High-average-power femtosecond laser at 258 nm

Coherent beam combining of femtosecond third-harmonic generators: towards high-power, high-beam-quality UV light generation

Coherent beam combining (CBC) of two femtosecond third-harmonic (TH) generators is proposed and demonstrated. By applying phase modulation to one of the fundamental laser pulses, the feedback loop effectively eliminates both phase and pointing errors between the two TH femtosecond laser beams. The system delivers 345-nm femtosecond laser pulses with 22-W average power at 1-MHz repetition rate. The average combining efficiency is 91.5% over approximately 1 h of testing. The beam quality of the combined ultraviolet (UV) laser beam is near-diffraction-limited with M2 factors of M X2=1.36, M Y2=1.24, which are similar to those of the individual channels. This scheme exhibits promising potential for increasing high-beam-quality UV laser power.

High-power deep-ultraviolet light generation at 266 nm from frequency quadrupling of a picosecond pulsed 1064 nm laser with a Nd:YVO4 amplifier pumped by a 914 nm laser diode

We report the generation of picosecond pulsed light at a 266 nm wavelength with an average power of 53 W. We developed a picosecond pulsed 1064 nm laser source with an average power of 261 W, a repetition rate of 1 MHz, and a pulse duration of 14 ps, using a gain-switched DFB laser diode as a seed laser and a 914 nm laser-diode-pumped Nd-doped YVO₄ power amplifier. We achieved stable generation of 266 nm light with an average power of 53 W from frequency quadrupling using an LBO and a CLBO crystals. The amplified power of 261 W and the 266 nm average power of 53 W from the 914 nm pumped Nd:YVO₄ amplifier are the highest ever reported, to the best of our knowledge.

High-peak-power picosecond deep-UV laser sources

Ultrafast deep-UV laser sources have extensive applications across a wide number of fields, whether biomedicine, photolithography, industrial processing, or state-of-the-art scientific research. However, it has been challenging to obtain deep-UV laser sources with high conversion efficiency and output peak power. Here, we simultaneously demonstrated high-peak-power picosecond deep-UV laser sources at two typical wavebands of 263.2 and 210.5 nm via the efficient fourth- and fifth-harmonic generation. The highest peak power of 263.2 and 210.5 nm laser radiations were up to 2.13 GW (6.72 ps) and 1.38 GW (5.08 ps). The overall conversion efficiencies from the fundamental wave to the fourth and fifth harmonic were up to 42.9% and 28.8%, respectively. The demonstrated results represent the highest conversion efficiencies and output peak powers of picosecond deep-UV laser sources at present to our knowledge. Additionally, we also systematically characterized the deep-UV optical properties of typical birefringent and nonlinear borate crystals, including α-BaB₂O₄, β-BaB₂O₄, LiB₃O₅, and CsLiB₆O₁₀ crystals. The experiments and obtained numerous new optical data in this work will contribute to the generation of ultrahigh-peak-power deep-UV and vacuum-UV laser sources and crucial applications in both science and industry, such as high-energy-density physics, material science, and laser machining.

High power picosecond green and deep ultraviolet generations with an all-fiberized MOPA

We demonstrate high power picosecond green and deep ultraviolet (DUV) lasers based on an all-fiberized master oscillator power amplifier (MOPA). The main power amplifier is fabricated with a highly Yb-doped large mode area (LMA) silicate glass fiber. It delivers 75.2-W laser output at 1029 nm with a pulse repetition rate of 10 MHz and a pulse duration of 70 ps. With a lithium triborate (LBO) crystal, a 43.0-W green output at 514.5 nm has been achieved with a pulse duration of 55 ps. With a caesium lithium borate (CLBO) crystal, a 14.5-W picosecond DUV output at 257 nm has been generated, which is the highest power for the all-fiber based DUV laser, to the best of our knowledge.

Nonlinear absorption in lithium triborate frequency converters for high-power ultrafast lasers

We report on an analysis of the nonlinear absorption in lithium triborate (LBO) used for second and third harmonic generation of ultrashort laser pulses at average powers in the order of kW and with sub-picosecond pulse duration. Thermographic imaging of the LBO crystals together with a simple analytical model revealed the presence of nonlinear absorption in both harmonic generation processes. Subsequent processing with a numerical model considering the nonlinear mixing, the absorption, and the heat conduction was used to estimate the absorption coefficients. Average powers exceeding 100 W in the ultraviolet and 400 W in the visible spectral range were obtained while maintaining a good beam quality by avoiding excessive nonlinear absorption.

Sum-frequency generation of 133 mJ, 270 ps laser pulses at 266 nm in LBO crystals

We demonstrate the generation of high-energy (133 mJ) and sub-nanosecond (∼270 ps) deep ultraviolet (DUV) pulses at 266 nm by sum-frequency mixing in LiB₃O₅ (LBO) crystals. The highest 133 mJ pulse energy ever reported corresponds to a peak power of 0.49 GW and an energy conversion efficiency of 13.3% from the infrared at 1064 nm to DUV at 266 nm. This is the highest output energy ever reported for the DUV sub-nanosecond pulses to the best of our knowledge. Higher energy efficiency of 25.7% can be achieved from 1064 nm to 266 nm when the fundamental energy was reduced to 346 mJ. Furthermore, the DUV generations using LBO and typical β-BaB₂O₄ (BBO) crystals were compared regarding the energy efficiency, and the effects of the nonlinear absorption are discussed.

Multi-GHz repetition rate, femtosecond deep ultraviolet source in burst mode derived from an electro-optic comb

We present a femtosecond, 11.48 GHz intra-burst repetition rate deep UV source at 258 nm based on forth-harmonic generation (FHG) of an electro-optic (EO) comb operating in burst mode. Second-harmonic generation (SHG) of the burst-mode EO comb in LiB₃O₅ (LBO) leads to 3.7 W average power and 242 fs root-mean-square pulse duration. A second stage of SHG is further performed using two separate β-BaB₂O₄ (BBO) crystals, delivering deep UV pulses at 523 mW and 294 mW, with estimated pulse durations of half-ps and sub-300 fs, respectively. At divided pulse repetition rates of 5.7 GHz and 2.9 GHz, FHG is also demonstrated, highlighting the potential of flexible repetition rate operation at the GHz level.

20 W, 2 mJ, sub-ps, 258 nm all-solid-state deep-ultraviolet laser with up to 3 GW peak power

We demonstrate an all-solid-state deep-ultraviolet (DUV) laser based on the frequency-quadrupling of a 1 µm, 1.2 ps, Yb: YAG Innoslab solid-state laser at a 10 kHz repetition rate, using LBO and BBO as second-harmonic generation and fourth-harmonic generation crystals, respectively. The DUV laser delivers 20 W, 2.0 mJ, 665 fs, 258 nm DUV pulses, with an overall conversion efficiency of ∼8.7% from 1 µm to DUV. The corresponding peak power of DUV pulses is up to 3 GW, which, to the best of our knowledge, is highest in reported kHz-rate all-solid-state DUV sources driven at 1 µm wavelength.

New observations on DUV radiation at 257 nm and 206 nm produced by a picosecond diode pumped thin-disk laser

We report new observations on picosecond deep ultraviolet coherent beams generated in a CLBO as the fourth and fifth harmonics of a diode pumped high average power Yb:YAG thin disk laser operating at 77 kHz repetition rate at 1030 nm. The effects of the two-photon absorption were observed, e.g. the modification of phase matching conditions, lowering of the conversion efficiency. The fifth harmonic generation (4ω+1ω) was studied for different time delays between both pump beams and for the case of excess input power of the fundamental. The latter effect suggests a possibility of increasing DUV output at short crystals. The highest output power obtained at 257 nm was 7.6 W and 1 W at 206 nm. To our knowledge these DUV output powers rank among the highest for picosecond pulses at the repetition rate of the order of magnitude of 100 kHz.

Cascaded harmonic generation from a fiber laser: a milliwatt XUV source

Recent progresses in femtosecond ytterbium-doped fiber laser technology are opening new perspectives in strong field physics and attosecond science. High-order harmonic generation from these systems is particularly interesting because it provides high flux beams of ultrashort extreme ultraviolet radiation. A great deal of effort has been devoted to optimize the macroscopic generation parameters. Here we investigate the possibility of enhancing the single-atom response by producing high-order harmonics from the second, third and fourth harmonics of a turnkey 50 W, 166 kHz femtosecond Yb-fiber laser providing 135 fs pulses at 1030 nm. We show that the harmonic efficiency is optimal when the process is driven by the third harmonic, producing 6.6 ± 1.3 × 10¹⁴ photons/s at 18 eV in argon, which corresponds to 1.9 ± 0.4 mW average power.