravascular intensity pattern might be useful to evaluate flow characteristics.

Swept-source based, single-shot, multi-detectable velocity range Doppler optical coherence tomography

Phase-Resolved Doppler Optical Coherence Tomography (PR-DOCT) allows visualization and characterization of the location, direction, velocity, and profile of flow activity embedded in a static sample structure. The detectable Velocity Dynamic Range (VDR) of each particular PR-DOCT system is governed by a detectable Doppler phase shift, a flow angle, and an acquisition time interval used to determine the Doppler phase shift. In general, the lower boundary of the detectable Doppler phase shift is limited by the phase stability of the system, while the upper boundary is limited by the π phase ambiguity. For a given range of detectable Doppler phase shift, shortening the acquisition duration will increase not only the maximum detectable velocity but unfortunately also the minimum detectable velocity, which may lead to the invisibility of a slow flow. In this paper, we present an alternative acquisition scheme for PR-DOCT that extends the lower limit of the velocity dynamic range, while maintaining the maximum detectable velocity, hence increasing the overall VDR of PR-DOCT system. The essence of the approach is to implement a technique of multi-scale measurement to simultaneously acquire multiple VDRs in a single measurement. We demonstrate an example of implementation of the technique in a dual VDR DOCT, where two Doppler maps having different detectable VDRs were simultaneously detected, processed, and displayed in real time. One was a fixed VDR DOCT capable of measuring axial velocity of up to 10.9 mm/s without phase unwrapping. The other was a variable VDR DOCT capable of adjusting its detectable VDR to reveal slow flow information down to 11.3 μm/s. The technique is shown to effectively extend the overall detectable VDR of the PR-DOCT system. Examples of real time Doppler imaging of an African frog tadpole are demonstrated using the dual-VDR DOCT system.

Doppler imaging with dual-detection full-range frequency domain optical coherence tomography

Most of full-range techniques for Frequency Domain Optical Coherence Tomography (FD-OCT) reported to date utilize the phase relation between consecutive axial lines to reconstruct a complex interference signal and hence may exhibit degradation in either mirror image suppression performance or detectable velocity dynamic range or both when monitoring a moving sample such as flow activity. We have previously reported a technique of mirror image removal by simultaneous detection of the quadrature components of a complex spectral interference called a Dual-Detection Frequency Domain OCT (DD-FD-OCT) [Opt. Lett. 35, 1058-1060 (2010)]. The technique enables full range imaging without any loss of acquisition speed and is intrinsically less sensitive to phase errors generated by involuntary movements of the subject. In this paper, we demonstrate the application of the DD-FD-OCT to a phase-resolved Doppler imaging without degradation in either mirror image suppression performance or detectable velocity dynamic range that were observed in other full-range Doppler methods. In order to accommodate for Doppler imaging, we have developed a fiber-based DD-FD-OCT that more efficiently utilizes the source power compared with the previous free-space DD-FD-OCT. In addition, the velocity sensitivity of the phase-resolved DD-FD-OCT was investigated, and the relation between the measured Doppler phase shift and set flow velocity of a flow phantom was verified. Finally, we demonstrate the Doppler imaging using the DD-FD-OCT in a biological sample.

Signal power decrease due to fringe washout as an extension of the limited Doppler flow measurement range in spectral domain optical coherence tomography

The recently introduced new phase-dependent Doppler model for spectral domain optical coherence tomography (SD OCT) has shown that the simple linear relation between the Doppler phase shift and the axial velocity component of an obliquely moving sample is not valid. Additionally, for nearly transverse sample motion with high velocities the phase shift will approach a constant value. Consequently, for small Doppler angles the velocity measurement range of the phase-resolved Doppler analysis is limited in SD OCT. Since these undesirable small Doppler angles can not be prevented, for example, in the in vivo 3-D measurement, we introduce a novel method extending the limited velocity detection range taking the signal power decrease due to fringe washout in SD OCT into account. The signal damping of an obliquely moving sample is presented as a function of the axial and transverse displacement by a universally valid contour plot and does not correspond simply to the sum of the axial and transverse effect. A quantitative combination of the Doppler analysis and the signal-damping method is presented with a flow phantom model. The practicability of this new combined method is presented for the blood flow of the saphenous artery in the in vivo mouse model.

Quantitative cerebral blood flow with optical coherence tomography

Absolute measurements of cerebral blood flow (CBF) are an important endpoint in studies of cerebral pathophysiology. Currently no accepted method exists for in vivo longitudinal monitoring of CBF with high resolution in rats and mice. Using three-dimensional Doppler Optical Coherence Tomography and cranial window preparations, we present methods and algorithms for regional CBF measurements in the rat cortex. Towards this end, we develop and validate a quantitative statistical model to describe the effect of static tissue on velocity sensitivity. This model is used to design scanning protocols and algorithms for sensitive 3D flow measurements and angiography of the cortex. We also introduce a method of absolute flow calculation that does not require explicit knowledge of vessel angles. We show that OCT estimates of absolute CBF values in rats agree with prior measures by autoradiography, suggesting that Doppler OCT can perform absolute flow measurements in animal models.