High photorefractive sensitivity in an n-type 45 degrees-cut BaTiO(3) crystal

Recording and erasure of photorefractive holograms in undoped BTO crystal at moderate to high intensities of 639.7 nm laser under action of 532 nm laser pre-illumination

We investigate recording and erasure of photorefractive holographic gratings in an undoped Bi₁₂TiO₂₀ crystal in a moderate to high intensity regime of the recording beams at 639.7 nm without and with the action of laser pre-illumination at 532 nm. The detected hologram without pre-illumination indicates the participation of two photorefractive electronic gratings in its recording process, and the diffracted signal by itself exhibits a fivefold enhancement when the total intensity increases from 38.4 to 214.5  mW/cm². The dependence of the measured total diffraction efficiency on intensity was investigated and showed linear behavior. At least three gratings are present in the regime of pre-illumination and participate in the writing and erasure of holographic mechanisms. Two of them are electronic, and one is hole-based, with a phase difference of Δϕ between them. The theoretical approach used to analyze the total diffraction efficiency based upon the photorefractivity standard model, and considering the presence of the three gratings, showed good agreement with the holographic erasure experimental data and permitted us to compute Δϕ, which exhibited strong and unusual dependence on the total intensity.

Inverse focusing inside turbid media by creating an opposite virtual objective

Limited by the penetration depth, imaging of thick bio-tissues can be achieved only by epi-detection geometry. Applications based on forward-emitted signals or bidirectional illumination are restricted by lack of an opposite objective. A method for creating an opposite virtual objective inside thick media through phase conjugation was first proposed. Under forward illumination, the backward scattering light from the media was collected to generate a phase conjugate wave, which was sent back to the media and formed an inverse focusing light. Samples combined with a diffuser or a mouse skin were used as specimens. Inverse focusing was successfully demonstrated by applying holography-based optical phase conjugation with a BaTiO3. This result indicates the capability to create an opposite virtual objective inside live tissues. The proposed method is compatible with current coherent imaging and super-resolution imaging technologies. It creates a possible way for forward-emitted signals collection and bidirectional illumination in thick specimens.

Optical BEAMTAP beam-forming and jammer-nulling system for broadband phased-array antennas

We present an approach to receive-mode broadband beam forming and jammer nulling for large adaptive antenna arrays as well as its efficient and compact optical implementation. This broadband efficient adaptive method for true-time-delay array processing (BEAMTAP) algorithm decreases the number of tapped delay lines required for processing an N-element phased-array antenna from N to only 2, producing an enormous savings in delay-line hardware (especially for large broadband arrays) while still providing the full NM degrees of freedom of a conventional N-element time-delay-and-sum beam former that requires N tapped delay lines with M taps each. This allows the system to adapt fully and optimally to an arbitrarily complex spatiotemporal signal environment that can contain broadband signals of interest, as well as interference sources and narrow-band and broadband jammers--all of which can arrive from arbitrary angles onto an arbitrarily shaped array--thus enabling a variety of applications in radar, sonar, and communication. This algorithm is an excellent match with the capabilities of radio frequency (rf) photonic systems, as it uses a coherent optically modulated fiber-optic feed network, gratings in a photorefractive crystal as adaptive weights, a traveling-wave detector for generating time delay, and an acousto-optic device to control weight adaptation. Because the number of available adaptive coefficients in a photorefractive crystal is as large as 10(9), these photonic systems can adaptively control arbitrarily large one- or two-dimensional antenna arrays that are well beyond the capabilities of conventional rf and real-time digital signal processing techniques or alternative photonic techniques.

Photorefractive Incoherent-to-Coherent Optical Converter Based on Anisotropic Self-Diffraction in BaTiO(3)

A photorefractive incoherent-to-coherent optical converter (PICOC) is demonstrated; conversion is accomplished by anisotropic self-diffraction in BaTiO(3). The setup of the PICOC is easy, and only two writing beams are required. The diffraction efficiency reaches 50%, and the resolution is 22 line pairs (lp)/mm in a typical-size crystal. Further, the resolution reaches 40 lp/mm when a BaTiO(3):Rh crystal of thickness 1.2 mm is used, and the diffraction efficiency is as high as 51%. The resolution of the PICOC can be increased effectively by reduction of the crystal thickness with no penalty for low diffraction efficiency.

Superior real-time holographic storage properties in doped potassium sodium strontium barium niobate crystal

We demonstrate superior holographic storage performance in a cobalt doped potassium sodium strontium barium niobate (Co:KNSBN) crystal that possesses a fast response time of 1.4 ms, a large photorefractive sensitivity of 13 x 10(-3) cm(3) J(-1) under a total writing intensity of 1 W/cm(2) , and high spatial resolution of 45 line pairs/mm. Reconstructed images with high fidelity have been obtained in real-time holographic storage. The dynamic properties of the index grating, the dependence of response time on writing intensity, and the dark decay of diffraction signal with increased writing intensity indicate that two species and shallow traps exist in Co:KNSBN crystal.

Volume gratings for holographic storage applications written in high-quality germanosilicate glass

Volume holographic gratings are written with ultraviolet light in high-optical-quality, commercially available Ge-doped silica films and in Ge-doped optical-fiber preform sections loaded with molecular hydrogen. In the film samples, peak refractive-index changes exceeding 10(-2) and a sensitivity (index change/absorbed energy density) of 0.4 × 10(-7) cm(3)/J are measured. Angular multiplexing of up to 51 gratings is demonstrated in the preform samples.

Spectroscopic and photorefractive properties of infrared-sensitive rhodium-doped barium titanate

We have grown and characterized crystals of BaTiO(3) doped with Rh. These crystals have a blue-green color that is probably due to charge-transfer optical transitions involving Rh(4+) and/or Rh(3+). Electron paramagnetic resonance spectroscopy confirmed the presence of Rh(4+) centers. Self-pumped phase-conjugation measurements were performed at wavelengths between 776 and 990 nm. Reflectivities near 80% were obtained throughout this wavelength range. In addition, self-pumped phase-conjugation buildup times were measured as a function of input power at 851 nm and are significantly faster than in undoped or Co-doped crystals studied previously. BaTiO(3):Rh is therefore a promising material for near-infrared photorefractive applications.

Recording of multiple holograms in photopolymer films

Multiple images were recorded in DuPont HRF-150 photopolymer as transmission holograms by using angle multiplexing. Agreement with Kogelnik's two-wave diffraction theory for phase gratings, the time considerations and its effect on dynamic range, the necessity of a pre-illumination pulse, and good image quality at readout are reported.