Static and dynamic mode coupling in a double-pass rod-type fiber amplifier

High-repetition-rate, 50-µJ-level, 1064-nm, CPA laser system based on a single-stage double-pass Yb-doped rod-type fiber amplifier

A 1064-nm femtosecond fiber chirped pulse amplification (FCPA) laser system based on a single-stage double-pass Yb-doped rod-type photonic crystal fiber (PCF) amplifier was demonstrated with a pulse repetition rate of 500 kHz, which was specially designed for expected conversion efficiency enhancement of a 10.8 eV source. With a series of Yb:fiber power amplifiers, the average output power was boosted to approximately 35 W. Further, using a transmission gratings-based pulse compressor, an average output power of 27.5 W was achieved, corresponding to a pulse energy of 55 µJ and a compression efficiency of 78.6%. The shortest pulse duration was optimized to be 204 fs, which was also accompanied by obvious pedestal. A pulse duration of 336 fs was also obtained when the pulse quality was at a top priority. To the best of our knowledge, this is the first demonstration of high-repetition-rate high-pulse-energy 1064-nm, instead of 1035-nm, femtosecond laser, based on commercially available Yb-doped rod-type PCF amplifier.

Double-pass pre-chirp managed amplification with high gain and high average power

We demonstrate, to the best of our knowledge, the first double-pass pre-chirp managed fiber amplifier. The double-pass fiber amplifier exhibits high gain allowing us to amplify chirped picosecond pulses from 20 mW to 113 W in a rod-type Yb-fiber corresponding to 38 dB gain. We study the dependence of static mode degradation (SMD) on the nonlinear phase shift (NPS) accumulated by the amplified pulse. Our results indicate that a larger nonlinear phase shift results in stronger nonlinear polarization evolution of the fundamental mode and leads to a lower threshold for SMD. After optimization, our pre-chirp managed amplifier seeded by 80 mW pulses delivers 102 W amplified power from the main output. The amplified pulses are compressed to 37 (55) fs with 90 (100) W average power by a grating pair (chirped mirrors). The double-pass configuration significantly simplifies the implementation of pre-chirp managed fiber amplifiers leading to an extremely compact system.

Experimental study of the influence of mode excitation on mode instability in high power fiber amplifier

Mode instability with different mode excitation has been investigated by off-splicing the fusion point in a 4 kW-level monolithic fiber laser system, which reveals that the fiber systems exciting more high order mode content exhibits lower beam quality but higher mode instability threshold. The static-to-dynamic mode degradation and dynamic-only mode degradation have also been observed in the same high power fiber amplifier by varying the mode excitation, which implicates that the mode excitation plays an important role in mode characteristics in high power fiber lasers. By employing a seed with near fundamental mode beam quality, only dynamic mode degradation-mode instability sets in with negligible static beam quality degradation. Then the fusion point in the seed laser is offset spliced to excite high order mode. As the output power of the main amplifier scales, the beam quality degrades with the beam profile being static, and then the dynamic mode instability sets in, the power threshold of which is higher than that with good beam quality seed. We consider that the static mode degradation is caused by the presence of incoherent supposition of fundamental and high order mode, which leads to that the measured dynamic mode instability threshold is higher.