On-chip silicon switchable polarization beam splitter

High-performance TM-pass polarizer based on anti-symmetric Bragg gratings

We present an all-silicon transverse-magnetic-pass (TM-pass) polarizer based on anti-symmetric Bragg gratings. We obtain wide operation bandwidth and high polarization extinction ratio (PER) by maximizing the coupling between the forward TE0 mode and the backward TE1 mode through the reduction of the bridge element width. In the meantime, low insertion loss (IL) is acquired with long tapered structures and the exclusion of the center grating part. Experimental results indicate IL below 0.74 dB and PER over 40 dB covering the wavelength ranges of 1275-1360 nm and 1500-1523 nm, while the average IL within these ranges is as low as 0.27 dB. Additionally, simulation results suggest that the performance can be further improved by introducing chirp in the period of Bragg gratings, thus achieving IL < 0.11 dB and PER > 60 dB over a wide range of 280 nm (1290-1570 nm).

Mode thermo-optic coefficient engineering of sub-wavelength gratings and its application for a mode-insensitive switch

It is shown that the thermo-optic (TO) coefficients of various waveguide modes of a sub-wavelength grating (SWG)-assisted strip waveguide is closely dependent on the various waveguide parameters with different dependencies, including the SWG width, strip waveguide width, duty cycle, and pitch. This offers what we believe to be new degrees of freedom in the design of TO coefficients for integrated-optic waveguides, opening the door to engineering the TO coefficients of individual spatial modes or polarization states using sub-wavelength structures. Such a capability is expected to offer new design possibilities for a variety of integrated photonic, thermo-optic devices. To demonstrate the application of the concept, a mode-insensitive switch on silicon-on-insulator using a TO coefficient-engineered SWG as a mode-independent, thermo-optic phase shifter is designed and experimentally demonstrated. The experimental results show that the switching powers of the TE0-TE2 modes are only ∼29 mW, and the maximum extinction ratios for the cross (bar) states are 38.2 dB (31 dB), 37.9 dB (37 dB), and 31.9 dB (20.5 dB) for the TE0-TE2 modes, respectively, at the wavelength of 1550 nm.

Compact reconfigurable on-chip polarization beam splitters enabled by phase change material

In this paper, we present the design of a compact reconfigurable polarization beam splitter (PBS) enabled by ultralow-loss phase-changing Sb2Se3. By harnessing the phase-change-mediated mode coupling in a directional coupler (DC), guided light with different polarizations could be routed into different paths and this routing could be dynamically switched upon the phase change of Sb2Se3. With an optimized DC region, the proposed PBS demonstrates efficient polarization splitting with crosstalk less than -21.3 dB and insertion loss less than 0.16 dB at 1550 nm for both phase states of Sb2Se3, and features energy efficient property benefitting from the nonvolatile phase change of Sb2Se3, which holds great potentials for on-chip applications involving polarization control, including polarization-division multiplexing system, quantum photonics, microwave photonics, etc.

Electrically controlled dual-mode polarization beam splitter using a nematic liquid crystal

Polarization handling using an external source is highly desirable in applied optics and photonics to increase the degree of freedom of an optical system. Here we report an electrically controlled polarization beam splitter (PBS) by sandwiching the nematic liquid crystal (LC) between two equilateral prisms. The presented LC-PBS is operated in two different modes: non-splitting mode and polarization splitting mode. The externally applied voltage can switch the mode of the PBS, which makes the device active and flexible. The proposed electrically controlled PBS exhibits features such as bistability with highly stable modes, large splitting angle, wider operating range, and ease of fabrication with lower cost.