Surface second-harmonic generation in Si(111) for autocorrelation measurements of 248-nm femtosecond pulses

Application of the nonlinear crystal SrB4O7 for ultrafast diagnostics converting to wavelengths as short as 125 nm

We used non-phase-matched second-harmonic generation (SHG) in the highly nonlinear but low-birefringence crystal SrB4O7 for temporal characterization (autocorrelation) of femtosecond UV pulses to convert these pulses to wavelengths as low as 125 nm, close to the transparency limit of SrB4O7. The sensitivity of this method was approximately 1 microJ at the fundamental for a repetition rate of 1 kHz. We also used SHG at longer wavelengths to estimate the three nonlinear coefficients of SrB4O7.

Femtosecond ultraviolet autocorrelation measurements based on two-photon conductivity in fused silica

We utilize the two-photon conductivity of a fused-silica substrate to produce a photoconductive switch for use in an intensity autocorrelator for ultraviolet ultrashort pulses. We perform measurements at 267 nm with pulse durations in the range of 110-330 fs and with energies as weak as 10 nJ. Based on the bandgap of fused silica, this device can potentially operate in the wavelength range of 140-280 nm.

Measurement of 160-fs, 248-nm pulses by two-photon fluorescence in fused-silica crystals

Measurements of 160-fs, 248-nm ultrashort pulses are obtained through a two-photon fluorescence measurement based on the two-photon-induced color-center fluorescence in fused-silica crystals. The method proved to be reliable and advantageous in comparison with two-photon fluorescence techniques employing other materials, both solid state and gaseous.