Extending the L-band amplification to 1623 nm using Er/Yb/P co-doped phosphosilicate fiber

Bandwidth extension to 1627 nm of over 20 dB gain in an erbium-doped silica fiber via two-photon absorption

In this study, PbS/Er co-doped fibers (PEDFs) were fabricated by atomic layer deposition (ALD) combined with modified chemical vapor deposition (MCVD). A pumping scheme based on two-photon absorption at 1310 nm of PEDF is proposed for L + band amplification. Through the theoretical analysis, the local environment of Er3+ is changed due to the co-doping of PbS, which improves the two-photon absorption efficiency near 1300 nm. Compared with the 980 nm pump, the PEDFs excited by the 1310 nm pump show better amplification performance in the L + band. And in a bi-directional pumping system, PEDF achieves over 22 dB of gain in the whole L band. In particular, the bandwidth of over 20 dB gain was extended to 1627 nm with a noise figure as low as 4.9 dB. To the best of our knowledge, this is the first time that a high-gain bandwidth of L band amplification has been extended to 1627 nm. The results of unsaturated loss also show that PbS co-doping improves the two-photon absorption efficiency of PEDF to broaden the amplification bandwidth of L + band. These results demonstrate that an effective L + band amplification method is practically provided for future ultra-wideband optical communications.

Er-doped silicate fiber amplifiers in the L-band with flat gain

We demonstrated an efficient way to enhance and flatten the emission cross sections of Er3+ ions at the L-band in the silicate fiber amplifier by increasing Mg2+ (up to 22.5 mol%) with high field strength. High values of Er3+ concentration, lifetime, and L-band emission cross section were achieved in our silicate fibers. Particularly, the flatness at the L-band was achieved to be 0.8 dB, and a high gain coefficient at 1625 nm (4.7 dB/m) was demonstrated by pumping meter-scale Er-silicate fibers. The as-prepared Er-silicate fibers are attractive for the L-band fiber amplifier.

Expanding gain bandwidth using ion-hybridized fiber for kHz-linewidth single-frequency fiber lasers at S-, C-, and L-bands: design and performance evaluation

Single-frequency fiber lasers at S-, C-, and L-bands play a crucial role in various applications such as optical network expansion, high-precision metrology, coherent lidar, and atomic physics. However, compared to the C-band, the S- and L-bands have wavelength deviations and suffer from excited-state absorption, which limits the output performance. To address this issue, a strategy called ion hybridization has been proposed to increase the differences in site locations of rare earth (RE) ions in the laser matrix, thereby achieving a broader gain bandwidth. This strategy has been applied to an Er3+/Yb3+ co-doped modified phosphate fiber (EYMPF), resulting in gain coefficients per unit length greater than 2 dB/cm at S-, C-, and L-bands. To demonstrate its capabilities, several centimeter-long EYMPFs have been used to generate single-frequency laser outputs at S-, C- and L-bands with kHz-linewidths, high signal-to-noise ratios (>70 dB), and low relative intensity noise (<-130 dB/Hz) in a compact short linear-cavity configuration.

High bismuth-doped germanosilicate fiber for efficient E + S-band amplification

Bismuth-doped germanosilicate fiber (BGSF), the active media of fiber amplifiers, has attracted widespread attention. Here, we report a BGSF with a high bismuth concentration of 0.075 wt. % and achieve high-efficiency E + S-band amplification, which was prepared by the modified chemical vapor deposition (MCVD) process. The small signal absorption (SSA) and unsaturated loss (UL) of BGSF at 1310 nm are 1.32 and 0.11 dB/m, respectively. The results show a record with only 45 m BGSF was created, to the best of our knowledge, which provides a maximum gain of 39.24 dB with an NF of 6.2 dB at 1430 nm under -20 dBm input signal power.

High-efficiency cladding-pumped Er/Yb co-doped alumino-phosphosilicate fiber for an extended L-band amplification

Extending the gain bandwidth of L-band optical fiber amplifier has provoked a widespread interest. To date, achieving a high-efficiency extended L-band amplification remains a challenge. Here, we report a cladding-pumped Er/Yb co-doped alumino-phosphosilicate fiber, prepared by the modified chemical vapor deposition process. We demonstrate the efficiency of alumino-phosphosilicate glass for cladding-pumped Er/Yb co-doped fiber, with a gain per unit fiber length of 0.45 dB/m at 1625 nm and a gain ripple of ∼9.4 dB. For 0.8 W pump power, the fiber exhibits a 20 dB gain bandwidth covering 1575-1625 nm and 6.9 dB noise figure at 1625 nm. Additionally, the utilization of multi-mode laser diode enables further significant power savings and cost reduction. To the best of our knowledge, Er/Yb co-doped fiber in alumino-phosphosilicate glass is first proposed, with a cladding-pumped scheme for enhancing an extended L-band performance.

Extended L-band 4-Core Er/Yb co-doped fiber amplifier based on 1018 nm cladding pumping

The extended L-band 4-core Er/Yb co-doped fiber and amplifier (MC-EYDFA) is first proposed and demonstrated, to the best of our knowledge, for space division multiplexing combined with wavelength division multiplexing application. The fiber core co-doped with Er/Yb/P is adopted for bandwidth expansion, and the long wavelength extends to 1625 nm. Numerical simulations further show that efficient amplification and higher saturation power are achieved with the 1018 nm cladding pumping. Based on the integrated 4-core fiber amplifier, an average gain of ∼22 dB covering 1575-1625 nm is experimentally obtained with a 4 W pump power and a 3 dBm total signal power, and the max core-dependent gain (CDG) variation is measured to be 1.7 dB.

Extending laser wavelengths to 1630 nm in centimeter-scale Er-phosphate fiber

The spectral bandwidth of Er-doped fibers limits their lasing wavelength at longer wave band. Here, to the best of our knowledge, we report a broad emission band (1420‒1680 nm) of Er³⁺ and demonstrate for the first time an Er-phosphate fiber, which supports laser oscillation at the extended wavelengths of 1627 nm and 1630 nm, with the output powers and slope efficiencies of 44 mW/12.5% and 16.5 mW/5.6%, respectively, pumped at 1480 nm. To the best of our knowledge, these are the highest output powers and slope efficiencies at 1627 nm and 1630 nm from an Er³⁺-doped all-fiber configuration.

Improved Fluorescence and Gain Characteristics of Er-Doped Optical Fiber with PbS Nanomaterials Co-Doping

Er-doped optical fiber (EDF) with ultra-broad gain bandwidth is urgently needed given the rapid advancement of optical communication. However, the weak crystal field of the host silica glass severely restricts the bandwidth of traditional EDF at 1.5 μm. In this study, we theoretically explored the introduction of PbS nanomaterials in the silica network assisted with the non-bridging oxygen. This can significantly increase the crystal field strength of Er³⁺ ions in the local structure, leading to their energy level splitting and expanding the fluorescence bandwidth. Additionally, the PbS/Er co-doped optical fiber (PEDF) with improved fluorescence and gain characteristics was fabricated using modified chemical vapor deposition combined with the atomic layer deposition technique. The presence of PbS nanomaterials in the fiber core region, which had an average size of 4 nm, causes the ⁴I_13/2 energy level of Er³⁺ ions to divide, increasing the fluorescence bandwidth from 32 to 39 nm. Notably, the gain bandwidth of PEDF greater than 20 dB increased by approximately 12 nm compared to that of EDF. The obtained PEDF would play an important role in the optical fiber amplifier and laser applications.

Extended L-band few-mode Er/Yb Co-doped fiber amplifier with a cladding-pumped pseudo-two-stage configuration

Spatial division multiplexing (SDM) is one of the most important technologies that may help to solve the future capacity crisis. However, to date, SDM optical amplification is still a challenge for its application. Herein, we numerically and experimentally demonstrated a few-mode Er/Yb co-doped fiber amplifier (FM-EYDFA) for extended L-band operation. A double cladding Er/Yb co-doped fiber was fabricated to expand the L-band bandwidth and a novel, to the best of our knowledge, cladding-pumped pseudo-two-stage amplification configuration was proposed to enhance the L-band gain. With an initial signal power of -16.8 dBm and an injected pump power of 8.8 W at 940 nm, the 20-dB gain range was covered to 1620 nm for two-mode groups of LP₀₁ and LP₁₁. Importantly, the average gain of 25 dB and average differential modal gain (DMG) of <1 dB were obtained in the wavelength range of 1570-1620 nm for all modes. Our results suggest that the cladding-pumped pseudo-two-stage amplifier based on Er/Yb co-doped fiber providing low DMG, and broad bandwidth has a great potential for increasing the future SDM capacity.