Nested capillary anti-resonant silica fiber with mid-infrared transmission and low bending sensitivity at 4000 nm

Highly sensitive methane detection using a mid-infrared interband cascade laser and an anti-resonant hollow-core fiber

For over a decade hollow-core fibers have been used in optical gas sensors in the role of gas cells. However, very few examples of actual real-life applications of those sensors have been demonstrated so far. In this paper, we present a highly-sensitive hollow-core fiber based methane sensor. Mid-infrared distributed feedback interband cascade laser operating near 3.27 µm is used to detect gas inside anti-resonant hollow-core fiber. R(3) line near 3057.71 cm^-1 located in ν₃ band of methane is targeted. Compact, lens-free optical setup with an all-silica negative curvature hollow-core fiber as the gas cell is demonstrated. Using wavelength modulation spectroscopy and 7.5-m-long fiber the detection limit as low as 1.54 ppbv (at 20 s) is obtained. The demonstrated system is applied for a week-long continuous monitoring of ambient methane and water vapor in atmospheric air at ground level. Diurnal cycles in methane concentrations are observed, what proves the sensor's usability in environmental monitoring.

CO2-based hollow-core fiber Raman laser with high-pulse energy at 1.95 µm

In this Letter, we present a high-pulse energy (>10µJ) Raman laser at 1946 nm wavelength directly pumped with a 1533 nm custom-made fiber laser. The Raman laser is based on stimulated Raman scattering (SRS) in an 8 m carbon dioxide (CO₂)-filled nested anti-resonant hollow-core fiber. The low-energy phonon emission combined with the inherent SRS process along the low-loss fiber allows the generation of high-pulse energy up to 15.4 µJ at atmospheric CO₂ pressure. The Raman laser exhibits good long-term stability and low relative intensity noise of less than 4%. We also investigate the pressure-dependent overlap of the Raman laser line with the absorption band of CO₂ at the 2 µm spectral range. Our results constitute a novel, to the best of our knowledge, and promising technology towards high-energy 2 µm lasers.

Heterodyne photothermal spectroscopy of methane near 1651 nm inside hollow-core fiber using a bismuth-doped fiber amplifier

We present laser-based methane detection near 1651 nm inside an antiresonant hollow-core fiber (HCF) using photothermal spectroscopy (PTS). A bismuth-doped fiber amplifier capable of delivering up to more than 160 mW at 1651 nm is used to boost the PTS signal amplitude. The design of the system is described, and the impact of various experimental parameters (such as pump source modulation frequency, modulation amplitude, and optical power) on signal amplitude and signal-to-noise ratio is analyzed. Comparison with similar PTS/HCF-based systems is presented. With 1.3 m long HCF and a fiber amplifier for signal enhancement, this technique is capable of detecting methane at single parts-per-million levels, which makes this robust in-fiber sensing approach promising also for industrial applications such as, e.g., natural gas leak detection.

Mid-Infrared Ultra-Short Pulse Generation in a Gas-Filled Hollow-Core Photonic Crystal Fiber Pumped by Two-Color Pulses

We show numerically that ultra-short pulses can be generated in the mid-infrared when a gas filled hollow-core fiber is pumped by a fundamental pulse and its second harmonic. The generation process originates from a cascaded nonlinear phenomenon starting from a spectral broadening of the two pulses followed by an induced phase-matched four wave-mixing lying in the mid-infrared combined with a dispersive wave. By selecting this mid-infrared band with a spectral filter, we demonstrate the generation of ultra-short 60 fs pulses at a 3–4 µm band and a pulse duration of 20 fs can be reached with an additional phase compensator.

Antiresonant fibers with single- and double-ring capillaries for optofluidic applications

In this work we discuss the effect of infiltration of different antiresonant fibers with low-refractive-index liquids, such as water and ethanol, on their optical properties. The fibers with single- and double-ring capillaries have been designed to show broad transmission bands in visible and near infrared range as it is required for optofluidics, in particular spectrophotometric applications. We show experimentally that their transmission windows shift toward shorter wavelengths and only modestly reduce their width. The transmission bands are located in the wavelength ranges of 533-670 nm and 707-925 nm, for the fibers when infiltrated with water. The two types of analyzed antiresonant fibers infiltrated with the liquids show similar light guidance properties when they are straight, but significantly lower bending loss can be achieved for the double-ring than for the single-ring antiresonant fiber. For this reason, the double-ring antiresonant fibers are more suitable as a compact solution for optofluidic applications, although transmission windows are reduced due to broader resonance peaks.

Laser-Based Trace Gas Detection inside Hollow-Core Fibers: A Review

Thanks to the guidance of an optical wave in air, hollow-core fibers may serve as sampling cells in an optical spectroscopic system. This paper reviews applications of hollow-core optical fibers to laser-based gas sensing. Three types of hollow-core fibers are discussed: Hollow capillary waveguides, photonic band-gap fibers, and negative curvature fibers. Their advantages and drawbacks when used for laser-based trace gas detection are analyzed. Various examples of experimental sensing systems demonstrated in the literature over the past 20 years are discussed.

Demonstration of mid-infrared gas sensing using an anti-resonant hollow core fiber and a quantum cascade laser

In this paper we report a mid-infrared sensor based on an anti-resonant hollow core fiber. A quantum cascade laser operating around 4.53 µm is used to target one of the strongest transition of nitrous oxide near 2203.7 cm^-1. The system provides 1-second minimum detection limit at single parts-per-billion level using 3.2-m-long fiber with the response time of less than 30 seconds. Presented sensing approach shows a good perspective for compact and sensitive mid-infrared fiber-based spectrometers.