Optomechanical entanglement under pulse drive

Highly Correlated Optomechanical Oscillations Manifested by an Anomalous Stabilization

Driven by a sufficiently powerful pump laser, a cavity optomechanical system will stabilize in coupled oscillations of its cavity field and mechanical resonator. It was assumed that the oscillation will be continuously magnified upon enhancing the driving laser further. However, based on the nonlinear dynamics of the system, we find that the dynamical behaviors of the system are much more complex than this intuitive picture, especially when it is operated near the blue detuning point by the mechanical resonator's intrinsic frequency. There exists an anomalous stabilization: depending on its intrinsic damping rate and the pump power, the mechanical resonator will metastably stay on one orbit of oscillation after another until it completely stabilizes on the final orbit it can reach. These orbits are consistent with the locked ones with almost fixed oscillation amplitudes, which are realized after the pump power becomes still higher. The oscillatory cavity field is seen to adjust its sidebands following the mechanical frequency shift due to optical spring effect, so that it always drives the mechanical resonator to near those locked orbits once the pump power is over a threshold. In the regimes with such correlation between cavity field sidebands and mechanical oscillation, the system's dynamical attractors are confined on the locked orbits and chaotic motion is also excluded.

Optomechanical force sensor operating over wide detection range

A detector with both broad operation range and high sensitivity is desirable in the measurement of weak periodic forces. Based on a nonlinear dynamical mechanism of locking the mechanical oscillation amplitude in optomechanical systems, we propose a force sensor that realizes the detection through the cavity field sidebands modified by an unknown external periodic force. Under the mechanical amplitude locking condition, the unknown external force happens to modify the locked oscillation amplitude linearly to its magnitude, thus achieving a linear scaling between the sideband changes read by the sensor and the magnitude of the force to be measured. This linear scaling range is found to be comparable to the applied pump drive amplitude, so the sensor can measure a wide range of force magnitude. Because the locked mechanical oscillation is rather robust against thermal perturbation, the sensor works well at room temperature. In addition to weak periodic forces, the same setup can as well detect static forces, though the detection ranges are much narrower.

Dynamical approach to quantum optomechanics: Motivation, method, and applications

We present an overall summary on a method to deal with quantum dynamics of optomechanical systems. The method is based on the dynamical evolution processes instead of the finally evolved steady states, which are a prerequisite to the standard approach, and well captures the features in optomechanical cooling, entanglement and other scenarios.

Cooling Effect and Cooling Speed for a Membrane-in-Middle Optomechanical System

Optomechanical systems are suitable for realizing the ground-state cooling of macroscopic objects. Based on a dynamical approach that goes beyond the validity of the standard linearization approach, we simulate the detailed cooling processes for a membrane-in-middle optomechanical system. In addition to the cooling results, we especially study the cooling speed, which is indicated by how soon the first minimum thermal phonon number is reached. Their relevance to the system parameters provides essential knowledge about how to achieve the best and/or fastest cooling under various combinations of different driving fields.

Ultra-high resolution mass sensing based on an optomechanical nonlinearity

Ultra-high resolution mass sensing used to be realized by measuring the changed mechanical oscillation frequency by a small mass that should be detected. In this work we present a different approach of mass sensing without directly measuring such mechanical frequency change but relying on the modified light field due to a previously less explored nonlinear mechanism of optomechanical interaction. The concerned optomechanical setup used for the mass sensing is driven by a sufficiently strong two-tone field satisfying a condition that the difference of these two drive frequencies matches the frequency of the mechanical oscillation, so that a nonlinear effect will come into being and lock the mechanical motion under the radiation pressure into a series of fixed orbits. A small mass attached to the mechanical resonator slightly changes the mechanical frequency, thus violating the exact frequency match condition. Such small change can be detected by the amplitude modification on the higher order sidebands of the cavity field. Even given a moderate mechanical quality factor for the setup, the added mass can still be detected to the levels corresponding to a mechanical frequency shift from 5 to 7 order less than the mechanical damping rate. Because the output cavity field difference for very close values of mechanical frequency is not blurred by thermal noise, such mass sensing can be well performed at room temperature. The previous tough requirements for ultra-high resolution mass sensing can be significantly relaxed by the method.

PT-symmetric phonon laser under gain saturation effect

As an analog of optical laser, phonon laser has potential applications in various areas. We study a type of phonon laser implemented by two coupled micro-cavities, one of which carries optical gain medium. The phonon laser operation is under a blue detuned external drive leading to dynamical instability. The saturation of the optical gain is considered, and its induced nonlinearity results in more complicated behaviors in stimulated phonon emission. To deal with such complex dynamics, we apply a composite numerical approach, in addition to a previously used dynamical approach, to the time evolution of the system. The workable phonon laser operation is found to be achievable by choosing the proper system parameters. Moreover, low threshold for the phonon laser operation is possible with the suitable coupling between the cavities and an optimum damping rate in one cavity.

Highly efficient cooling of mechanical resonator with square pulse drives

Ground state cooling of mechanical resonator is a way to generate macroscopic quantum states. Here we present a study of optomechanical cooling under the drive of square pulses without smooth profile. By illustrating the dynamical processes of cooling, we show how to choose the amplitudes and durations of square pulses, as well as the intervals between them, so that a mechanical resonator can be quickly cooled down to its ground state. Compared with the cooling under a continuous-wave drive field, the ground state cooling of a mechanical resonator can be performed more efficiently and flexibly by using square pulse drives. At certain times of such cooling process, the thermal phonon number under square pulse drives can become even lower than the theoretical limit for the cooling with a continuous-wave drive field of the same amplitude.

Entanglement dynamics in double-cavity optomechanical systems

We present a detailed study of a double-cavity optomechanical system, focusing on the dynamics of the entanglement between the cavity and mechanical modes, as well as the entanglement between two cavity modes. The discussions are based on a complete quantum approach without the standard practice of fluctuation expansion. The entanglement evolutions for various combinations of two different drives, such as those of the same blue detuning, of the same red detuning, and one red detuning and one blue detuning, are investigated. The relation of the entanglement and the rate of photon hopping between two cavities is also discussed.

Detection of genuine tripartite entanglement and steering in hybrid optomechanics

Multipartite quantum entanglement is a key resource for ensuring security in quantum network. We show that by using a unified parameter in terms of reduced noise variances one can determine different types of tripartite entanglement of a given state generated in a hybrid optomechanical system, where an atomic ensemble is located inside a single-mode cavity with a movable mirror, with different thresholds for each type. In particular, the special quantum states which allow both entanglement and steering genuinely shared among atom-light-mirror modes can be observed, even though there is no direct interaction between the mirror and the atomic ensemble. We further show the robustness against mechanical thermal noise and damping, the relaxation time of atomic ensemble, as well as the effect of gain factors involved in the criteria. Our analysis provides an experimentally achievable method to determine the type of tripartite quantum correlation in a way.