Electrically driven whispering-gallery-mode microlasers in an n-MgO@ZnO:Ga microwire/p-GaN heterojunction

Plasmonically-boosted exciton-photon coupling strength in a near-infrared LED based on a ZnO:Ga microwire/GaAs heterojunction with surface-coated Au&Ag alloy nanorods

The development of electrically-driven low-dimensional coherent light sources via highly-polarized polariton emission behavior has been extensively researched, but suffers from limited modulation of the exciton-photon coupling strengths. Herein, an electrically-biased near-infrared exciton-polariton light-emitting diode (LED), which includes a Ga-doped ZnO microwire (ZnO:Ga MW) and p-type GaAs substrate, is demonstrated. The well-designed LED structure is conducive to producing strong coupling between excitons and cavity photons, thus yielding highly-polarized light-emissions due to the optical birefringence in the ZnO:Ga MW microcavity. In particular, when the LED device is modified using Au&Ag alloy nanorods (AuAgNRs) with desired plasmonic properties, the electroluminescence (EL) performance is significantly boosted, especially the Rabi-splitting energy, which increases from 96 to 285 meV. The current-injection exciton-polariton emission from the LED undergoing a strong coupling regime is confirmed through angle-resolved EL measurements. This study exhibits a performance-boosted near-infrared exciton-polariton LED at room temperature, which provides a new scheme toward the realization of highly energy-efficient polariton coherent light sources. Further, the significantly lower density of polariton states induced by the incorporated metal nanostructures highlights a bright future of realizing ultralow-threshold polariton lasers much more feasibly, in comparison to conventional lasers based on narrow bandgap semiconductors.

Highly Monochromatic Ultraviolet LED Based on the SnO2 Microwire Heterojunction Beyond Dipole-Forbidden Band-Gap Transition

SnO2 has been extensively applied in the fields of optoelectronic devices because of its large band gap, high exciton binding energy, and outstanding optical/electrical properties. However, its applications in ultraviolet light-emitting diodes (LEDs) are still hindered by the dipole-forbidden rule. Herein, the dipole-forbidden rule can be conquered by synthesizing Sb-incorporated SnO2 microwires (SnO2:Sb MWs), which are examined by ultraviolet photoluminescence emitting at 363.2 nm and a line width of 11.3 nm. Subsequently, a highly monochromatic ultraviolet light-emitting diode (LED) based on a SnO2:Sb MW heterojunction was constructed with a p-GaN film serving as the hole supplier. In the LED, the presence of a MgO intermediate layer can modulate carrier transport and recombination path, thus achieving band-edge optical transition in the SnO2:Sb MW. As the LED is modified using Ag nanowires, electrical properties, especially for the hole injection efficiency, were dramatically boosted, contributing significantly to the device high brightness. The LED emits at 365.9 nm and a line width of 12.4 nm. Therefore, we have realized a high-brightness and narrow-band ultraviolet LED with the shortest peak wavelength never seen in previously reported SnO2 LEDs. This work will promote the potential applications of low-dimensional SnO2 optoelectronic devices and provide an effective exemplification to overcome the dipole-forbidden rule in metal-oxide materials with "forbidden" energy gaps.

Enhancing UV photodetection performance of an individual ZnO microwire p-n homojunction via interfacial engineering

As a typical broad bandgap semiconductor, ZnO has received considerable attention for developing optoelectronic devices in ultraviolet wavelengths, but suffers from a lack of high-quality single-crystalline p-type ZnO. Herein, we report the realization of a homojunction ultraviolet photodetector, which involves a p-type Sb-doped ZnO microwire (ZnO:Sb MW) and n-type ZnO layer. The p-type conductivity of the as-synthesized ZnO:Sb MWs was evidenced using an individual wire field-effect transistor. Due to its good rectifying ability and excellent photovoltaic effect, the constructed p-ZnO:Sb MW/n-ZnO homojunction is able to work as an ultraviolet photodetector in self-biased and reversely biased manners. By appropriately engineering the band alignment of the p-ZnO:Sb/n-ZnO homojunction via a MgO interface modification layer, the optimized photodetector exhibits performance-enhanced ultraviolet detection capabilities, such as the light on/off ratio reaching up to 1.6 × 10⁸, responsivity of over 267 mA W^-1 and specific detectivity of approximately 1.2 × 10¹⁴ Jones upon 365 nm light illumination at 0 V. The detector also produces faster response with rise/recovery times of 102 μs/3.6 ms. This study not only employed a novel method to synthesize genuine p-type ZnO with excellent stability and reproducibility, but also opened up substantial opportunities for developing high-performance ZnO homojunction optoelectronic devices.

Interface engineering enhanced near-infrared electroluminescence in an n-ZnO microwire/p-GaAs heterojunction

Interface engineering in the fabrication of low-dimensional optoelectronic devices has been highlighted in recent decades to enhance device characteristics such as reducing leakage current, optimizing charge transport, and modulating the energy-band structure. In this paper, we report a dielectric interface approach to realize one-dimensional (1D) wire near-infrared light-emitting devices with high brightness and enhanced emission efficiency. The light-emitting diode is composed of a zinc oxide microwire covered by a silver nanolayer (Ag@ZnO MW), magnesium oxide (MgO) buffer layer, and p-type gallium arsenide (GaAs) substrate. In the device structure, the insertion of a MgO dielectric layer in the n-ZnO MW/p-GaAs heterojunction can be used to modulate the device features, such as changing the charge transport properties, reducing the leakage current and engineering the band alignment. Furthermore, the cladding of the Ag nanolayer on the ZnO MW can optimize the junction interface quality, thus reducing the turn-on voltage and increasing the current injection and electroluminescence (EL) efficiency. The combination of MgO buffer layer and Ag nanolayer cladding can be utilized to achieve modulating the carrier recombination path, interfacial engineering of heterojunction with optimized band alignment and electronic structure in these carefully designed emission devices. Besides, the enhanced near-infrared EL and improved physical contact were also obtained. The study of current transport modulation and energy-band engineering proposes an original and efficient route for improving the device performances of 1D wire-type heterojunction light sources.

Interfacial modulation and plasmonic effect mediated high-brightness green light sources in a single Ga-doped ZnO microwire based heterojunction

Heterostructure manufacturing has been extensively studied as indispensable footstones in the progressive semiconductor optoelectronic devices due to their constituent materials, interfacial states and electronic transport capabilities, thus enabling competitive candidates...