Indirect absorption spectroscopy using quantum cascade lasers: mid-infrared refractometry and photothermal spectroscopy

Temperature-Dependent Infrared Refractive Index of Polymers from a Calibrated Attenuated Total Reflection Infrared Measurement

We demonstrate a straightforward method by which a commonly available reference sample such as water can be used to calibrate an attenuated total internal reflection infrared absorbance measurement in order to account for the polarization of the beam incident on the internal reflecting element, and the spread of angles about the nominal angle of incidence. This enables quantitative comparison of attenuated total reflection-derived absorbance data with spectra calculated from optical constants. We then apply this calibration to the measurement of temperature-dependent absorption spectra of a polydimethylsiloxane sample. We illustrate that the extracted optical constants scale with the temperature-dependent changes in the polymer density better than the raw absorbance values on vibrational resonance.

Dual-wavelength Mach-Zehnder interferometry-assisted photothermal spectroscopy for characterization of surface contaminants

Photothermal spectroscopy (PTS) working in the mid-infrared region is an effective technique for in-situ characterization of the chemical composition of surface contaminants. The sensitivity relies on the way that the laser-induced response of the sample is detected. We present a highly-sensitive PTS assisted with a dual-wavelength Mach-Zehnder interferometer (MZI), MZI-PST in short. The MZI aims to sense all the phase delays taking place at the sample and air when the heat produced by resonance absorption of the contaminant is transferred into its surroundings and further to amplify the total phase delay to a large intensity difference of a probe beam. To guarantee a stable quadrature phase bias of the MZI working in the balanced detection mode, we employ two separate wavelengths, one for sensing and the other for phase bias feedback, to lock the working point to the quadrature point in real time. The MZI is expected to have a 7.8-fold sensitivity enhancement compared with the conventional phase-sensitive PTS in theory. The results of the proof-of-concept experiment on the olive oil contaminated on a wafer surface verify the spectral fidelity and the sensitivity enhancement as well as the capability of photothermal spectral imaging of the MZI-PST.

All-digital histopathology by infrared-optical hybrid microscopy

Optical microscopy for biomedical samples requires expertise in staining to visualize structure and composition. Midinfrared (mid-IR) spectroscopic imaging offers label-free molecular recording and virtual staining by probing fundamental vibrational modes of molecular components. This quantitative signal can be combined with machine learning to enable microscopy in diverse fields from cancer diagnoses to forensics. However, absorption of IR light by common optical imaging components makes mid-IR light incompatible with modern optical microscopy and almost all biomedical research and clinical workflows. Here we conceptualize an IR-optical hybrid (IR-OH) approach that sensitively measures molecular composition based on an optical microscope with wide-field interferometric detection of absorption-induced sample expansion. We demonstrate that IR-OH exceeds state-of-the-art IR microscopy in coverage (10-fold), spatial resolution (fourfold), and spectral consistency (by mitigating the effects of scattering). The combined impact of these advances allows full slide infrared absorption images of unstained breast tissue sections on a visible microscope platform. We further show that automated histopathologic segmentation and generation of computationally stained (stainless) images is possible, resolving morphological features in both color and spatial detail comparable to current pathology protocols but without stains or human interpretation. IR-OH is compatible with clinical and research pathology practice and could make for a cost-effective alternative to conventional stain-based protocols for stainless, all-digital pathology.

Phase-sensitive lock-in detection for high-contrast mid-infrared photothermal imaging with sub-diffraction limited resolution

Imaging of the phase output of a lock-in amplifier in mid-infrared photothermal vibrational microscopy is demonstrated for the first time in combination with nonlinear demodulation. In general, thermal blurring and heat transport phenomena contribute to the resolution and sensitivity of mid-infrared photothermal imaging. For heterogeneous samples with multiple absorbing features, if imaged in a spectral regime of comparable absorption with their embedding medium, it is demonstrated that differentiation with high contrast is achieved in complementary imaging of the phase signal obtained from a lock-in amplifier compared to standard imaging of the photothermal amplitude signal. Specifically, by investigating the relative contribution of the out-of-phase lock-in signal, information based on changes in the rate of heat transport can be extracted, and inhomogeneities in the thermal diffusion properties across the sample plane can be mapped with high sensitivity and sub-diffraction limited resolution. Under these imaging conditions, wavenumber regimes can be identified in which the thermal diffusion contributions are minimized and an enhancement of the spatial resolution beyond the diffraction limited spot size of the probe beam in the corresponding phase images is achieved. By combining relative diffusive phase imaging with nonlinear demodulation at the second harmonic, it is demonstrated that 1-μm-size melamine beads embedded in a thin layer of 4-octyl-4'-cyanobiphenyl (8CB) liquid crystal can be detected with a 1.3-μm spatial full-width at half-maximum (FWHM) resolution. Thus, imaging with a resolving power that exceeds the probe diffraction limited spot size by a factor of 2.5 is presented, which paves the route towards super-resolution, label-free imaging in the mid-infrared.

Multiple bifurcations with signal enhancement in nonlinear mid-infrared thermal lens spectroscopy

We report a novel nonlinear mid-infrared vibrational spectroscopy regime where multiple bifurcations and signal enhancement are observed in the photothermal spectrum of a 6 μm-thick layer of 4-octyl-4'-cyanobiphenyl (8CB) liquid crystal. For increasing pump power values, the nonlinear evolution of the photothermal spectrum is studied in 8CB samples initially in the crystalline and smectic-A phase and their non-equilibrium transitions are characterized with pump-probe thermal lens spectroscopy. The nonlinear photothermal phenomena can be explained by the nucleation of localized non-equilibrium transitions that leads to the formation of bubbles, which modify the thermal lensing behavior. Analysis of the multiple bifurcations reveals a universal critical exponent for these non-equilibrium dynamics that can be linked to mean field theory. We report for the first time simultaneous measurement of the photothermal signal amplitude and phase behavior in the nonlinear regime. Due to the signal enhancement and spectral narrowing observed, nonlinear photothermal behavior shows promise for improvement in sensitivity and signal contrast in mid-infrared, attractive for sample characterization in the mid-infrared.

Depth-selective photothermal IR spectroscopy of skin: potential application for non-invasive glucose measurement

Photothermal depth profiling is applied to total internal reflection enhanced photothermal deflection spectroscopy (TIR-PTDS) in order to study skin characteristicsin vivoand to improve the sensing technique for non-invasive glucose monitoring.

Vibrational mid-infrared photothermal spectroscopy using a fiber laser probe: asymptotic limit in signal-to-baseline contrast

We report on a mid-infrared photothermal spectroscopy system with a near-infrared fiber probe laser and a tunable quantum cascade pump laser. Photothermal spectra of a 6 μm-thick 4-octyl-4^'-cyanobiphenyl liquid crystal sample are measured with a signal-to-baseline contrast above 10³. As both the peak photothermal signal and the corresponding baseline increase linearly with probe power, the signal-to-baseline contrast converges to an asymptotic limit for a given pump power. This limit is independent of the probe power and characterizes the best contrast achievable for the system. This enables sensitive quantitative spectral characterization of linear infrared absorption features directly from photothermal spectroscopy measurements.

Photothermal deflectometry enhanced by total internal reflection enables non-invasive glucose monitoring in human epidermis

We present TIR-PTD spectroscopy, an IR-pump/VIS-probe method for the measurement of IR absorption spectra by means of photothermal deflectometry (PTD) enhanced by total internal reflection (TIR). It overcomes the limitations of IR spectroscopy for the study of opaque samples and allows molecular fingerprinting of IR-active liquids or solids. Another important advantage of the presented approach over traditional IR spectroscopy methods is the ability to obtain IR information by means of VIS detection, which is generally much cheaper and easier to handle than IR detection. By application of mid-IR TIR-PTD spectroscopy on human skin in vivo, we are demonstrating the correlation between epidermal- and blood-glucose levels on a type 1 diabetic patient.

Karhunen-Loève treatment to remove noise and facilitate data analysis in sensing, spectroscopy and other applications

Resolving weak spectral variations in the dynamic response of materials that are either dominated or excited by stochastic processes remains a challenge. Responses that are thermal in origin are particularly relevant examples due to the delocalized nature of heat. Despite its inherent properties in dealing with stochastic processes, the Karhunen-Loève expansion has not been fully exploited in measurement of systems that are driven solely by random forces or can exhibit large thermally driven random fluctuations. Here, we present experimental results and analysis of the archetypes (a) the resonant excitation and transient response of an atomic force microscope probe by the ambient random fluctuations and nanoscale photothermal sample response, and (b) the photothermally scattered photons in pump-probe spectroscopy. In each case, the dynamic process is represented as an infinite series with random coefficients to obtain pertinent frequency shifts and spectral peaks and demonstrate spectral enhancement for a set of compounds including the spectrally complex biomass. The considered cases find important applications in nanoscale material characterization, biosensing, and spectral identification of biological and chemical agents.