Single-pass imaging through a thick dynamic distorter using four-wave mixing

Single beam one-way imaging through a thick dynamic turbulent medium

A new method to record an image through a thick dynamic phase distorting medium by using a photorefractive LiNbO3 crystal is demonstrated. The method uses only one beam of light, the object light. By making use of the photorefractive fanning effect, gratings are formed in the LiNbO3 crystal through the interference between the object light and its own fanning light. Because the time scale of the distorting fluctuation is much shorter than the writing time of the LiNbO3 crystal, the fluctuated light does not induce any fanning. Therefore only the static portion of the image is recorded in the crystal, and the intensity distribution of the image can then be reconstructed at any later time.

One-way imaging through a polarization-sensitive aberrator by use of an optical lock-in detection

We demonstrate one-way image compensation for a thin and polarization-sensitive aberrator by the use of optical lock-in detection. Optical lock-in detection is accomplished by dual-phase modulation in four-wave mixing in a holographic medium. In our scheme, both the image-bearing beam and the reference beam copropagate through the aberrator under the same polarization condition. The holographic grating that reconstructs only the corrected image was generated by selective recording in optical lock-in detection. The phase aberration is subtracted out in the holographic process. This scheme permits image correction through the polarization-sensitive aberrator.

Image transmission through a thick dynamic distorter by the photorefractive fanning effect

A new method of one-way image transmission through a thick dynamic distorter without the need for a reference beam or four-wave mixing is demonstrated. In this method there are only one object beam and one sampling beam. The response time of the photorefractive crystal must be much longer than the fluctuation period of the dynamic distorter. Thus the crystal responds only to the time-averaged intensity pattern of a rapidly varying object beam. The images, reconstructed with high fidelity, are picked up through the photorefractive fanning effect.

Time-multiplexed real-time one-way image compensation for high-spatial-frequency aberration correction

A new self-aligning geometry for real-time holographic image reconstruction for one-way imaging through a phase aberrator is demonstrated. The input beams are time multiplexed to isolate the diffracted image from the reference beams after the image beams propagate through the hologram. This geometry permits the image-bearing beam and the reference beams to copropagate through the holographic plane.

Real-time holographic image correction using bacteriorhodopsin

We present experimental results of one-way coherent imaging through a thin phase-aberrating medium using a holographic technique with bacteriorhodopsin as a real-time holographic material. Bacteriorhodopsin is well suited for the application when the aberration is time varying because of its real-time writing and erasing characteristics, sensitivity, and spatial resolution. We show results with final image resolution of greater than 20 line pairs/mm and high signal-to-noise ratio using a polarizationholcgraphy approach.

One-way imaging through an aberrator with spatially incoherent light by using an optically addressed spatial light modulator

A real-time holographic technique employing an optically addressed spatial light modulator was used to correct an incoherently illuminated image that had made a single pass through an aberrator. Aberrations that change slowly compared with the integration time of the spatial light modulator are fully corrected.