Vanadium-dioxide microstructures with designable temperature-dependent thermal emission

Electrostatic steering of thermal emission with active metasurface control of delocalized modes

We theoretically describe and experimentally demonstrate a graphene-integrated metasurface structure that enables electrically-tunable directional control of thermal emission. This device consists of a dielectric spacer that acts as a Fabry-Perot resonator supporting long-range delocalized modes bounded on one side by an electrostatically tunable metal-graphene metasurface. By varying the Fermi level of the graphene, the accumulated phase of the Fabry-Perot mode is shifted, which changes the direction of absorption and emission at a fixed frequency. We directly measure the frequency- and angle-dependent emissivity of the thermal emission from a fabricated device heated to 250 °C. Our results show that electrostatic control allows the thermal emission at 6.61 μm to be continuously steered over 16°, with a peak emissivity maintained above 0.9. We analyze the dynamic behavior of the thermal emission steerer theoretically using a Fano interference model, and use the model to design optimized thermal steerer structures.

Dynamically switchable self-focused thermal emission

The ability to manipulate thermal emission is paramount to the advancement of a wide variety of fields such as thermal management, sensing and thermophotovoltaics. In this work, we propose a microphotonic lens for achieving temperature-switchable self-focused thermal emission. By utilizing the coupling between isotropic localized resonators and the phase change properties of VO₂, we design a lens that selectively emits focused radiation at a wavelength of 4 µm when operated above the phase transition temperature of VO₂. Through direct calculation of thermal emission, we show that our lens produces a clear focal spot at the designed focal length above the phase transition of VO₂ while emitting a maximum relative focal plane intensity that is 330 times lower below it. Such microphotonic devices capable of producing temperature-dependent focused thermal emission could benefit several applications such as thermal management and thermophotovoltaics while paving the way for next-generation contact-free sensing and on-chip infrared communication.

Infrared radiative switching with thermally and electrically tunable transition metal oxides-based plasmonic grating

Plasmonic and phase transition has been blended to gain the infrared radiative switching which is tunable with temperature or voltage supply. This is applied via vanadium dioxide, tungsten trioxide, and molybdenum trioxide as transition metal oxides (TMO). The metallic phase at high temperature or colored state contributes in magnetic polariton (MP) excitation, producing broad absorptance. The TMO-based sub-layer is integrated underneath the grating fully supporting MP resonance. In contrast, this underlayer leads to producing the narrowband absorptance originated from concept of zero contrast grating (ZCG). The zero gradient in refractive index at the output plane of the grating cause transmission of light in broad wavelength range. With introduction of reflective silver underlayer, those transmitted through the grating are reflected back. However, there exists the near-zero narrowband transmission peaks in ZCG. This undergoes transformation to narrowband absorptance. In addition, another absorptance peak can be induced due to phonon modes at insulating phase. The MP resonance at metallic phase is characterized with inductor-capacitor (LC) circuit and the narrowband absorptance peaks are characterized with phase shift from the Fabry-Perot round trip (FP-RT) eigenequation from high contrast grating (HCG). The work expands the usage of transition metal oxides in infrared region with larger contrast.